You are here: Forums SUVs Ford Bronco Ford Bronco Problems

Ford Bronco Problems

231 messages,  Last post on Nov 21, 2009 at 2:24 AM

You are in the Ford Bronco Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Bronco

Messages Page 19 of 24 1 ... 16 17 18 19 20 21 22 ... 24 Prev Next Last

Go To Msg # Search This Discussion

#180 of 231 by chris779 Sep 20, 2008 (2:52 pm)
im a 17 yr old kid, getting ready to start working on my dads 84' bronco 2, i have to put a new transmission in it, but ive never done it before, and all the sites i read instructions on, i cant seem to follow, can anyone help me with instructions?
#181 of 231 95 Bronco 351 automatic with AOD problems. by hahs Sep 24, 2008 (4:47 pm)
Im not to savy on working on trucks but i was looking for some info if someone could help please? Sometimes while im driving my AOD will come on by itself. I try and turn it off by pressing the button on the handel but it wont turn off. So when i give it gas it reacts very slow and then i will get a pretty forcefull jerk whrn it finally shifts. It does not do this all the time or every day. Just sometimes. The only way i can get the AOD to turn off is to pull over and turn the truck off. Sometimes it will start turning on by itself again and sometimes everything runs smoothly for a few days. I need to figure out what is wrong before i end up doing any damage that will cost me more money then this fix. Thanx in advance for any help.
#182 of 231 stalling when going into reverse by cwtcr Oct 15, 2008 (7:00 am)
I have a 96 bronco, 351W with auto tranny w O/D, the transmission when the motor is warm is stalling when i shift into reverse, once it stalls i can restart it and shift into reverse and it will not stall but the rpm's fluctuate quite a bit from very low to normal. When the engine is cold and rpms are up it operates as normal. It also has stalled on me when i come to a quick stop at a traffic light or something, rpm's just slowly die. But if i brake regularly it is fine, Also it is running fine in any forward gear and no hesitation at any speed. any ideas, thanks Replies to this message: bronco96kid (Nov 16, 2008 4:20 pm)
#183 of 231 Re: '93 full size trans "shudder"/vibration problem [buknbronco] by flattop4x4 Oct 29, 2008 (5:59 pm)
Replying to: buknbronco (May 14, 2008 4:15 pm) You might be on the right track, but the u-joints aren't the only thing "IN THE DRIVETRAIN" that will cause that type of vibration. The yoke that ties the trans output shaft to the driveshaft/u-joints has a plastic coating on the splines of the yoke itself. Find a driveshaft rebuild shop and have them get ya a NEW yoke. You wouldn't believe how much difference it makes having that teflon coating, filling in the slack, and dampening road noise!!
#184 of 231 Re: Starting problem [dnolen] by flattop4x4 Oct 29, 2008 (6:06 pm)
Replying to: dnolen (Mar 10, 2008 11:29 am) Well I haven't read down through any other possible replies, but I'll offer this question to you. Have you "EVER" replaced the fuel filter?
#185 of 231 Re: stalling when going into reverse [cwtcr] by bronco96kid Nov 16, 2008 (4:20 pm)
Replying to: cwtcr (Oct 15, 2008 7:00 am) I am having the same exact problem, same symptoms and everything. I took it to a shop and the guy ran the codes and said it was an internal tranny problem. I also have a 96 bronco, 351 with auto tranny w O/D. Has anyone figured this problem out yet?
#186 of 231 Re: Front End 93 eddie bauer 5.8 [devinque] by 82ncmarine Nov 26, 2008 (11:02 am)
Replying to: devinque (Sep 01, 2006 8:19 pm) well the most common cause is the "camber" bushings will need to be replaced. it is best to take it to a shop that does alignments.
#187 of 231 93 EB bronco 5.0 by bigblockman Dec 18, 2008 (9:23 am)
i have had this bronco for 2 years and did me good. but i was out hunting and when i came out of the woods it started bucking and then died. i can get it to start but i can not get the rpm up. soon as i put it in drive and try to give it some gas it dies. i was told it is the timing cuz when trying to get the rpm up it will backfire under the hood. but had someone check it and it is fine and ides smooth. i think it might be my gas presher how can i test it. HELP LOL Replies to this message: redraider28 (Dec 18, 2008 7:50 pm) khawley (Mar 04, 2009 4:28 pm) jutmac (Mar 04, 2009 4:52 pm) and 1 more...
#188 of 231 Re: 93 EB bronco 5.0 [bigblockman] by redraider28 Dec 18, 2008 (7:50 pm)
Replying to: bigblockman (Dec 18, 2008 9:23 am) This is just a suggestion, because I have a 94 EB with the 5.8L. There's a fuel rail along the intake that supplies the fuel injectors (not sure about the 5.0). There's what looks like a tire air stem. With the car ignition turned on, but not running, so the fuel pump turns on, you can push down the stem and fuel should come out. Make sure the engine is COOL. If no fuel, start by changing your fuel filter then your fuel pump. If the fuel is not your problem, check your plugs, plug wires, coil, and distributor. If you've cracked one or more of your spark plugs with the off roading, it will cause the bucking when you rev the engine.   Hope this helps. Replies to this message: khawley (Mar 04, 2009 4:28 pm) jutmac (Mar 04, 2009 4:52 pm) redraider28 (Mar 04, 2009 7:42 pm)
#189 of 231 93 Bronco--Ignition Problem by afindly Jan 01, 2009 (9:24 pm)
My 93 Ford Bronco(351/EFI) quit running suddenly while idling .... have replaced the fuel filter. The Fuel Pump "Sounds" normal when turning on key to start, but have not checked further. When trying to start, engine turns over but does not fire. Checked the distributor .... cap and rotor seem functioning ok. Sprayed starting fluid (Deep Creep by makers of Sea Foam) into air inlet ... would not fire. Do you have a check-list of what to try next?? Is there an electronic module at the distributor that could fail & cause this behavior? Replies to this message: redraider28 (Jan 03, 2009 9:04 pm)

Messages Page 19 of 24 1 ... 16 17 18 19 20 21 22 ... 24 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Ford Bronco Ford Bronco Problems