You are here: Forums SUVs Ford Bronco Ford Bronco Problems

Ford Bronco Problems

231 messages,  Last post on Nov 21, 2009 at 2:24 AM

You are in the Ford Bronco Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Bronco

Messages Page 17 of 24 1 ... 14 15 16 17 18 19 20 ... 24 Prev Next Last

Go To Msg # Search This Discussion

#158 of 231 95 ford bronco problem by nhernon Mar 09, 2008 (3:41 pm)
I have a 95 ford bronco 5.8 L and the problem is i put it into low range and ever since then when i shift into reverse theres a big clunk and sometimes when i shift into drive theirs a big clunk also while im driving it will shift funny or sometimes wont even shift and i have to let off the gas would anybody maybe know the problem and if so maybe a solution to the problem? thanx Replies to this message: dameen6 (Mar 10, 2008 10:12 am) bernie11 (Mar 24, 2008 7:43 am)
#159 of 231 Re: 95 ford bronco problem [nhernon] by dameen6 Mar 10, 2008 (10:12 am)
Replying to: nhernon (Mar 09, 2008 3:41 pm) how are you PHERNON,well i have a 88 bronco 11, i had similar problems with mine,here's a couple of things you might want to check, driveshaft,universal joints,gears in the rear end, I don't know if you have automatic locking hubs check em also,check yur radius arm on both sides check the insulator and washer they usually are wore out and is rubbing on the crossmember that is some of the things that were done to mine. I HOPE IT HELPS YOU, good luck and let me know if any of them were bad, hopefully it isn't yur tranny, thats were i am stuck for now.
#160 of 231 Starting problem by dnolen Mar 10, 2008 (11:29 am)
I have a '92 V8 5.0L Ford Bronco and I have a problem with the engine in the morning. The fuel pump needs to run for about 15 minutes before it has built up enough pressure to start. The mechanics think it might be either the connection on the fuel pump. They're going to connect all three tubes seperately instead of together with one clasp. If that doesn't help all they can do is replace the on board computer. My faith in mechanics is a little gone since I've spent more on repairs than on the initial amount I paid for the car.   Has anyone had the same problem or does anyone have any suggestions on where the problem might really lie?     Any help is appreciated.   Thank you! Danielle Replies to this message: flattop4x4 (Oct 29, 2008 6:06 pm)
#161 of 231 Re: 95 ford bronco problem [nhernon] by bernie11 Mar 24, 2008 (7:43 am)
Replying to: nhernon (Mar 09, 2008 3:41 pm) I had this problem before and all it was is a sensor in the engine. It only cost 85 dollars to replace. After that you won't get that jerking anymore. I thought it was the trans but it was only a sensor.
#162 of 231 maybe fuel system problems????? by cohide Mar 25, 2008 (3:45 pm)
I have an 87 bronco that quit me today, it started twice but died each time after about 2 minutes or so, I'm thinking fuel filter but not real familiar with the fuel system yet, please help, my other truck is a diesel and diesel fuel prices are going through the roof, I have to get my "ol bronc" back on the road
#164 of 231 '93 full size trans "shudder"/vibration problem by droplever1 Apr 13, 2008 (12:27 pm)
I have a '93 full size Bronco 351 motor Dana(?) drive train w/140k problem started with a "thump" when shifting into reverse, hard ("jerky") shifting, then a vibration/"shudder"(like I'm riding over small rumble strips) when accelerating at 40-55mph. First time to shop they reccomended a service (fluid,filters,etc.) and a product called "shudderstop" for the torque converter. The "thump" went away and it was better for about a month then the shudder started again. Second trip to shop they tried a "shift-pak"(?) and solenoid(s). The thump and hard shifting are gone but I still have a vibration/"shudder" between 40 and 55mph when I accelerate. Any suggestions before I research replacing??? I hope to keep my Bronco indefinitely so I'm not opposed to replacement, but if it's not necessary I'de like to keep my money. Thanks Replies to this message: buknbronco (May 14, 2008 4:15 pm) droplever1 (May 23, 2008 6:24 am) flattop4x4 (Oct 29, 2008 5:59 pm)
#165 of 231 Re: '93 full size trans "shudder"/vibration problem [droplever1] by buknbronco May 14, 2008 (4:15 pm)
Replying to: droplever1 (Apr 13, 2008 12:27 pm) I would recommend checking your drive shaft as well as your tranz. You may need new universal joints. If at 40-55 mph you start to fell like it wont go any faster then i recommend doing as i suggested, if it stops as you accelerate past this operating speed i would recommend having the front end checked. good luck! Replies to this message: droplever1 (May 23, 2008 6:24 am) flattop4x4 (Oct 29, 2008 5:59 pm)
#166 of 231 92 FORD BRONCO REAR DOOR REPLACEMENT by s2603 May 18, 2008 (3:52 pm)
Will a 1986 ford Bronco rear door fit a 1992 bronco? My stepson's bronco got hit by a school bus and the only door he can find is a 1986. If the 1986 will not work what years will fit. Thanks Replies to this message: droplever1 (May 23, 2008 6:27 am)
#167 of 231 Re: '93 full size trans "shudder"/vibration problem [buknbronco] by droplever1 May 23, 2008 (6:24 am)
Replying to: buknbronco (May 14, 2008 4:15 pm) thanks for the reply! i have checked the drive shaft and there does not appear to be any "slop." the "vibration" has now migrated to other points on the speedo and happens when accelerating. if i turn the "overdrive" off it happens less frequently but continues. i am also considering replacing the front shock towers. it looks scary though. any tips?

Messages Page 17 of 24 1 ... 14 15 16 17 18 19 20 ... 24 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Ford Bronco Ford Bronco Problems