You are here:
Forums
Sedans
Honda Accord
Honda Accord (2003-2007) Maintenance and Repair

4866 messages, Last post on Nov 10, 2009 at 5:58 PM
You are in the Honda Accord Forum. Your Hosts are pat & karens
|
Replying to: arbys (Jun 08, 2009 9:46 am) I haven't had to adjust them on my 06 but every car I've had allows you to do this. Sometimes you have to stick a pin or something similar in the nozzle to move it slightly. Other times you can reach the nozzle to adjust it from the outside. |
|
|
Replying to: arbys (Jun 08, 2009 9:46 am) |
|
|
|
|
Replying to: mookie14 (Jun 08, 2009 6:40 am) As far as loosing anything on trade in, heck I'd rather buy a used car with a new/newer engine with less miles on it then an engine with higher miles. This is a mechanical repair, It won't change the value of your car. It wasn't in an accident, so there is nothing that will devalue your Accord. Mrbill |
|
|
|
|
Replying to: arbys (Jun 08, 2009 9:46 am) |
|
|
for you manual tranny people.. I have an intermittent squeak in the clutch linkage. Recently started again. Mostly I notice it in 1-2 gear, lower speeds. Kind of like a squeak/squeal noise when releasing the clutch. I don't notice it at higher speeds (or gears). I did have something replaced for this issue when the car was 1-2 years old,(some TSB I found on line), even though they claimed it didn't apply to my car. Now, noise is back. WOnder if it is just a lubrication issue? Works fine, just annoying, and of course I want to head off any future expensive failures! Especially since it is no longer under warranty.
|
|
| Could be a worn throwout bearing. With a hydraulic clutch I doubt it is a matter of lube, but it could be possible. | |
|
|
|
Replying to: stickguy (Jun 09, 2009 6:25 pm) The mechanical explanation I was given is that some fitting(s) were made of plastic which lead to the premature wear. The redesigned part uses brass. Good luck! |
|
|
I dug out my paperwork, and it was the master cylinder they replaced (probably per the same TSB). That was at 15K. I complained that the noise was coming back at 34K, and of course they didn't hear it, so they lubed the linkage pin to the MS and punted me. At least I have the paperwork to proved that it was a problem before the warranty expired. That and the 3 cars I bring to them for service should get me something. |
|
Man you would not believe what has happened to my auto. About some wks ago i put a post about the p steering pump. If you go back you will see what typed anyway as they took my engine out they found that the SOB'S who worked on the auto to put the pump on and a clerking sound from the pulleys tapped the bolt near the engine And drilled a hole to far in so what did i have after the fact a OIL LEAK!!! this is not honda's defect its a incompatent DEALERSHIP. I am HOT!!! yes i do not have to pay but dam you trust folks to fix your auto and look what you get. Well the dealership that has it its like 10 miles away from the factory where they make them and i will only deal with them to fix ANYTHING wrong with this auto. And purchase the new honda what do you think of this man this is a 1ST! ps. the post about this is 4617,4624,4625,4626, thanks.
|
|
|
Replying to: mookie14 (Jun 10, 2009 9:11 am)
|
|
You are here:
Forums
Sedans
Honda Accord
Honda Accord (2003-2007) Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Honda Accord



Browse by Board
Browse by Topic
Today's Chats