Sign In Join 



Honda Accord (2003-2007) Maintenance and Repair

4933 messages,  Last post on Dec 01, 2009 at 5:02 PM

You are in the Honda Accord Forum. Your Hosts are pat & karens

What is this discussion about? Honda Accord, Electrical, Engine, Coupe, Sedan


Messages Page 437 of 494
1
...
434
435
436
437
438
439
440
...
494
Prev
Next
Last
Go To Msg #
Search This Discussion

#4359 of 4933
Re: Brake Change [f0rl0rn] by elroy5
Jan 05, 2009 (3:34 pm)
Reply

Replying to: f0rl0rn (Jan 05, 2009 1:02 pm)

I have heard the rear brakes need changing before the front. Is anyone aware of that trend? How long on average after the rear do the front ones go out? Should I just replace brakes all the way around while I am at it? I may try tackling my first brake job ever this time around. What are the common pitfalls to pay special attention to? Should I go ahead and swap out the Brake fluid while down there?
 
Yes, the rear brakes do wear faster than the front (on many 7th gen Accords). My rear brakes were changed at 47k miles, and the front were just changed at 60k miles. When you push the calliper piston back in (rear only) you have to turn it clockwise, while pushing. Then line up the groves in the piston with the tab on the inner pad backing plate (should be square with the calliper). There is a paste that comes with the oem pads, that is to be applied between the pad backing and the shims. This paste is supposed to keep the brakes from squealing. If the new pads don't come with shims, use the old ones. There are different opinions on wether or not you should have the rotors turned when replacing the pads. IMO if the brakes are working fine, and there are no deep grooves (1/8") in the rotor, I would not have them turned. It will only make the rotors thinner, and weaker. You just have to break the new pads in carefully. I have a link explaining this, if you want to read it.
#4360 of 4933
Re: Brake Change [elroy5] by tankbeans
Jan 05, 2009 (3:52 pm)
Reply

Replying to: elroy5 (Jan 05, 2009 3:34 pm)

For what it's worth, I have had an 03 4-cylinder since 36000 miles and am now just under 59000. I had the front pads replaced at around 42000 a little over a year ago. I don't think the rear drums have been serviced yet and I haven't had any problems. I'm getting an intermittent squeal, but it isn't constant.
 
I'm going to wait until 60k when I take it in for its check-up and have them check it along with my alignment and all that fun stuff. I'm not handy at all. I can change pads and filters that's about it.
#4361 of 4933
Re: 2005 Honda Accord 4cyl AT EXL [langjahr] by elroy5
Jan 05, 2009 (4:12 pm)
Reply

Replying to: langjahr (Jan 05, 2009 12:54 pm)

I was wondering if sparks plugs are different. I read here somewhere, but can't find it again that a certain spark plug will give you aprox 5 hp throught all ranges, if this is true i would gladly pay double or triple for this, wouldn't eyeryone? , if it is also safe for the engine that is. Thanks for any responces. Charlie
 
All any plug can do, is burn the gas injected into the cylinder. If the plug is not burning all the fuel, you will smell fuel coming out of the exhaust. As long as the oem plugs are in good condition, I don't see any other type of plug adding HP. A lot of people like to buy higher resistance plug wires, and not matching up the rest of the ignition system. The way I hear it, if the spark plug wires are stronger, they will only put more pressure on the coil and other ignition parts. I say keep everything OEM.
#4362 of 4933
Re: Brake Change [tankbeans] by elroy5
Jan 05, 2009 (4:16 pm)
Reply

Replying to: tankbeans (Jan 05, 2009 3:52 pm)

I don't think the rear drums have been serviced yet and I haven't had any problems.
 
Sorry, but I was talking about rear disk brakes only. Should have made that clear, I guess. My old truck had rear drums, and at 60k miles they still looked brand new.
#4363 of 4933
Re: Brake Change [elroy5] by tankbeans
Jan 05, 2009 (4:20 pm)
Reply

Replying to: elroy5 (Jan 05, 2009 4:16 pm)

I'm sorry, I'm kind of dumb. I keep forgetting that you have an EX (SE?). Either way I haven't had the drums checked, I've heard that they're a B---- and a half to fix. Pardon my french.
#4364 of 4933
Re: Brake Change [tankbeans] by elroy5
Jan 05, 2009 (4:29 pm)
Reply

Replying to: tankbeans (Jan 05, 2009 4:20 pm)

Yes, drum brakes have a lot more small parts, reassembly can get complicated, and are a dirty job compared to disks. The best way to make sure everything is put back together correctly, is to do one side at a time, so you can take a look at the other side for reference. Of course to do this, you have to jack up the entire rear end, and remove both wheels and drums.
#4365 of 4933
ABS Light Coming on, Wheels locking up by mfish99
Jan 06, 2009 (7:24 am)
Reply
I have a 2003 EX 4cyl. with 72K Miles. In the first snow storm of the year, my ABS light went on and my wheels would lock up, making my car just about undriveable. I was able to make it home and brought to my mechanic the next day. They replaced the calipers on my rear brakes, and the light went off. The next snow storm, the light went on again, and my wheels locked up. This time I had the car towed to my work parking lot. The next day, I drove the car and the light went off after about 5 monutes, and drives fine. My mechanic couldn't find anything else wrong. It sounds to me like a sensor problem when it snows, but I don't understand why the wheels are locking up? Has anyone experienced this??
#4366 of 4933
Re: ABS Light Coming on, Wheels locking up [mfish99] by kiawah
Jan 06, 2009 (7:55 am)
Reply

Replying to: mfish99 (Jan 06, 2009 7:24 am)

Can you describe what you mean by "my wheels locked up".
 
Does that mean that while you were driving and then applied the brakes, that one or more of the wheels locked up and began to slide on the slippery surface, and if so, which wheel(s)?
 
Or, do you mean, that the brakes applied themselves and locked all four wheels, preventing you from driving the car?
 
Or, do you mean something totally different from those scenarios?
#4367 of 4933
Re: ABS Light Coming on, Wheels locking up [kiawah] by mfish99
Jan 06, 2009 (8:02 am)
Reply

Replying to: kiawah (Jan 06, 2009 7:55 am)

The light comes on before I apply the brakes. I'm not even 100% sure if it it the actual wheels that are locking, but when I apply the accelerator, the engine will rev, bu the car won't move, it'll just spin.. Thanks for replying
#4368 of 4933
03 Accord EX V6 Sedan Tensioner Pulley by avalanche2x
Jan 06, 2009 (4:39 pm)
Reply
I have an squeal/grinding noise that appears to be coming from the pulley. Does anyone happen to know if it is possible to replace the belt tensioner pulley without having to R&R the tensioner assembly? Thank you.

Messages Page 437 of 494
1
...
434
435
436
437
438
439
440
...
494
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement