Sign In Join 



Honda Accord (1998-2002) Maintenance and Repair

1936 messages,  Last post on Nov 21, 2009 at 5:35 PM

You are in the Honda Accord Forum. Your Hosts are pat & karens

What is this discussion about? Honda Accord, Electrical, Engine, Coupe, Sedan


Messages Page 92 of 195
1
...
89
90
91
92
93
94
95
...
195
Prev
Next
Last
Go To Msg #
Search This Discussion

#905 of 1936
Re: dent fix [srx2870] by elroy5
Jun 24, 2007 (12:07 pm)
Reply

Replying to: srx2870 (Jun 24, 2007 10:53 am)

I would check out one of those paint-less dent removal places. They use special tools to push the dent out from the back side. It may cost you a good bit (depends on how hard the dent is to get to), but there is no paint matching to worry about, which is never perfect.
#906 of 1936
1998 Accord Speed Sensor by dea8805
Jun 25, 2007 (9:38 am)
Reply
I have a 1998 Accord LX 4Cyl 4dr 5 speed manual. The Check engine light is on and the speedometer and cruise control do not work. Took it to the local auto shop and the code says its the speed sensor. Can someone tell me where its located (someplace on the transmission is what I was told) and how to replace it?
 
Thank you!!!
#907 of 1936
Re: 1998 Accord Speed Sensor [dea8805] by elroy5
Jun 25, 2007 (1:08 pm)
Reply

Replying to: dea8805 (Jun 25, 2007 9:38 am)

If this link does not go straight to the VSS part, just click on VSS on the left. Your 98 Accord may not be exactly like this, but I assume it's pretty close. Good luck Link below
 
http://techauto.bravehost.com/
#908 of 1936
Accord Transmissions by accordtrans
Jun 26, 2007 (4:06 pm)
Reply
I have a 2001 Accord, 4 cyl. with a 5 speed. With the clutch pedal depressed, there is no noise. When the pedal is released, even in neutral, there is a very loud roaring noise that increases with engine RPM. What could this be? Also, when the clutch pedal is depressed, is the throwout bearing turning, or is it turning when the pedal is released? Or both? Please respond. Thank you for your time.
#909 of 1936
Re: Accord Transmissions [accordtrans] by blane
Jun 26, 2007 (6:14 pm)
Reply

Replying to: accordtrans (Jun 26, 2007 4:06 pm)

You should have gone to the Honda Accord (1998-2002) Maintenance & Repair forum here: http://tinyurl.com/327mkk
#910 of 1936
Re: Accord Transmissions [blane] by pat HOST
Jun 27, 2007 (3:03 am)
Reply

Replying to: blane (Jun 26, 2007 6:14 pm)

Thanks blane - you can see that I moved the post to the discussion you suggested.
 
By the way, be sure to remove any numbers after the final slash when linking to a discussion unless your intent is to link to a specific post. If there is no number after that last slash the last page of the discussion will be displayed. If a number exists, a specific post is linked. That makes it a little harder for a newbie to see what to do next.
#911 of 1936
Re: Accord Transmissions [accordtrans] by kiawah
Jun 27, 2007 (5:33 am)
Reply

Replying to: accordtrans (Jun 26, 2007 4:06 pm)

The throwout bearing is engaged, when the clutch is depressed in. It is normally not engaged and spinning while the clutch is out (unless the clutch is adjusted incorrectly).
 
The symptom you describe, sounds like a bearing is bad on the main shaft in your transmission. Get it looked at quick, before you tear up the transmission further.
#912 of 1936
Aftermarket cat converter by activex111
Jun 27, 2007 (11:43 am)
Reply
Hi,
I needto replace the cat converter on my 99 Accord-V6 with 115K miles on it. The OEM cat converter replacement is almost $840 + Tax. Got a few aftermarket cat quotes for around $350.
Has anyone had any experience with aftermarket cats? also, they told me that it has to be welded in, not bolted.
#913 of 1936
Re: Accord Transmissions [kiawah] by Mr_Shiftright HOST
Jun 27, 2007 (12:50 pm)
Reply

Replying to: kiawah (Jun 27, 2007 5:33 am)

I agree with kiawah---a bad mainshaft bearing in the transmission.
#914 of 1936
'98 Accord HVAC temperature light bulb by ron_m
Jun 27, 2007 (6:16 pm)
Reply
Have any of you guys ever had to replace the light bulb for the red and blue arc-shaped marking above the HVAC temperature control knob? My Accord is a '98 model and it appears as though I may have to remove the digital clock before the two screws at the bottom of the HVAC/Stereo trim bezel--in order to gain access to the bulb that needs replacing. Maybe I'm wrong about this. Hopefully the bulb won't cost me very much and this will end up being a DIY type of project for me.
 
Ron M.

Messages Page 92 of 195
1
...
89
90
91
92
93
94
95
...
195
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement