Ask the Car People.SM


Honda Accord (1998-2002) Maintenance and Repair

2254 messages,  Last post on Jan 23, 2013 at 7:44 AM

You are in the Honda Accord Forum.

What is this discussion about? Honda Accord, Electrical, Engine, Coupe, Sedan

Messages Page 157 of 226

#1560 of 2254 Starter Squeaking - 1999 Accord by robster

Nov 11, 2008 (11:31 am)

I have a 1999 Accord EX with 4 cyl eng with approx 111K mi. I recently began to notice a high pitched squeaking noise that i assume is coming from the starter when I start the car up. The noise lasts for a split second and stops. I've been paying close attention to make sure I'm not holding the ignition key in the start position too long. Is this noise the beginning signs that the starter needs replaced or are there other things that could be causing this? If the starter needs replaced, does anyone have any experience with what Honda dealers charge for replacing starters on a "99 Accord EX?

#1561 of 2254 Re: Starter Squeaking - 1999 Accord [robster] by kiawah

Nov 11, 2008 (2:17 pm)

Replying to: robster (Nov 11, 2008 11:31 am)
Disconnect the accessories belt first, and start it to make sure the problem isn't with one of the belt driven accessories before you go yanking the starter out. You need a little more troubleshooting to really confirm what the problem is.

#1562 of 2254 Re: starter squeaking - robster by jazzchaz

Nov 12, 2008 (11:15 am)

my 2000 Accord EX with 88k on it is exhibiting a whine at start-up which used to go away after about 5min. but is now permanent....is it a whine or a squeal?....of which i suspect is the alternator wearing.

#1563 of 2254 by oscollie

Nov 12, 2008 (5:40 pm)

I am replacing the timing belt and balancer belt on my 2002 Honda Accord. The
thing that is I can't figure out is the direction to hold the balancer shaft with a
screw driver thru the access hole at the rear of the engine. Would holding the
front balancer shaft produce the same result?

#1564 of 2254 '99 Accord A/C control panel by aduncan

Nov 15, 2008 (2:46 pm)

The Fan works just fine. but the A/C panel controls work only part time. When the control panel lights are on every thang works fine. then the lights will go out and then neather the A/C or tjhe Heat will work, the fan still works just fine. What is going on?

#1565 of 2254 drivers side ball joint by mentiya

Nov 15, 2008 (7:48 pm)

I just recently took my car in to get a wheel alignment and was told that I need a new drivers side ball joint. The mechanic showed me the upper ball joint and how it moved and said that it was not supposed to do that. I have a 98 Honda Accord with 133,000 miles and was wondering is this just normal wear as I don't think I have had a ball joint replaced before. Any advice on whether I should go with an OEM or an aftermarket part for my car? Also, are there any recalls on this part at all? Thank you.

#1566 of 2254 Re: drivers side ball joint [mentiya] by blufz1

Nov 15, 2008 (11:12 pm)

Replying to: mentiya (Nov 15, 2008 7:48 pm)
Get a second opinion from a Honda dealer.

#1567 of 2254 Accord 98 Manual Transmission not engaging immediately by tokzzy

Nov 16, 2008 (11:33 pm)

I own a honda accord 98 with manual transmission. Belts have just been replace and should be ok. But after a week, i noticed that the transmission is not engaging immediately. When accelerating on right after changing gears, the car feels like not engaging totally, but after two or three seconds, it engages totally that sometimes it would jerk up. Also, during idle, engine running, it sounded like the engine is going to die but it doesn't. It happens randomly. Any possible problems my car have? Thanks for your help.

#1568 of 2254 Re: Accord 98 Manual Transmission not engaging immediately [tokzzy] by thegraduate

Nov 17, 2008 (9:05 am)

Replying to: tokzzy (Nov 16, 2008 11:33 pm)
Worn/Slipping clutch?

#1569 of 2254 fan doesn't work at lower speeds by booog

Nov 20, 2008 (7:06 am)

On my 2002 Accord, the blower fan doesn't work on speed levels 1 & 2, but does at 3 & 4. I've been told it's either the switch, or a resistor pack. Which one should I start with and where is the resistor pack?

Messages Page 157 of 226

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement