Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Sedans Honda Accord Honda Accord (1994-1997) Maintenance and Repair
1542 messages, Last post on Nov 13, 2009 at 6:46 AM
You are in the Honda Accord Forum. Your Hosts are pat & karens
| i have a honda accord 4 cyl vtech think it is 2.2 i have a mis that starts about 2000 rpms to about 2500 rpms i change spark plugs fuel pump went bad change it and filter put in new rotor and cap. it starts maybe after 4 or five minutes driving then last all the rest of the time i have pulled of fuel injectors wires one at a time to see if they would mis and they did. lost do know where to go now | |
|
Ony one of my high beam lights work, I have checked fusses, bulb. Also my drive lights are not working, is this a concted problem? Does anyone know where I can find the Daytime running lights control unit? I did run a jump wire acrose the high beams this does not solve the dive lights problem. Help I need to get this ready for an out of province inspection. Terry |
|
|
|
|
Hey all, quick question. I have a '96 LX 4-cyl 4-door with 193k miles on it. Lately, I've noticed that my blinkers will hesitate from the time I push down the stalk to the time they start flashing. It is worse when temps are cooler, and when the car hasn't been driven for the day. As time goes on, the hesitation goes away. I'll move to signal a turn, nothing will happen for about one second, then I hear the click but at double-time speed (no flashing on the instrument panel or outside) much like when a bulb is out, then it will pick up and blink like normal. Today was the longest time-period with no blinking (over 5 seconds) and it nearly got me rear-ended; I had to go to the next block and double back to make my turn. Any thoughts or suggestions on what the problem could be? Any/all replies are most appreciated! Thanks! TheGraduate PS: No bulbs are out, and the hazard flashers work immediately when you press the button. 
|
|
|
|
|
Replying to: thegraduate (May 17, 2009 12:07 pm) Mrbill
|
|
|
|
|
Replying to: mrbill1957 (May 17, 2009 12:58 pm)
|
|
|
My speedometer quit, wife drove the car played with the odometer reset and speedometer worked for a few miles. Cruise always worked. Changed the VSS( vehicle speeed sensor) did no good, but since I change the VSS the odometer has registered an additional 40 miles and I am sure the speedo worked during those 40 miles I just did not notice. Speedo registers 20 mph all the time the switch is on. Since it worked and does not worked it sounds like a loose wire or connection but where do I look or is there another solution?? Sure would like some help, Tybum |
|
|
Replying to: thegraduate (May 17, 2009 1:29 pm) Regards, Corkscrew
|
|
|
|
|
Replying to: corkscrew (May 18, 2009 4:47 am)
|
|
|
Replying to: thegraduate (May 18, 2009 7:13 am) Flashers and fuses are different but they tend to be located in the same box, either under hood or under dash. You should find a diagram under each cover that shows where the flasher is and which fuse controls what circuit.
|
|
|
|
|
Replying to: corkscrew (May 18, 2009 8:02 am)
|
|
You are here:
Forums
Sedans Honda Accord Honda Accord (1994-1997) Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Honda Accord
Browse by Board
Browse by Topic
Today's Chats
