You are here: Forums Sedans Honda Accord Honda Accord (1990-1993) Maintenance and Repair

Honda Accord (1990-1993) Maintenance and Repair

1756 messages,  Last post on Nov 29, 2009 at 10:14 AM

You are in the Honda Accord Forum. Your Hosts are pat & karens

What is this discussion about? Honda Accord, Electrical, Engine, Coupe, Sedan

Messages Page 159 of 177 1 ... 156 157 158 159 160 161 162 ... 177 Prev Next Last

Go To Msg # Search This Discussion

#1574 of 1756 TCM box replacement by cybercool Apr 21, 2009 (3:37 pm)
Hi all,   Well, I went and bought a TCM box from ebay for my 93 Accord. Wish me luck it'll work. The seller told me it's a working item and I'll just have to bite the bullet.   Cybercool
#1575 of 1756 Brakes acting up by cybercool Apr 21, 2009 (3:45 pm)
Hi all, My brakes on my 93 Accord EX has a hard or spongy feeling and sound when braking. I had the rear brakes done and replaced. I'm thinking it's a master cylinder job? What type of brake job am I looking at here? Thanks Cybercool
#1576 of 1756 Re: 91 HONDA SEAT BELT IS STUCK [toots92] by savior_of_rock Apr 23, 2009 (7:04 pm)
Replying to: toots92 (Apr 19, 2009 10:13 am) anything seatbelt related will be fixed FOR FREE by the dealership, this is true on all cars makers. as far as I know, safety stuff has a lifetime warrenty.
#1577 of 1756 1990 accord dx axle by stephen1985 Apr 23, 2009 (2:05 pm)
i have a 1990 accord dx 5speed manual transmisson.i put a driverside axle in yesterday and got one block and made a u-turn and it broke.then today i put another one in and went around the block 3 times and then that one broke.i just replace my tie rod ends and ball joints are good.anyone have any ideas on what could be causing this?
#1578 of 1756 axle by dumbhere Apr 24, 2009 (3:13 pm)
are you pushing it in hard enough for the Snap-ring to engage the slot in the tranny? otherwise it will jump out .and it might be why they are breaking,or something else major is wrong.
#1579 of 1756 Resisitance on driving, feels like dragging by cybercool Apr 29, 2009 (5:54 am)
Hi all, I replaced the TCM box on my car and the D4 light stopped blinking. It drives ok again but I've noticed it drives with resistance. I had the rear brakes done and all tires are currently shot and worn. Should I look into buying four new tires or getting a wheel alignment?   Thanks, Jim Replies to this message: gojackets (Apr 30, 2009 7:03 pm) cybercool (May 01, 2009 3:58 am)
#1580 of 1756 Re: Resisitance on driving, feels like dragging [cybercool] by gojackets Apr 30, 2009 (7:03 pm)
Replying to: cybercool (Apr 29, 2009 5:54 am) I would guess that whomever did your brakes did not properly adjust the parking brake cable and you are driving with the brake partly on (even though the handle may be all the way down).   Congrats on solving the D4 problem. I've been fighting it for 9 months on my '93 Replies to this message: cybercool (May 01, 2009 3:58 am)
#1581 of 1756 Re: Resisitance on driving, feels like dragging [gojackets] by cybercool May 01, 2009 (3:58 am)
Replying to: gojackets (Apr 30, 2009 7:03 pm) hey Gojackets   Thanks, I found my TCM box to solve D4 problem on Ebay and it's affordable. At Autozone parts store, they were asking $379 and I bought mine used on Ebay for $59.00. I hope it'll last me long.   peace Jim
#1582 of 1756 92 Honda Accord turn signal flasher. by 94shadow May 02, 2009 (1:40 am)
Hi all... It's me again. Here goes, I replaced all of my incandescent light bulbs with LED light bulbs and all the trouble lights came on. e.g. brake light on, turn signal doesn't blink check engine light stays on. I mentioned this problem earlier on this forum but I forgot what I wrote. Someone wrote that I needed an LED compatible flasher relay. I called all the parts house in Hawaii but some of them did not know what I was talking about. Where can I get a flasher or relay to run all of my LED light bulbs. I took all the LED bulbs out of my car. Any answer would be greatly appreciated.. Mahalo, 94shadow
#1583 of 1756 Calling Mr. Shiftright and all experts - how to change the driver's wiper? by geez123 May 03, 2009 (6:55 pm)
First let me say THANKS to Mr. Shiftright! His advice was spot on!   Now, I must pose another question. I need to replace the wiper on the driver side. I already bought the blade and the arm. How do I unlock the current wiper so that I could put in new one?   The instructions that came with the Michelin HydroEdge wiper was not clear. It had instructions on how to install it but no instructions to remove the current wiper!!   Help again!   Thanks! Replies to this message: Mr_Shiftright (May 03, 2009 10:06 pm)

Messages Page 159 of 177 1 ... 156 157 158 159 160 161 162 ... 177 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Sedans Honda Accord Honda Accord (1990-1993) Maintenance and Repair