Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Sedans Honda Accord Honda Accord (1990-1993) Maintenance and Repair
1756 messages, Last post on Nov 29, 2009 at 10:14 AM
You are in the Honda Accord Forum. Your Hosts are pat & karens
|
My Honda was driving fine yesterday. This morning, I could not start it-- the key would not turn and the shiftstick would not move. My ten-year old son was fumbling inside the car yesterday but he denied touching anything except the garage door opener. What happened? What to do? Thanks for any advice you can give.
|
|
|
|
|
Replying to: bubuyog3 (May 01, 2008 6:19 am) Mrbill |
|
|
Replying to: mrbill1957 (May 01, 2008 1:59 pm) Thank you.. thank you! You're an angel.Now I know better! Now I don't have to call towing service to bring in the Honda to the shop. You're a blessing!
|
|
| Hi,I have an 91 accord sedan that was working fine until today.The guages on the dash all stopped working.No gas,temp,rpm nothing.I checked the fuse and everything looks good.Any suggestions? | |
|
|
|
Replying to: bubuyog3 (May 01, 2008 2:17 pm) When you mentioned your son was in the car, but he didn't say he touched anything, I thought maybe he grabbed the steering wheel, gave it a twist, locking the steering wheel but also locking it under torque. That can lock things up until you turn it. Mrbill
|
|
|
Replying to: mrbill1957 (May 01, 2008 6:07 pm) |
|
Any one have DIY suggestions on how to replace the air compressor in a '92 Honda Accord? Is there a simple step by step list of instructions?
|
|
|
|
|
Replying to: diyw2b (May 02, 2008 2:41 pm) 2. Use a Refrigerant Recovery/Recycling System to recover the refrigerant from the system. 3. Remove: o power steering mounting bolt and nut o adjusting bolt o adjusting bolt bracket o power steering belt o power steering pump 4. Remove the two cruise control actuator mounting bolts, disconnect the connector and remove the cruise control actuator. 5. Remove the alternator harness clamp and disconnect the alternator harness. 6. Remove: o alternator mounting bolt and nut o adjusting bolt o adjusting bolt bracket o compressor belt o alternator 7. Disconnect the connectors from the condenser fan, and remove the connector from the compressor. Remove the three mounting bolts and remove the condenser fan shroud. CAUTION: Do not damage the radiator fins when removing the fan shroud. 8. Disconnect the suction and discharge hoses from the compressor. CAUTION: Cap the open fittings immediately to keep moisture and dirt out of the system. 9. Remove the four compressor mounting bolts and compressor. CAUTION: Do not damage the radiator fins when removing the fan shroud. 10. If necessary, remove the compressor bracket as shown. 11. Install in the reverse order of removal, and: o If a new compressor is installed, calculate the amount of refrigerant oil in the A/C system by draining the oil through the suction fitting on the old compressor: 100 cc (3 1/3 fl oz) minus contents of old compressor, equals the amount of refrigerant oil to be drained from new compressor. * Replace 0-rings with new ones at the pipe joints, and apply a thin coat of refrigerant oil before installing them. * Do not damage the radiator fins when installing the compressor. * Be careful to connect the alternator harness as shown. * Adjust the belt. * Charge the system. * Test the performance. |
|
|
Hi all, When I called autozone for a price check for the oxygen sensor, I was told there is two in my 93' Accord EX. And they're not identical on top of that. Is this true? Can someone reconfirm this? Thanks Cybercool
|
|
|
Replying to: cybercool (May 03, 2008 7:44 am)
|
|
You are here:
Forums
Sedans Honda Accord Honda Accord (1990-1993) Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Honda Accord
Browse by Board
Browse by Topic
Today's Chats
