Sign In Join 



Dodge Durango Maintenance and Repair

718 messages,  Last post on Nov 15, 2009 at 8:59 AM

You are in the Dodge Durango Forum. Your Hosts are steve_ & tidester

What is this discussion about? Dodge Durango, Dodge, SUV


Messages Page 9 of 73
1
...
6
7
8
9
10
11
12
...
73
Prev
Next
Last
Go To Msg #
Search This Discussion

#76 of 718
Re:2004 engine malfuntion by pas379
Feb 09, 2006 (6:54 pm)
Reply
read my #47 then #58. Dodge dealer replaced the head on my 1999 Durango. Had it back for about 4 weeks now after replacing the head and it seems to be running fine now. bought it with 32K on it but can see by the previous owners paperwork it started at about 10,000 miles. Out of warrenty when I got it. Now at 8oK and cost me $1400. Runs good now and no check engine light
#77 of 718
Re:2004 engine malfuntion [pas379] by j9shemi
Feb 11, 2006 (5:33 am)
Reply

Replying to: pas379 (Feb 09, 2006 6:54 pm)

I've had it back for a week now, and no engine light. But it's running really rough when it's cold. Almost to the point of stalling when I brake. I think the idle is off. When it's warm it runs good. Do you think I should bring it back, or wait a bit?
#78 of 718
Re: KEYLESS REMOTE INSTRUCTIONS [jules469] by big2thumbs
Feb 11, 2006 (8:45 am)
Reply

Replying to: jules469 (Jan 13, 2006 8:41 pm)

My '04 Durango manual says:
1. Enter your vehicle
2. Put on your seat beat
3. Put key in ignition
4. Key key to ON position - not start
5. Press and HOLD the UNLOCK button on FOB
6. After holding the UNLOCK button for 4 seconds, also press the PANIC button within 6 seconds.
7. When asingle chime is heard release both buttons. The chime in an indication that you have successfully entered program mode. All fobs that are to be programmed must be done so within 60 seconds of when chime was heard.
8. Using the fob to be programmed, press and release both the LOCK and UNLOCK buttons.
9. A single chime will be heard.
10. Within 4 seconds of hearing the chime, press and release the UNLOCK button on the fob.
11. A single chime will be heard.
12. Repeat 8-10 for each FOB
 
It worked for me just a few minutes ago.
#79 of 718
2004 Engine Malfunction by j9shemi
Feb 21, 2006 (5:07 pm)
Reply
I've been driving my Hemi for a couple of weeks now. Still runs rough. On Sunday, yet another light came on. This time its the Electronic Throttle Malfunction. It went back off but who knows! I don't know what else to do. It's been in and out of the dealer's shop, and it hasn't run the same since they took apart the engine. Thank god this is a leased truck, and I can hand them back the keys in 2 more years!
#80 of 718
Dumping fuel by daveorcat
Feb 25, 2006 (8:35 pm)
Reply
I have a 99 dodge durango 4.7 engine. The check engine light came on and we found out that one of the codes was saying "system to lean". another code said power steering pressure out of range. also the o2 sensor slow response. One o2 sensor was replaced and the power steering switch. We had to get a new catalytic converter because the dumping of fuel clogged it. None of this fixed the problem. It continued to dump the fuel. We had it in and out of the shop and finally took it to the dealer. Here is their diagnosis: POWER STEERING SWITCH IS LEAKING FLUID THROUGH ITS TERMINALS, THE OIL HAS WICKED UP THE SIGNAL WIRE TO THE PCM. (UNSURE IF PCM IS CONTAMINATED) THE POWER STEERING SWITCH ALSO SHARES THE SAME GROUND AS THE OXYGEN SENSOR. THIS COULD ALLOW FLUID TO ENTER THE OXYGEN SENSOR THROUGH THE WIRING. THE OXYGEN SENSOR HAS BEEN CONTAMINATED BY OIL FROM POWER STEERING SWITCH THE POWER STEERING & OXYGEN SENSOR NEED TO BE REPLACED.
AND THE 02 HEATER GROUND WIRE NEEDS TO BE SEPERATED FROM THE POWER STEERING SWITCH GROUND. They do not gaurantee this will fix the problem. Anyone have any similiar problems? If we put another 600 into this and they are not correct are we required to pay them for it?
#81 of 718
loud noise when locking and unlocking the door locks by daveorcat
Feb 25, 2006 (8:40 pm)
Reply
There is a loud noise when locking and unlocking the door locks. It happens everytime. Two of the door locks have to be pulled up manually cause they wont work by the remote or the buttons in the car. Anyone have anything similar?
#82 of 718
Radio by daveorcat
Feb 25, 2006 (8:43 pm)
Reply
This is my third post of problems with my 1999 durango. My radio went out. It went from working fine to being stuck on a channel to working fine to the volume going down on its own to not working at all. All in one week. The time doesnt even work. There is no lighting at all. With all these mysterious problems i will not buy a dodge, chrysler or plymouth ever again. Anyone have and ideas about the radio/clock?
#83 of 718
Re: 2003 dodge durango - engine light on [mtone] by slammie
Feb 25, 2006 (8:55 pm)
Reply

Replying to: mtone (Jan 06, 2006 6:10 am)

The same problem occurred with my 98' Nissan Pathfinder. Well, almost...I filled the truck while it was running, which triggered the check engine light. It stayed on until the dealer reset it. I would guess you'll have to visit the dealer also.
#84 of 718
durango oil light by mopar5m4me
Feb 27, 2006 (5:52 pm)
Reply
just bought 03 durango oil light comes on sometimes on first start up goes off if i shut off and restart..sounds like oil pressure sending unit to me anybodyelse?
#85 of 718
2003 Dodge Durango 6 Disc/Radio by briguy1
Feb 28, 2006 (8:56 pm)
Reply
I was wondering if anyone has taken out a radio out of a 2003 Durango, if yes how complicated is it? I ask because I am connecting a amp convertor to it. I just need to know how to do so. Thank You for your help.

Messages Page 9 of 73
1
...
6
7
8
9
10
11
12
...
73
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement