Last post on Jul 07, 2013 at 9:26 PM
You are in the Dodge Durango
What is this discussion about?
Dodge Durango, Dodge, SUV
#405 of 853 Re: 2000 Durango - turn signal problem... [surfdade]
Jan 10, 2007 (3:42 pm)
i have a 2000 durango with the 4.7 motor. part stores don't cary parts for that motor so i had to go to dodge directly. Mine started going bad in may '06. then it was fine then two days ago it went completly out. its under the dash on the drivers side along the wall. it's a green box. costs $35.00. i didn't have to take any panels out to get to it. hope this helps.
#406 of 853 Re: all sorts of electrical problems [jdl_saunders]
Jan 11, 2007 (9:23 am)
My 2001 Durango has lost all tghe electronics in the steering wheel incuding: Air bag, cruise control, radio buttons and horn. Any ideas?
#407 of 853 Re: all sorts of electrical problems [jallein]
by Stever@Edmunds HOST
Jan 11, 2007 (9:29 am)
Sounds like a faulty clock spring. There's a TSB out on them for the Durango - (NHTSA ITEM NUMBER - 620059). You can see all the TSB and recall summaries with the Edmunds Maintenance Guide.
Probably need to see your dealer and hope the TSB covers the fix free.
#408 of 853 Re: 2000 Durango - turn signal problem... [jessi4]
Jan 12, 2007 (2:18 pm)
Yep It was the Flasher I replaced it and it works like a champ now
#409 of 853 Multi Disk CD Player Not Working
Jan 13, 2007 (2:34 pm)
I unplugged the two back panel wiring-harness connectors on my 2004 Durango Limited multi-disc CD player/radio to run cabling behind the unit. Once I plugged the connectors back in and powered up the unit, I cannot select the CD player mode. AM/FM/DVD (VES) all work fine. Additionally, when I open the driver door I hear the CD disc changer apparently shuffling CDs for about 15 seconds, then silence. There were 5 CD's in the unit when I unplugged it. Any insight is greatly appreciated.
#410 of 853 04 Durango hissing noise
Jan 14, 2007 (7:24 pm)
I have had a hissing noise coming from the gas peddle area for quite some time. Dealer can't find it and says that there are no vacuum lines in the area. The noise is most noticable when letting off the gas over 1000rpm. When it drops under 1000rpm it goes away. Anybody know what this could be? Thanks.
#411 of 853 Re: 2005 Durango hemi 5.7 stalling [wesw]
Jan 16, 2007 (7:43 pm)
I have a 2005 hemi durango with the same problem. Dealer so far has not been able to "fix" the problem. Started with firmware upgrade, now said the instrument cluster was "losing" connection and posting an error code. Don't know that I buy this, but we'll see what happens. Usually happens after the first 5 minutes after cold start.
#412 of 853 Re: '05 Dodge Durango Hemi Limited stalling problem [shepard007]
Jan 16, 2007 (7:58 pm)
Great information. I too have the EXACT problem on my 2005 SLT Hemi Durango. Been through all the "upgrades" now they replaced the instrument cluster as it was "posting" error codes??? Other symptoms for me have been airbag light on intermittently. How scary is that? My dealer has been trying....so points for that, but when you buy new to have reliable transportation, but have to take it in all the time and worry about stalling, what good is it?
#413 of 853 2005 Durango Hemi SLT Vent whistling
Jan 16, 2007 (8:03 pm)
Another problem on the 2005 Durango. When the vent control is set to recirculate, and the lower is set to off, when the vehicle hits 50 mph, there is a whistling/squealing heard from the vent. If the blower is turned on, or the control changed, the sound can be made to stop. The dealer has had two attempts to fix, one covered with a TSB for an expansion valve, (no fix) then another TSB for a pinched AC line....(no fix). Any one else out there with this annoying problem?
#414 of 853 2002 Durango Won't Start - HELP!
Jan 20, 2007 (2:19 pm)
My 2002 Durango with 4.7 engine and 26K miles has the following problem:
I get in it and turn the ignition. It does not crank at all. Every electrical accessory works - windows, fan, lights, instrument cluster, etc.
The 10 amp fuse in slot #10 blows. It appears to support the PCM and Fuel Pump. if I replace the fuse it just blows out again immediately. If I have the truck towed to my mechanic it shows no error codes and if they replace the fuse, it starts fine. This lasts for a week, several weeks, etc. then it happens again. the car can be sitting for 20 minutes, an hour, overnight, warm, cold, rain, sunny - its random.
The PCM has been tested and replaced. The ignition switch has been replaced.
Does anyone have any ideas? Or a schematic to where this fuse goes, etc. ?