You are here: Forums Coupes & Convertibles Nissan 300ZX Nissan 300ZX

Nissan 300ZX

315 messages,  Last post on Aug 18, 2009 at 11:47 PM

You are in the Nissan 300ZX Forum. Your Host is claires

What is this discussion about? Nissan 300ZX, Coupe

This forum is for anyone interested in the 300ZX, all years and variations.

Messages Page 27 of 33 1 ... 24 25 26 27 28 29 30 ... 33 Prev Next Last

Go To Msg # Search This Discussion

#252 of 315 Re: My 300ZX [cb300zx] by 95convertna Mar 24, 2008 (12:31 pm)
Replying to: cb300zx (Dec 06, 2007 12:45 pm) im pretty sure they are the same length, but you could also go with the one piece drive shaft from z1motorsports.com. i think the only differenc in drive shaft and rearends in the na and tt is the na has a steeper gear ratio than the tt and also the hicas system on the tt which is junkaroo by the way
#253 of 315 Re: Rear Vibration at 40mph [unknown300zx] by 95convertna Mar 24, 2008 (12:36 pm)
Replying to: unknown300zx (Jul 19, 2006 2:09 pm) lug nuts, wheel bearings, and tire balance, also the tire maybe a little out of round if you have let it set up for an extended amount of time or have been using the e brake for a manner other than intended alot. make sure the rims are not damaged in any way
#254 of 315 Re: electrical fuel problem? [coach5] by 95convertna Mar 24, 2008 (12:38 pm)
Replying to: coach5 (Jul 25, 2006 3:24 pm) try the fuel pump, it might build enough pressure to rev so it uses all the fuel in the system,
#255 of 315 Re: cuts out at 2500 rpm [dmartin_1] by 95convertna Mar 24, 2008 (12:40 pm)
Replying to: dmartin_1 (Feb 23, 2007 1:26 pm) could be a cam sensor or a crank sesor
#256 of 315 Re: cold air intake?? [schittonu] by 95convertna Mar 24, 2008 (12:42 pm)
Replying to: schittonu (Jun 20, 2007 9:14 pm) they come out the factory with a cold air intake, under the nose panel in front of the radiator right?
#257 of 315 Re: Engine swap N/A to TT [tr_1890] by 95convertna Mar 24, 2008 (1:03 pm)
Replying to: tr_1890 (Oct 18, 2006 10:54 pm) is it an auto or a manual? if you can buy the whole front clip and ecu, it just makes routing the piping and electrical connectors easier
#260 of 315 no injector pulse/both wires are testing pos+ by justinlust Mar 29, 2008 (5:43 am)
I have a 1985 300 zx I cannot figure out why it is not pusing the injectors . I have replaced the disributor ,coil , and control box. When I test the wires to the injector test as constant pos+ even with the key off . Any body Have an Idea what it could be ?
#261 of 315 seats for 85 300zx by wals Apr 12, 2008 (2:04 pm)
any sugestions on seats for my 85 300zx, I had some good honda seats but can't figure out how to get them to work,would like some good affordable after market, thanks for any help.

Messages Page 27 of 33 1 ... 24 25 26 27 28 29 30 ... 33 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Coupes & Convertibles Nissan 300ZX Nissan 300ZX