Sign In Join 



Chevy Suburban

944 messages,  Last post on Nov 20, 2009 at 6:44 PM

You are in the Chevrolet Suburban & Tahoe Forum. Your Hosts are steve_ & tidester

What is this discussion about? Chevrolet Suburban, GMC Suburban, SUV


Messages Page 85 of 95
1
...
82
83
84
85
86
87
88
...
95
Prev
Next
Last
Go To Msg #
Search This Discussion

#836 of 944
# 562 by heathhooper
Jun 01, 2008 (9:39 am)
Reply
I am experiancing the same problem with my tahoe. Have you found a solution yet?
#837 of 944
Re: A/C Belt & Pulley Issue [parkerbobtampa] by heathhooper
Jun 01, 2008 (9:40 am)
Reply

Replying to: parkerbobtampa (Feb 10, 2006 7:23 am)

have you found a solution for this yet? I need some help.
#838 of 944
Transmission install/how to by 1500grnburban
Jun 14, 2008 (4:14 pm)
Reply
Hey Chevy Guys & Girls,
 
I have a 98 suburban and I just bought a used transmission with transfer case attached for 800.00. I'm mechanically inclined and could install it my self, but I have never installed a transmission with 4 wheel drive before. I'm looking for some instructions or someone with know how that can walk me thru the remove/install of my old trannny and install of the new one. My truck is 1500 4 wd if I have to I will take it to someone but if I can cut cost on the labor and do it my self I'd rather do that. Please post something here if you know of any free available resources I can use to help me with this project.
 
Thanks
#839 of 944
Re: Ignition fuse keeps blowing [xtianknights] by mike069
Jun 15, 2008 (8:13 am)
Reply

Replying to: xtianknights (Aug 17, 2005 8:43 pm)

I have same problem with 96 can you help me
#840 of 944
Re: Problem with my 99' Suburban [macalanmav] by shagcmb23
Jul 24, 2008 (7:12 am)
Reply

Replying to: macalanmav (Jul 30, 2007 1:22 pm)

Did you ever find a solution to this issue? My 99 is doing the same thing... Thanks!
#841 of 944
oil gauge is pegged out on the instrument panel by zues1
Jul 28, 2008 (11:22 am)
Reply
I own a 96 2500 4x4 w/a 454 and my oil gauge is pegged out on high. Sometimes it begins to jump back and forth, and sometimes it reaches the zero part of the gauge. When this occurs it shuts the burb off. This problem is unpredictable and it occurs pretty often. I've replaced the oil sending unit (which is a pain to get to), the instrument panel, and before I bought the burb the owner before me had a high pressure oil pump put on. I've been told the oil gauge will drop to zero if the oil sendin unit wire becomes grounded. ANY SUGGESTIONS, TIP,OR HINTS are APPRECIATED!!!!!!!!!!
#842 of 944
Re: Problem with my 99' Suburban [shagcmb23] by tj27
Jul 29, 2008 (7:32 am)
Reply

Replying to: shagcmb23 (Jul 24, 2008 7:12 am)

Yes, finally a mechanic said that the starter if it is not a genuine GM will usually last only 1 to 2 years….the place I was taking it to kept testing the starter and said it was fine. As soon as the new mechanic replaced the starter with original GM starter I have not had a problem since I sent out the request for help. He says the aftermarket starters after time heat up and expand and will lock against the casing….if you have someone turn the key to the start position and then take a hammer and tap the starter it should start if it is the starter…it just needs to be jolted to get it to unlock. I love my Suburban again.
#843 of 944
98 Suburban Shaking Violently by fuegoman
Aug 19, 2008 (9:11 pm)
Reply
Lately while driving uphill my 98 K1500 starts to shake really bad... it's not the tranny, it was just replaced and then checked again... the mechanic had it happen to him and he seems to think it's not getting fuel... already replaced the fuel pump...
 
To me it feels like the timing is doing something funny, but have replaced the distributor 3 times and its still doing it?
 
Thanks for the help.
#844 of 944
Re: 90 Suburban Heater Problem [wmbigs] by mudrat
Aug 24, 2008 (8:49 am)
Reply

Replying to: wmbigs (Dec 13, 2006 8:52 pm)

I had almost the same problem minus the RPM change. Check under the dash. The ductwork in the center, above the hump, does not match up very well. I took wide seal tape and wrapped the opening. Also, rust right of the hump, a cable comes down to a fin that directs all the air. A clip on mine broke. The deflector did not close completely. Vacuum does control the deflector. So motor vacuum might be part of the problem.
#845 of 944
A/C and Heater Porblems.. Please Help. by eric90suburban
Aug 31, 2008 (2:00 pm)
Reply
I have a 1990 Suburban as I'm sure you can tell by my name. I have had it for a long time and when I got it everything worked fine. Recently the A/C and heater started acting up. They both work if your touching the vent but the fan that blows the hot and cold air out just doesn't work. Is this a common problem? Is it an easy fix? Any ideas for me? Please help me out here.
                  Thanks for you time, Eric

Messages Page 85 of 95
1
...
82
83
84
85
86
87
88
...
95
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement