Last post on Jun 10, 2013 at 3:37 PM
You are in the BMW M/M3/M6
What is this discussion about?
BMW M3, Coupe, Convertible
#220 of 250 Re: e46 m3 maintenance [roadburner]
Mar 25, 2009 (1:53 pm)
Thanks. I have the bentley manual and saw that section before and adjust the window according to the direction. I will try to repeat the steps over again from beginning to end and see what happens.
Apr 01, 2009 (7:41 am)
I have a 2002 BMW M3 with SMG that I just bought from a friend. It has over
100k on it. I love this car. But here is the problem. In a manual transmission
when you don't depress the clutch far enough and you press down on the gas
pedal the car will race some before it goes into gear. This is what the SMG
appears to be doing. I am hoping that maybe it just needs and adjustment or
some lubrication or something small. Is this a common problem? Is it a big
problem? Can you help?
#222 of 250 Re: SMG [gregory11]
Apr 01, 2009 (1:37 pm)
You really need to take the car to a good BMW dealer or indie BMW tech. It could be something simple and it could be something pricey- but you need to have it diagnosed by someone who knows what they are doing. I hope you haven't been using just the throttle to hold the car on hills; that will kill an SMG clutch in no time...
#223 of 250 Re: e46 m3 maintenance [gmonkies]
May 08, 2009 (11:15 am)
I have the same problem on my m3 2003. Would you please tell me what is the part that you have changed ( dealer's part#? or the rubber O-ring). I have seen the slotted screw or plug on the side of the engine block (passenger side) where the oil leaking from. I called the BMW dealer in my area and they cannot see any part in this location!!!. Thanks for your time.
#224 of 250 Re: e46 m3 maintenance [sal4ever]
May 08, 2009 (11:04 pm)
That is the oil pressure regulator on the passenger side of the block. It requires a flat short head to remove. It's kinda tight so you will need a flex wrench with a flat head socket. Becarefull not to strip the grove on the regulator. If you can't get it off then you will have no choice but to take the exhaust manifold off for more room.
In any case, my friend just gave me another rubber O-ring from his O-ring box, no BMW parts required unless you want to pay the dealer extra $ for the same O-ring that you can get from the parts store. Feel free to let me know if you need anymore help.
#225 of 250 Changing spark plug for my M3
Jun 10, 2009 (5:09 pm)
I was driving on Cruise Control and suddenly the motor choked for a sec. 15 minutes later, check engine light came on and when I got off the highway, the motor was running rough like a miss fire. Shut the car off and the check engine went away but still runs rougher than normal and lost of power.
It has 84K on it right now, not sure if the spark plug was changed before I bought it. Hopefully it just needs a new plug.
In any case, the bentley manual does not show the m3 set up for changing spark plug. It does not have a bolt that holds down the individual ignition coil like the other 3 series.
After I separate the ignition wire harness wire from the ignition coil, does the coil just pull up/out? The coil is pretty tight in there, not sure if there's anything else I need to do or just man handle it. Hopefully once I fix replace the plugs, it will stop miss firing and running rough
If it was my honda, I'll just yank it out but always more fearful when it comes to working on the bimmer.
#226 of 250 2008 M3-Rear Grinding Metal Noise
Oct 31, 2009 (7:24 pm)
Every morning steering right to back out or steering sharp right moving forward, there is a grinding metal noise coming from the rear. An example of the noise would be as if one was to move a very heavy couch with four wooden legs a very short distance over concrete floors. Weird example but that is the first thing that pops in my mind. Or another example would be as if the wheel was about to fall off the axle and the titled wheel is grinding against the axle.
It only happens with SHARP right turns. But once the car is warmed up, the noise does not happen again.
Any ideas why the noise? solutions?
I thought it was a lack of oil for the slip differential, but the dealer changed it out and still makes the noise, only in the morning.
Thanks for any feedback
#227 of 250 Re: 2008 M3-Rear Grinding Metal Noise [jjohnjohn]
Nov 01, 2009 (7:00 am)
I would say it is the gear oil - but not a lack of oil. In the morning, the oil has settled to the bottom of the case and it's cold/thick. Once it's stirred up into the gears and warm, your noise goes away.
I wouldn't expect the noise to be that severe sounding though....
#228 of 250 Re: 2008 M3-Rear Grinding Metal Noise [jjohnjohn]
Nov 05, 2009 (9:24 pm)
LSDs are sometimes noisy when cold; it's the nature of the beast.
#229 of 250 E46 m3 differential noise
Dec 21, 2009 (3:15 pm)
A friend told me the whinning noise coming from the back when I'm cruising at ~ 80 MPH on the cruise control is my rear diff and it shouldn't do that. The sound is normally not there when I drive on the street or when I punch it.
He suggested I change the fluid and see if the noise goes away, otherwise, I might have a lose pinion. Anyone else has or had this problem. I always thought that it was a normal common sound.
My M3 now is 01 Manual with 88K. Any thoughts?