Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Coupes & Convertibles BMW M/M3/M6 BMW M3 Maintenance and Repair
228 messages, Last post on Nov 05, 2009 at 9:24 PM
You are in the BMW M/M3/M6 Forum. Your Host is claires
|
|
|---|---|
|
Replying to: rroscher (Oct 12, 2008 7:49 am) You might check for a hydraulic leak, as that could damage the upholstery or paint surfaces back there.
|
|
|
Replying to: Mr_Shiftright (Oct 12, 2008 8:10 am)
|
|
|
|
|
Replying to: rroscher (Oct 12, 2008 8:47 am)
|
|
|
Replying to: Mr_Shiftright (Oct 12, 2008 9:20 am)
|
|
|
|
|
Replying to: rroscher (Oct 12, 2008 9:32 am) I believe there are trouble codes that can be read on this car to help with diagnosis on the top mechanism. |
|
|
HI Just need to know what is the right tool to use for the drain plug. The last time/1st time I change the oil, i used a hex key to remove and tighten the drain plug. Since there was no way I can use the torque wrench, I hand tighen the drain plug (using new washer) with the hex key as tight as I can without stripping it. After a couple of months, I saw oil leak from the plug. I realized that the drain plug looks like it can be torqued with a torx set even though the hex key works. Now is time for another oil change, I used the torx to remove it but it started to slip. To prevent any damamge with a stuck drain plug that will require to be tapped out, I decided to leave it alone until I figure out the right tool. If it does use a torx, what size am I suupose to use? It was either T40 or T45 that had the best fit but still slips. Or am I suppose to get a hex key to remove and use a hex key end that can go on my torque wrench to tighten down properly for seal. Thanks! |
|
|
does anyone have DIY direction and diagram/photo on the air pump/ valve and where it is located? Bentley manual shows nothing that I can find on that and i can't seem to find anything detail on other forum, aside from the fact that peole claim is a easy easy diy. The dealer quoted a price of $1000 for parts and labor any help will be appreciated
|
|
|
|
|
Replying to: gmonkies (Jan 07, 2009 1:30 pm)
|
|
|
Replying to: Mr_Shiftright (Jan 07, 2009 4:47 pm) http://forums.bimmerforums.com/forum/showthread.php?t=92029 i have a 01 m3, will so will the e36 be similar to e 46?
|
|
You are here:
Forums
Coupes & Convertibles BMW M/M3/M6 BMW M3 Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 BMW M3
Browse by Board
Browse by Topic
Today's Chats
