You are here:
Forums
Hatchbacks
Mazda3
Mazda3 Maintenance & Repair

4533 messages, Last post on Dec 05, 2009 at 6:27 PM
You are in the Mazda3 Forum. Your Host is pf_flyer
| I had a 86 Mazda 626 that I drove 244000 miles over 14 years. | |
| I had a 90 Mazda MX6 that I drove for 260000 miles... | |
|
I just took my mazda3 in because the rear wheels showed much more brake dust than the front. Since this was opposite from the way it should be, I was concerned. The dealer said that there was a bulletin (whatever that is) related to this problem. However, when they went to install this part they found that the rear rotors and pads were worn and had to be replaced. They did all of this work under warranty, but first tried to say that we had driven the car with the handbrake on. I responded that the handbrake had never been used as the car is automatic. Then they said that they were going to fix it all under warranty anyway. I just wanted to know if anyone else had noticed this problem(with the brakes, not the service dept)? matt |
|
| You rear pads & rotors were worn already?!? How many miles have you racked up your Mazda3? Whatever it is, it sounds way too soon for that. | |
|
Only some with rear disc brakes though. None of the earlier Proteges with rear drums had an issue with the parking brake cables sticking. I think some moisture may get in there and freeze (literally) the parking brake cables. I'm not sure of the situation with the 3, but on the Protege/P5, the end of the cable points upwards. There are rubber boots covering them, but I'm sure some dirt and moisture gets in there, which may cause the cables or mechanisms to stick. |
|
|
I have heard many Mazda3 owners observing more brake dust on the rear than front. Though none of them reports the pad worn out. There is a believable speculation that this is tie to the ABS. Hence my question above. |
|
|
The N. American-spec Mazda3 issues have been (in order of prevalency): - airbag light - CEL light - extreme pitting on brake rotors My dealer just called me on Monday, my Mazda3 factory order was submitted last week, so I'm looking at a Jan or Feb build. It'll be interesting to see if these issues have been fixed at the factory yet. |
|
| I know brake rotors all rust (supposed to), but I wonder what threshold Mazda is using as a measure. | |
You are here:
Forums
Hatchbacks
Mazda3
Mazda3 Maintenance & Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Mazda MAZDA3



Browse by Board
Browse by Topic
Today's Chats