Sign In Join 



Mazda3 Maintenance & Repair

4531 messages,  Last post on Oct 22, 2009 at 5:40 PM

You are in the Mazda3 Forum. Your Host is pf_flyer

What is this discussion about? Mazda MAZDA3, Hatchback, Sedan


Messages Page 454 of 454
1
...
448
449
450
451
452
453
454
Prev
Next
Last
Go To Msg #
Search This Discussion

#4522 of 4531
Re: engine light 2004 mazada 3//being scam/hoodwink [darthvada] by autonomous
Oct 07, 2009 (5:05 pm)
Reply

Replying to: darthvada (Oct 05, 2009 3:56 pm)

now the engine light is on and now they are telling me its the o2 sensor and a valve cleaning needs to be done...i feel i am being scam/hoodwink...???
Sorry to hear that. Why not get a second opinion about the cause of the check engine light from an independent garage? The car is almost 6 years old, so a faulty O2 sensor is possible. You mention "valve cleaning", did you mean a fuel system cleaning? If so, I'd recommend having the fuel system cleaned if you have not had that done since 2004.
#4523 of 4531
Re: 2008 3i Touring Manual update [custadvocate] by nsbio1
Oct 07, 2009 (6:18 pm)
Reply

Replying to: custadvocate (Sep 21, 2009 11:19 am)

Guess what - my rotors that had been resurfaced earlier this year are warped again! I am not driving the car super hard: I also drive my wife's corolla and the rotors there are just fine. Seems like my car's rotors are junk, but the dealer won't fix that for free because it is almost impossible to prove that rotor warping is not because of abuse...
#4524 of 4531
Re: 2008 3i Touring Manual update [nsbio1] by shipo
Oct 08, 2009 (2:08 am)
Reply

Replying to: nsbio1 (Oct 07, 2009 6:18 pm)

Please understand that when you have old rotors resurfaced, you are having a significant amount of metal removed from the rotors, and that makes them more susceptible to warping. That is the single reason why I NEVER have rotors resurfaced, they're cheap to buy (even top quality units should be less than $50 each), and easy to replace.
 
Best regards,
Shipo
#4525 of 4531
Re: 2008 3i Touring Manual update [shipo] by autonomous
Oct 08, 2009 (1:24 pm)
Reply

Replying to: shipo (Oct 08, 2009 2:08 am)

old rotors resurfaced... makes them more susceptible to warping ... I NEVER have rotors resurfaced, they're cheap to buy
Agreed on both fronts: 1) resurfacing is only a stop-gap before the inevitable and 2) the cost of rotors has dropped significantly over the years.
#4526 of 4531
2005 mazda 3 hit 50,000 by sawolf
Oct 22, 2009 (8:21 am)
Reply
Would like to get recommendations for what services I should get for my Mazda that just hit 50,000 miles. It still runs great although it isnt whisper quiet anymore. Thanks
#4527 of 4531
Re: 2005 mazda 3 hit 50,000 [sawolf] by shipo
Oct 22, 2009 (8:37 am)
Reply

Replying to: sawolf (Oct 22, 2009 8:21 am)

Does your Owner's Manual spell out any special services for the 50,000 mile mark? If not then there's nothing you need to have done, errr, that is unless you've skipped some of the service events that were perscribed by Mazda for the pre-50,000 mile threshold.
 
Best regards,
Shipo
#4528 of 4531
Re: Engine ticking [chefjd] by ashmr20
Oct 22, 2009 (9:03 am)
Reply

Replying to: chefjd (Sep 19, 2009 5:30 am)

I had the same noise on mine diagnosed this week as a bad throtle butterfly. They took 3 weeks to figure it out and I still can't believe that's what it was; I was convinced the engine was about to throw a rod. at any rate, it was covered under warranty.
#4529 of 4531
2005 mazda 3i check engine light on by zippy12
Oct 22, 2009 (11:25 am)
Reply
Hi light is on car is running fine what could it be? I just bought car and had it checked out by garage had to get a new battery and smog check but that is it. I am now freaking out! help
#4530 of 4531
Re: 2005 mazda 3 hit 50,000 [sawolf] by autonomous
Oct 22, 2009 (2:22 pm)
Reply

Replying to: sawolf (Oct 22, 2009 8:21 am)

Have you tried Edmunds?
Go to Used Cars > Tips and Advice > Maintenance and you'll find recommended a schedule of maintenance that is quite useful.
#4531 of 4531
Re: 2005 mazda 3i check engine light on [zippy12] by roadburner
Oct 22, 2009 (5:40 pm)
Reply

Replying to: zippy12 (Oct 22, 2009 11:25 am)

Hi light is on car is running fine what could it be?
 
I could be any number of things; it's pointless to guess. Take it to Autozone and they will read the fault code(s) for you free of charge.

Messages Page 454 of 454
1
...
448
449
450
451
452
453
454
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement