Got a Quick, Technical Question?

4960 messages, Last post on Nov 25, 2009 at 8:23 AM

You are in the Maintenance & Repair Forum. Your Host is mr_shiftright

What is this discussion about? Brakes, Electrical, Engine, Exhaust

A Place to Post A Question That Doesn't Need a Discussion--Only One Quick Answer!

Outline

Messages Page 323 of 497: 1; ...; 320; 321; 322; 323; 324; 325; 326; ...; 497; Prev; Next; Last

#3215 of 4960 Bearing/Hub Assembly by codered Feb 16, 2007 (3:29 am)
hi i have a 1990 Chevrolet Lumina... i think i have a bad Bearing/Hub Assembly or drive axle...the car has humming sound when driving....sounds stops when wheel is yanked to the right....any info would be great thanks Replies to this message: qbrozen (Feb 16, 2007 6:29 am) codered (Feb 16, 2007 9:42 am)
#3216 of 4960 Re: Bearing/Hub Assembly [codered] by qbrozen Feb 16, 2007 (6:29 am)
Replying to: codered (Feb 16, 2007 3:29 am) quite possibly the bearing, yes. Replies to this message: codered (Feb 16, 2007 9:42 am)
#3217 of 4960 Re: Bearing/Hub Assembly [qbrozen] by codered Feb 16, 2007 (9:42 am)
Replying to: qbrozen (Feb 16, 2007 6:29 am) cool thanks thats what i was thinking also....thanks for help
#3218 of 4960 95 Chrysler Cirrus lx V6 auto isn't getting fire by mmlbow Feb 17, 2007 (9:18 am)
it turns over but isn't getting spark from either coil. Just replaced fuel pump and filter. don't know if it is the crank or cam sensor. any advice would be greatly appreciated
#3219 of 4960 braking noise by cole91 Feb 17, 2007 (7:56 pm)
03' F250 4x4 V8 - When I hit the brakes I hear a dull "dunk" and feel a vibration under the driver floor board. I have changed the callipor, pads and rotors. I have also checked the ball joints. Any advise on the next step? Need help!
#3220 of 4960 plug gap by rulover Feb 18, 2007 (12:05 pm)
I would like to replace my spark plugs but can't find the gap setting in the manual or on the hood of the car. have a 96 subaru legacy 2.2 L engine. Thanks in advance!!
#3221 of 4960 Pontiac Aztek - Can't remove ignition key by swissdude Feb 19, 2007 (9:13 am)
our trusty 2001 pontiac aztek has the following problem: we can't remove the ignition key. engine can be switched off, but lock won't go back to release position. this started happening out of the blue. is this the key itself, the lock or an electrical problem? Replies to this message: suvshopper4 (Feb 19, 2007 1:36 pm) ray80 (Feb 20, 2007 4:40 am) swissdude (Feb 20, 2007 6:32 am) and 2 more...
#3222 of 4960 Re: Pontiac Aztek - Can't remove ignition key [swissdude] by suvshopper4 Feb 19, 2007 (1:36 pm)
Replying to: swissdude (Feb 19, 2007 9:13 am) I gotta ask the obvious: Have you tried yanking the steering wheel to its most extreme position (left or right) while trying to remove the key? Is the shifter in Park? Hope this helps. Replies to this message: ray80 (Feb 20, 2007 4:40 am) swissdude (Feb 20, 2007 6:32 am) ray80 (Feb 20, 2007 6:37 am) and 1 more...
#3223 of 4960 Re: Pontiac Aztek - Can't remove ignition key [suvshopper4] by ray80 Feb 20, 2007 (4:40 am)
Replying to: suvshopper4 (Feb 19, 2007 1:36 pm) In addition to what suvshopper suggested, it could be a power problem if your battery is getting old, or possibly what I just went through with mine,,,,, the lock cylinder was appearantly partially froze and would not give key back until vehicle was very warm after running for a long time. In my case I still haven't fixed leaky sunroof issue so I have had considerable moisture build up in cabin (shifter also had issue being stuck in park for I guess same reason) and I ended ups letting it run for an hour or so with A/C on and heat on high with windows cracked (A/C turns compressor on which helps dry out air) Replies to this message: swissdude (Feb 20, 2007 6:32 am) ray80 (Feb 20, 2007 6:37 am) swissdude (Mar 01, 2007 12:24 pm)
#3224 of 4960 Re: Pontiac Aztek - Can't remove ignition key [ray80] by swissdude Feb 20, 2007 (6:32 am)
Replying to: ray80 (Feb 20, 2007 4:40 am) all - shifter is in park. - yanking on the steering wheel to no avail. - we were driving the car for 90+ minutes before this first happened, everything was running normally during this time. - in the position where the key is stuck, it appears that the battery is getting drained. - after a jumpstart of the battery, car comes on normally, except that the dash board now shows a 'SECURITY' warning. car's in the shop now, i'll let y'all know what the finding was. Replies to this message: ray80 (Feb 20, 2007 6:37 am) swissdude (Mar 01, 2007 12:24 pm)