Last post on Oct 28, 2013 at 1:21 PM
You are in the Lincoln Town Car
What is this discussion about?
Lincoln Town Car, Auto Body, Engine, Suspension, Sedan
#704 of 1123 Re: 1990 Lincoln Town Car [cwhitten]
Nov 29, 2007 (6:19 pm)
Hi my name is Al,,,,, If your car will only run or start when primming it, make sure someone did not shut the shut off gas switch in the trunk to the off position, if this in not the problem then try to turn key forward one click but not starting with no radio on and quiet around you and listen to hear if you can hear the pump in tank sending fuel up from tank, also you may want to change the fuel filter that is located at rear side of car it should only be about 30-70 bucks to replace if u do it yourself....also take off breather on carb hold open chock with screwdriver turn key forward and have someone hold down gas peddel to see or smell gas going into carb, if fuel injected hold down gaspedel to flood it out this will tell you that gas in reaching injection, if gas gets that far then it might need to have plugs remove cleaned or replaced. If this car has been sitting for 2yrs then you might want to siphin gas out of tank or put 10 bucks of gas with some stableizer in the container with new gas and try that as well,....good luck let me know if this helped thanks.... Al
#705 of 1123 lincoln town car wont shift into gear
Nov 28, 2007 (2:31 pm)
#706 of 1123 lincoln town car wont shift into gear
Nov 28, 2007 (2:31 pm)
I have a 1993 lincoln town car when i start the car in park and press on the break the gear shift will not let me put the car in drive,but if i turn the key in the auxillary postion i can put the car in nuetral and start the car then shift to drive.any help would be appreciated.
#707 of 1123 Re: lincoln town car wont shift into gear [vern1964]
Dec 04, 2007 (5:24 am)
If you touch the brake does the brakes lights come on? If so, either a brake light is out or more probably the brake switch on the brake pedal is not working. My 2K did the same thing. My money is on the brake switch is not working to disengage the gear shift. DO NOT FORCE THE GEAR SHIFT , it will cost more money to fix it.
#708 of 1123 Re: lincoln town car wont shift into gear [vern1964]
Dec 04, 2007 (8:47 am)
I had this same problem on my 2000 TC. The wire had burned off of the brake light switch. An easy fix. I just cut off the connector, and put regular spade lug crimp connectors on the wire and put the wires back on the lugs of the switch.
You can shift out of Park if you pull on the gear shift while starting as the lock will release while in the starting mode.
Dec 12, 2007 (8:29 pm)
Hi all, I have a '90 LTC. The brake lights are not working. I have taillights and signal lights just no brake lights. Checked the fuses, and bulbs everything is fine. Checked some forums and think it may be the brake light switch but I don't know where it is or how to fix it.
#710 of 1123 Re: No brake lights [altonfoster]
Dec 12, 2007 (10:17 pm)
Brake light switch is under the dash on the brake pedal. Most likley the wires are broken or burnt off.
#711 of 1123 1990 TownCar Overdrive is gone
Dec 13, 2007 (2:04 pm)
I have a 1990 Town Car and the overdrive is completely gone. When it tries to shift into overdrive its like you shifted into neutral by mistake. I am getting ready to take it into a trans shop and wanted some input. Rebuild? Easy fix? Any ideas?
#712 of 1123 Rattling under hood in air conditioning unit
Dec 13, 2007 (4:01 pm)
I have a 98 Lincoln TC and a couple of weeks ago an obnoxious rattle started under the hood. It seemed worse when the heater was on or the defrost. After about a week the Have Engine Serviced Soon light came on so I took it in. I took it in to a guy who works on air conditioning units and he says he thinks the compressor is going out so the whole unit will need to be replaced ($500). I think this guy is trustworthy but I just want to make sure other people think this is the route to go. He told me the belt runs the power steering and air as well as the water pump so when the belt gives, I will lose all that. Do belts go bad on their own and can you just replace a belt or does it sound like the whole unit needs replaced? Thanks so much for you help.
#713 of 1123 Re: No brake lights [adjuster]
Dec 24, 2007 (5:06 am)
i replaced the switch but the fuse keeps blowing and i cant se any bare wires or find a short?