- #703 of 744
-
2006 N AV CD PLAYER MALFUNCTIONING
by djackson13
-
Aug 02, 2009 (5:36 pm)
-
|
|
I have a 2006 Nav with just over 50k miles. For some reason the 6 disc changer has begun to malfunction. It will not accept CD's sometimes. It gives a message of "load error" when I try to load a CD. I tried brand new CDs so i know it is not the dics itself that is bad. Also, when I do get CDs the eject function sometimes does not work. When I hit eject, the Cd never comes out but the display indicates that the slot is empty. These issues usually reset themselves after a while but are very very aggravating. Anybody else had these issues? I am thinking that the dealer will repair under warranty but I was wondering if there was any quick fix for this besides taking in to the dealer.
|
- #704 of 744
-
Re: 01 navi shakes/wobbles [marissa1013]
by pepeispepe
-
Aug 14, 2009 (9:40 am)
-
|
|
Replying to: marissa1013 (Jul 24, 2009 1:52 pm)
Marissa, did you have a road force balance done? Shops like NTB or most gas station auto shops won't have the machine to do it, so try a performance shop. Specifically you are looking for a place with a Hunter Road Force Balancing Machine. This is different than a regular balance in that the wheels are balanced while they are on the car. That should take care of the shaking at higher speeds. As far as the lower ball joints, my 2000 Expedition went through them every 25K or so, I also had 22 inch rims, but it was not due to the rims at all, just a design issue by Ford. Not sure on the tie rod ends, in both cases I would get a second opinion before having them replaced. Good Luck
|
- #705 of 744
-
2002 lincoln navigator
by mariaestela
-
Aug 17, 2009 (11:19 am)
-
|
|
I have an 02 nav. that I purchased used in Dec 07. Since July 08 it has literally been in the shop every other month. I am so fustrated. I love my navigator until it acts up again. It is always the heater cooler that makes my navigator smell like fish, or the radiator. I just don't know if its the mechanics that don't know what they are doing or if i just bought a lemon. But I am tired of going to the shop everyother month. My extended warranty expires in Dec. 09. Any suggestions or is anyone else having problems with their 02 navigator like me?
|
- #706 of 744
-
04 Navigator gear shifter
by georgej2
-
Aug 17, 2009 (1:28 pm)
-
|
|
I pulled the gear shift lever up to clean the leather boot and now it will not go down and will not shift out of park
|
- #707 of 744
-
Re: 04 Navigator gear shifter [georgej2]
by dalesatter
-
Aug 17, 2009 (4:23 pm)
-
|
|
Replying to: georgej2 (Aug 17, 2009 1:28 pm)
It sounds like your shift knob came loose. The spring that works with the big chrome button on the knob has probably come out. You are going to have to dismantle part of your console to put it back together. You start by pulling the one plug on the backside of the window switch housing inside the storage bin and just under the console storage bin lid. After pulling that single plastic plug the switch housing pops off. Just grab it and pull up. Now you will see two screws that hold on the cup holder housing. Remove those and pull out the cup holder housing. Now you should be able to see the shifter mount. Pull the leather down away from the chrome ring below the shift knob. Pull the chrome ring down and you will see a screw or where the screw is supposed to be. It is probably gone but needs to be found or replaced. There is a small wire attached to knob and under knob is a spring that sits in the middle of the shifter shaft. There is a white plastic clip stuck up on the underside of the knob that needs to be pulled out with a little screw driver of something to get the silver plastic cap off the top of the knob. Put the spring back in place, it sets on top of the plastic shaft point up to the roof, so button works and reassemble. Make sure little wire running down the side of the shaft is still plugged in before you close it all back up.
|
- #708 of 744
-
Re: 2002 lincoln navigator [mariaestela]
by dalesatter
-
Aug 17, 2009 (4:33 pm)
-
|
|
Replying to: mariaestela (Aug 17, 2009 11:19 am)
The fish smell is debris that has collected from your vent intake and is decaying down inside. Do a search for Ford truck enthusiasts to ask for advice on how to clean it out. You can do most of the work yourself on these Navi's with a little advice. Good luck!
|
- #709 of 744
-
Re: Air Suspension [e_z_zeke]
by yolanda6
-
Aug 23, 2009 (8:31 am)
-
|
|
Replying to: e_z_zeke (May 22, 2006 5:29 pm)
i have a similar problem the back of my 00 navagotor has droped i took it to a machanic and was told that it needed a new compressor i replaced it at 500.00 dollars and still the problem is there i wish i can fix the problem soon i need it for many things and soon school will start and I have to take my children to school
please help me thank you
|
- #710 of 744
-
Re: Air Suspension [e_z_zeke]
by yolanda6
-
Aug 23, 2009 (8:33 am)
-
|
|
Replying to: e_z_zeke (May 22, 2006 5:29 pm)
i have a similar problem the back of my 00 navagotor has droped i took it to a machanic and was told that it needed a new compressor i replaced it at 500.00 dollars and still the problem is there i wish i can fix the problem soon i need it for many things and soon school will start and I have to take my children to school
please help me thank you
if you can please e-mail me with some kind of solution at ramirezy56 yahoo.com
thank you.
|
- #711 of 744
-
Re: Air Suspension [yolanda6]
by tidester HOST
-
Aug 23, 2009 (10:32 am)
-
|
|
Replying to: yolanda6 (Aug 23, 2009 8:33 am)
if you can please e-mail me...
We prefer to keep the discussion here so everyone can benefit.
tidester, host
SUVs and Smart Shopper
|
- #712 of 744
-
Re: 01 navi shakes/wobbles [pepeispepe]
by marissa1013
-
Aug 23, 2009 (11:06 am)
-
|
|
Replying to: pepeispepe (Aug 14, 2009 9:40 am)
Thanks I'll try that out. I already replaced the tie rods and it stopped the shaking for a month and here the past week it's starting to shake again not as bad but its doing it.I also have heard a popping noise when i turn either way, could that be my ball joints?..I'll have to find someone in louisville to have a Hunter Road Force machince.Thanks for your help!
|