- #385 of 436
-
Re: Coolant Leak 2003 CTS / Oil Cooler Seals [riskybusiness]
by scott1121
-
May 11, 2006 (1:54 pm)
-
|
|
Replying to: riskybusiness (Oct 05, 2005 11:33 am)
I have the same vehicle and just had my head gasket blow. I was sitting idle in traffic and all of a sudden the bells started going off and the computer screen said "Engine Overheating - Idle Engine". I put the vehicle in neutral and just as I did the bells when off again and this time the screen said "Low Coolant - Engine Overheating - Stop Engine". I immediately put the car in a parking space 6 feet away and turned off the engine. When I did, I heard a bubbling sound in the coolant reserve tank. I got out and on the ground was a huge puddle of milk-chocolate colored, milkshake thickness fluid. After towing to the shop, the initial diagnosis is blown head gasket - external failure. It just turned 100k miles last week and had all the service done as required on a 2003 CTS. Cadillac is refusing to help so far saying that since I have over 100k miles it's out of their abilty to assist, I have 101k miles not - come on guys. I'm going to have it towed to a Cadillac Dealer and have them tear it down and do a full diagnosis.
|
- #387 of 436
-
07 Escalade - 22" Wheel/Tire not available?
by auto007
-
May 12, 2006 (1:37 pm)
-
|
Hi,
Anyone have any ideas where to get 1 factory 22" Escalade 07 FACTORY wheel/tire? It appears according to my local dealer this is a special order item that takes 2 days to get updated on availablity that could be months?
It's hard to believe this and any insight on how to obtain it faster would be great!
Thanks
|
- #389 of 436
-
Re: Parking brake on 93 Eldorado [monkeyman3]
by 1993caddysts
-
May 18, 2006 (1:06 pm)
-
|
|
Replying to: monkeyman3 (Nov 26, 2003 8:34 pm)
Look under your dash, there should be a small handle just exposed beyond the driver kick panel. If may be sticky if its never been used.
Sometimes, I have found my brake will stick, try cycling the tranny between park and drive a few times.
|
- #391 of 436
-
engine swap]
by philly500
-
May 18, 2006 (5:56 pm)
-
|
|
Replying to: chuck46 (Apr 15, 2005 1:51 pm)
want to drop a big block olds in my 69 caddy conv is this possible i know my eldo had a 350 olds rocket the 472 in my caddy is a pain to get parts for and of course i threw a rod on sat any feedback would be very helpful
thanx
|
- #392 of 436
-
Re: engine swap] [philly500]
by Mr_Shiftright HOST
-
May 19, 2006 (10:01 am)
-
|
|
Replying to: philly500 (May 18, 2006 5:56 pm)
Doesn't make sense to me. You'll spend a lot of $$ getting everything to fit (it's not a common conversion after all) and you'll lose considerable value on your car to boot. And if you put an Olds 350 in there you will lose a LOT of horsepower (from 375 to 250). And if you use an Olds 455 you will gain but a few HP if you find the most powerful 455 (which will not be cheap to buy).
Sounds like a no win situation on all counts. Can't think of a good reason to do it---if I could, I'd tell you.
|