Sign In Join 



Lexus RX 330 Maintenance and Repair

1744 messages,  Last post on Dec 08, 2009 at 11:04 AM

You are in the Lexus RX 300/330/350 Forum. Your Hosts are steve_ & tidester

What is this discussion about? Lexus RX 330


Messages Page 2 of 176
1
2
3
4
5
6
7
...
176
Prev
Next
Last
Go To Msg #
Search This Discussion

#3 of 1744
Torque Converter Noise by tuomala1
Dec 02, 2003 (9:02 am)
Reply
My RX330 makes a slight clunking noise when it downshifts from 4th gear to third gear. It will also make the same noise if you lightly accelerate or decelerate whenever it is in 4th gear. It is most noticeable at speeds between 30 to 45 mph. Dealer says it's normal noise from lockup torque converter. The RX330 loaner I used didn't do it and mine didn't until I put about 4000 miles on the car. Anybody else experienced this problem?
#4 of 1744
Transmission slipping and clunking by jabba
Dec 10, 2003 (10:07 am)
Reply
My RX330's transmission slips between 1st and 2nd gear. Sometimes it stays between gears a full 2 seconds. I also get the clunking noise during downshifts. The dealer says this is normal for this design. I say very poor design especially for this price range. The slipping started when new. The clunking started a little later. I now have 7,000 miles on the vehicle.
#5 of 1744
Transmission slipping and clunking by tvkw
Dec 10, 2003 (10:54 am)
Reply
Will Lexus fix this problem? I am considering to purchase one, but if there is a flaw on the design, I may think twice. When is your build date?
#6 of 1744
Transmission slipping and clunking by chitung
Dec 10, 2003 (4:19 pm)
Reply
My RX330 is closed to 5K service and I am having problem with the transmission and noise.
 
Transmission:
- Slow shifting between gears
- Two seconds delay shifting between 2nd and 3rd
- Two clunking noise when approaching stop.
- When driving between 5-10mph, tapping the gas pedal a little bit will make the clunking noise.
 
Noise:
Toyota is trying to cut cost on parts and labors:
- Use plastic intake manifold instead of cast aluminum (RX300) -> Noise from combustion chamber will be heard easier. That's why so many owners complain about louder engine noise.
- Less insulator material between engine compartment and the cabin.
 
Cost cutting: Use only one hydrolic lift for the hood instead of two (RX330). This helps Toyota cut cost and time to install.
 
I am not happy about this car because the noise level is quite high and transmission is not smooth. The car is not quite as others said.
#7 of 1744
To all with transmission issues by lovemylexus1
Dec 10, 2003 (6:24 pm)
Reply
Have any of you had the ECM update performed on your transmission? I had similar complaints with slow shifting and what felt like slipping gears. I had the ECM update done at the 1000 mile service and now the transmission acts like I expect it to: smooth.
 
The Technical Service Bulletin (TSB) number is: TC005-03
#8 of 1744
tvkw - Ted by myk_a
Dec 11, 2003 (11:53 am)
Reply
I'm not sure but it may be that this issue affects only specific models from Japan. I got mine on Nov. 1st from North America (Canada) and I haven't had any such issues. Then again, I've only got 2500 miles on it.
#9 of 1744
Coin Holder? by milkchug
Dec 11, 2003 (1:21 pm)
Reply
I have one major issue with this car. Is it just me or is there no coin holder in this vehicle? I have been pulling my hair trying to find anywhere to put coins. The center console is not a good place because I can't find anywhere stable to put it.
 
Thanks.
#10 of 1744
Coin Holder by lovemylexus1
Dec 11, 2003 (7:35 pm)
Reply
I hope Lexus remembers the coin holder in the next model!
 
I carry my sunglasses in my purse so I have no use for the overhead sunglasses case in the RX . So, I bought a small coin purse that will fit into the overhead sunglasses holder. Not perfect but it works.
#11 of 1744
Coin Holder and ECU program updated today by chitung
Dec 11, 2003 (11:42 pm)
Reply
Toyota might thought that Lexus buyers are rich and having only bill/check/credit card. Coins are thrown into charity box. Coin holder should be only exist in economy car. Just kidding.
The only place I can think of is the door handle slot where you your fingers place while closing the door.
 
My car was built in Japan Aug 03 and I just had ECU program updated today. The shifting is improving quite significantly from 2nd to 3rd. Overall, it's quite satisfying.
 
The only annoying thing left for me to solve is the engine noise. I am going to buy some sound deadening material to suppress sound coming into cabin. The reason the engine noise is excessive is the INTAKE MANIFOLD IS MADE OF PLASTIC/FIBER for this model. It is used to be made of cast aluminum which reduced the combustion noise significantly.
#12 of 1744
Coin holder by scodiana
Dec 11, 2003 (11:45 pm)
Reply
I saw something online that's a coin holder that's shaped to fit into the cup holder.
 
I wish I could remember where I saw it.
 
My breakwater blue RX was finally delivered today (a three week wait for it to be moved from Washington State to the Bay Area). I put my coins on end into that slim holder in the center console - between the two smaller containers and the large one.
 
Sheri

Messages Page 2 of 176
1
2
3
4
5
6
7
...
176
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement