768 messages,
Last post on Feb 24, 2012 at 7:03 PM
You are in the
Mazda B-Series Forum.
What is this discussion about?
Mazda B-Series Pickup, Mazda B-Series Truck, Truck
#759 of 768 Re: 92 b26001 4x4 transfercase Q's please help [tuffy4]
by munch3
Jul 16, 2010 (9:20 pm)
Do you still have the clanging problem in 4 hi? I have the same truck but it's an automatic and on 2 occasions have had a similar problem. Both times it was in cold weather. I noticed that your post was in February. I'm wondering whether some part of the linkage, maybe part of the remote free wheel system is icing up and preventing the mechanism from fully engaging.
#760 of 768 Mazda B Series
by maxy2
Jul 17, 2010 (2:32 am)
Mazda B series are based on the ford ranger but sadly it didn’t work out on the market.
#761 of 768 ECU question (1992 Mazda B2200 Sport fuel injected)
by ronart
Sep 16, 2010 (9:09 pm)
ECU question (1992 Mazda B2200 Sport fuel injected)
Though I have read on a few forums that people have replaced their ECU... I have not read that anyone suggests performing specific tests BEFORE installing the ECU.
The reason I am concerned is that I received back an ECU that stated that the solenoids/relays must have a resistance value of no less than 20 ohms or it could damage the ECU.
I called Mazda about this and they seemed clueless, but... they said that they do perform tests on the connector to see if there are any shorts, etc. prior to installing the ECU (so I assume this is probably what it is).
Mazda also said that they MUST reprogram the ECU after it is reinstalled for it to function properly.
No where have I read that this is necessary.
Mazda said that they charge $99 to 'reprogram' the ECU and if they have to diagnose it after that it would be an additional $99.
Does this seem correct or are they doing things that are unnecessary?
Any advice would be greatly appreciated.
Regards,
Ron
#762 of 768 Re: B 2300 [wkdf]
by bbowen53
Oct 10, 2010 (7:15 pm)
what gas mileage should I get from a 1996 Mazda B2300 4cyl. auto with air?
#763 of 768 94 Mazda B4000 4x4 Check Engine/Check Oil Lights?????
by dbailey
Oct 21, 2010 (10:58 am)
Guys I gotta major amount of confusion and need some assistance. For awhile there the check engine light was coming on and I forget what I did if anything to get it to stop. Now the check oil light comes on sometimes and it is full of oil and I change it every 3000 miles. I have the 4.0 engine and 5 speed tranny. Any suggestions? Thanks.
#764 of 768 Re: lonny [lonny]
by kenter50
Jan 03, 2011 (8:47 pm)
your still paying too much for it, buy a used one for 5000 less still under warranty save ten thousand $'s over 10yrs.
#765 of 768 Re: 94 Mazda B4000 4x4 Check Engine/Check Oil Lights????? [dbailey]
by kenter50
Jan 03, 2011 (8:48 pm)
unhook your batry 4 an hr and then rehook it up
#766 of 768 B300 - Sequences of dings???....What does this mean?
by nbunte43
Dec 06, 2011 (11:22 am)
As soon as I start my truck and engage it into drive or reverse the truck begins to do a sequence of dings. It makes 5 dings then after about 5 seconds it begins another set of 5 dings. It does this sequence for five sets of five dings. Then after 30 minutes of driving it does this same sequence again. The truck does not show any check engine lights or anythign like that. This is quite annoying! Any help would be much appreciated. THANKS!!
#767 of 768 Re: B300 - Sequences of dings???....What does this mean? [nbunte43]
by nbunte43
Dec 06, 2011 (11:23 am)
BTW...the truck is a 1999.
#768 of 768 Service Bulletin 0500402; 1999 Mazda B2500
by snyderlite
Feb 24, 2012 (7:03 pm)
SERVICE BULLETIN REGARDING A HOOTING, EEKING, OR MOANING NOISE COMING FROM THE CLUTCH WHEN SHIFTING INTO GEARS. Any ideas ?