Sign In Join 



Nissan Pickup Owners Hangout

644 messages,  Last post on Dec 01, 2009 at 10:43 AM

You are in the Nissan Titan Forum. Your Host is kcram

What is this discussion about? Nissan Pickup, Nissan Frontier, Nissan King Cab, Nissan Titan, Truck


Messages Page 64 of 65
1
...
59
60
61
62
63
64
65
Prev
Next
Last
Go To Msg #
Search This Discussion

#630 of 644
Weird noise by restin84
Jun 15, 2009 (4:11 pm)
Reply
Got a thumping/clicking noise when the steering wheel is locked going in reverse. Any thoughts on what it may be?
#631 of 644
Re: Weird noise [restin84] by obyone
Jun 17, 2009 (9:34 pm)
Reply

Replying to: restin84 (Jun 15, 2009 4:11 pm)

Thumping/clicking? I'd be more concerned that your car can move in reverse with the steering locked.
#632 of 644
Re: Funny Noise [restin84] by juumpmaster
Jul 02, 2009 (4:40 pm)
Reply

Replying to: restin84 (Jun 15, 2009 12:45 pm)

I have a 95 4WD, 6 cyl. Had the same problem, always thought it was coming from front, or sound being transmitted to the center or rear. Checked front end,
drive shaft and everything else I could thing of. After taking it to several Mechanics, had all kinds of answers, rear end mostly. On many occasions I would
go to a Mechanic and could not duplicate the noise. One last resort, I drained the rear end and replaced the fluid. Checked the book to might sure I was using the right type, think mine was a non slip differential. Low and behold never heard the noise after that. Now it could have been low to start with, or when I had work done on it and the drained the rear end, they may have replaced the fluids with the wrong type. Just like yours, only did it in the turning position and especially when backing up.
#633 of 644
Re: Weird noise [restin84] by juumpmaster
Jul 02, 2009 (4:44 pm)
Reply

Replying to: restin84 (Jun 15, 2009 4:11 pm)

Steering wheel locked, no mine was not in the locked position when I had the problem, but I was turning the wheel sharply, kinda thought this is what you meant.
#634 of 644
1983 nissan lights by 83nissan
Jul 31, 2009 (3:01 pm)
Reply
hi i have an 1983 nissan pickuptruck and i am new to nissans and my headlights don't work. i have tested all of them and they all work but they whon't work on the truck. all the other lights work(rear lights, signal lights, side markers, dash lights, interior light(which doesn't turn off). and i have a problem with the engine. it will run but when i quickly add the gas it bogs and dies, and it doesn't idle. the gas line is all rusted so i replaced it but it has a diffrent pump, the pump is from a suzuki samuri.
#635 of 644
95 Nissan 4x4 V6 by snowflake3
Oct 27, 2009 (1:47 pm)
Reply
Earlier this summer I was hit in the passenger side rear end of my truck. The insurance company decided to total it. I am wondering if anyone knows what other years of the hardbody have interchangeable under carriage parts, specifically the leaf springs, shocks, axle and housing. Thanks for your time.
#636 of 644
ignition chime by fpina25
Oct 29, 2009 (9:19 am)
Reply
I have a 95 nissan pickup extended cab,
when I remove the key from the ignition the chime stays on, I have to tap the ignition once or twice to get the chime to turn off. What could this be? I have checked the wiring and fuses, they are all good to go. stumped!
#637 of 644
Re: ignition chime [fpina25] by obyone
Oct 29, 2009 (8:41 pm)
Reply

Replying to: fpina25 (Oct 29, 2009 9:19 am)

bad ignition switch
#638 of 644
cooling prob by chefdan
Nov 01, 2009 (10:08 am)
Reply
I have a 91 nissan pickup 2x2 ,this past summer it started overheating. I checked the radiator and discovered a small hole. A friend of mine gave me some radiator stop leak and since we were at his house we just put water in it. now last month I realized that I forgot to put the antifreeze in and the water froze up. I removed the radiator and thawed it out and replaced. I went to flush out all the crud left in the motor and discovered that I have a manufactured hole without a plug. I found the plug and the hole is on the left side of the block under the aircleaner and carb. Does anyone have any bright ideas on replacing it with out removing the carb and stuff?
#639 of 644
Re: cooling prob [chefdan] by asa
Nov 03, 2009 (5:07 pm)
Reply

Replying to: chefdan (Nov 01, 2009 10:08 am)

Is it a 'freeze plug' on the side of the engine block that you have found? These are engineered to pop so that ice in the cooling system doesn't crack the block. You can purchase a replacement, but you'll need to carefully and squarely drive it in with a hammer and driver and you'll need some room to do that.

Messages Page 64 of 65
1
...
59
60
61
62
63
64
65
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement