You are here: Forums Coupes & Convertibles Chrysler Sebring Chrysler Sebring Convertible

Chrysler Sebring Convertible

382 messages,  Last post on Dec 03, 2008 at 7:48 AM

You are in the Chrysler Sebring Forum. Your Host is claires

What is this discussion about? Chrysler Sebring, Convertible

Messages Page 39 of 39 1 ... 33 34 35 36 37 38 39 Prev Next Last

Go To Msg # Search This Discussion

#373 of 382 car cover. by mumble88 Sep 16, 2008 (1:52 pm)
I got a chrysler 300C and i was just wondering if the cover will damage my paint by any chance. Becuz I got myself a new cover for my car from carscover.com and just worried that it might scratch my paint and i really don't want to see that happen to my car.
#374 of 382 Re: Tachometer and Odometer problems [mcginty1] by jav008 Oct 06, 2008 (11:04 pm)
Replying to: mcginty1 (Jan 06, 2008 9:10 pm) HI: I had the same problem with the odometer, however I got it fix by a help of some friends, I will give you the link and follow the instructions. It will work I haven't had a problem since. http://members.cox.net/dpeters30/97_sebring_dash.htm have a nice day
#375 of 382 Re: Tachometer and Odometer problems [bogie01] by isaachernandez Oct 07, 2008 (11:29 pm)
Replying to: bogie01 (Feb 23, 2008 2:21 pm) I am new to forums and new to this one. The reason for mounting resistors close to the circuit board is to draw heat away from the resistor using the circuit board to dissipate the heat. It is not a good idea with ceramic resistors (which tend to run fairly hot) and not with cheap circuit boards. The combination is trouble with a capital T. Your fix seems sound as long as the resistor doesn't end up near plastic.
#376 of 382 Re: Convertible top slow to close! [ohldepharte] by isaachernandez Oct 08, 2008 (12:07 am)
Replying to: ohldepharte (Sep 29, 2005 8:35 am) I know that you posted in 2005 but I am faced with the same problem now. What was the fix? If there is a reservour, where is it and did your system just need a good burp?
#377 of 382 Re: Convertible top slow to close! [mlcryslr] by hartinger Oct 14, 2008 (7:43 pm)
Replying to: mlcryslr (Jun 15, 2005 9:55 am) I have a 1998 Sebring Convertible who's top is not coming up without help. The dealer say's the fluid has leaked out and to replace the pumps and motor (which are still working). Have you received any replies to your problem. Is there a way to fill the system without replacing ? Thanks Ron Replies to this message: isaachernandez (Oct 16, 2008 11:34 am) isaachernandez (Oct 19, 2008 12:50 pm)
#378 of 382 Re: Convertible top slow to close! [hartinger] by isaachernandez Oct 16, 2008 (11:34 am)
Replying to: hartinger (Oct 14, 2008 7:43 pm) Ron, I have not received any replies. I just checked the fluid level at the pump in my car and it looks plenty full. I was thinking that a place that specializes in hydraulics might have a better way to burp the system and/or find leaks. The reservoir may not be higher up than the rest of the system. Before getting too involved, I lubricated all the joints with a spray lubricant. My personal choice was white grease. It worked for a few months then the problem came back. In my 2002 the motor/reservoir is behind the rear seat. The seat bottom pulls straight up from the front and easily pulls forward and out. The rear is easily pulled up and out after removing the two nuts (17mm) that hold the seat belt/lower bracket plate in the center of the backrest on the floor. I also removed the two bolts (T50) that secure the seat belts to the floor at each end. I will keep you posted. Isaac Replies to this message: isaachernandez (Oct 19, 2008 12:50 pm)
#379 of 382 Re: Convertible top slow to close! [isaachernandez] by isaachernandez Oct 19, 2008 (12:50 pm)
Replying to: isaachernandez (Oct 16, 2008 11:34 am) Ron, try this link: http://www.sebringclub.net/board/viewtopic.php?f=37&t=13394&p=136169&hilit=hydra- ulic#p136169   Good luck, Isaac
#380 of 382 Press Request by KarenS HOST Oct 28, 2008 (9:52 am)
An advertising agency would like to speak with satisfied Chrysler Sebring drivers. If you own or regularly drive one of these vehicles, please respond to jwahledmunds.com with your daytime contact information no later than Friday, October 31st.
#381 of 382 Major Electrical Problem 2005 Sebring Convertable by sebringpat Nov 04, 2008 (12:38 pm)
I have a 2005 Sebring Convertable that developed the following: The Auto headlight switch stopped working, except when the car is shut off than the lights come out and will go out automatically. The convertable top switch stopped working so I can not use the top. The heated seats stopped working and the Auto heat also stopped working. It is at the dealership now and has been all day and they do not have a clue what is wrong (at $98 an hour). Has anyone experianced this problem or any part that I discribed, it would be helpful.
#382 of 382 1998 chrysler sebring 2.5 v6 by wesley07 Dec 03, 2008 (7:48 am)
I have a 98 convertible and having serious problems with it. It has been at the dealership for 3 weeks and they cant figure it out! When you first start the car after sitting over night it will run just fine for about 5 min. then when you give it gas it stalls and wants to die. It will sit and idle but when you give it gas it stalls and dies! It will drive down the road at about 15 mph but give it anymore gas than that it stalls and dies if you dont let off of it! They have replaced (so far) MAP sensor, fuel pump and filter, catalytic converter, fuel line that was bad, nothing has worked. It is showing no codes, dealership says now they do not know what is wrong! Can anyone help?? They are now leaning towards the distributor???

Messages Page 39 of 39 1 ... 33 34 35 36 37 38 39 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Coupes & Convertibles Chrysler Sebring Chrysler Sebring Convertible