Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
SUVs GMC Yukon GMC Yukon and Yukon Denali Problems
779 messages, Last post on Oct 31, 2009 at 6:36 AM
You are in the GMC Yukon Forum. Your Hosts are steve_ & tidester
|
|
|---|---|
Has anyone had this problem with their liftgates. I can lock the doors with the remote or from the inside of the truck but the Lift Gate and the Lift Window will not lock. Can anyone help.
|
|
|
Replying to: thatworks (Apr 15, 2008 10:41 am)
|
|
I have a 2003 GMC Yukon Denali with 95k miles and for the past 2-3 years I have had to replace the rear pads and rotors several times, they last 4-5 months each time.... The front ones are fine... I tried several different aftermarket. What could be causing them to go bad so quick all the time?
|
|
|
Anyone have any good advice for better brake pads for my 2008 Yukon XL Denali? Braking can be best described as weak. I will be towing a 3000# boat in about 3 weeks on vacation and I want to upgrade to better pads with better grip so I can stop this sloppy driving SUV before plowing into the car in front of me. Thanks. |
|
|
Replying to: umoms (Jun 28, 2008 9:58 am) In my opinion there are several possible reasons, assuming in the 4-5 months of time you have only driven a few thousand miles (say ~6K to 7K): 1. Have been using bargain pads and rotors... ??? 2. Caliper Pins/Slides were not properly (or not at all) lubricated, which caused the pads to stick to the rotors. 3. Have been using old/rusted brake pad retainers, could potentially cause the pads to stick too... 4. Bad caliper or caliper piston, does not release/retract properly even when the brake paddle is off. 5. I assume it not the ABS or the Master Cylinder, as you mentioned the front brakes are just fine... Hope you find the real cause of this problem soon. |
|
my 2004 yukon denali has a problem with the drivers side heated seat they come on and go off automatically its been to the dealer 3 times and they still cannot fix the problem any suggestions?
|
|
|
Replying to: ice100 (Jul 01, 2008 3:40 pm) If it turns off immediately after you turned it on, then there may be an over load to the Heated Seat Element, perhaps an electrical short of some kind...? Once in a long long while, it could be related to a faulty Heated Seat Switch... If the seat does get to heat up, but only stayed on for a short time, then there may be an issue with the temperature sensor, or may be the Climate Control Seat Module itself is faulty... A lot of guesses here, I hope your dealer knows better to check all these components at the least. Best Wish! |
|
I have a 2000 Denali and it has started making a terrible ticking noise. When I start the rig it is much louder and more intense but then it seems to settle down and find a steady grove of ticking. Does anyone know what this could be caused by and how much its going to cost me to fix it? Is this a common problem with Denali's?
|
|
|
|
|
Replying to: kendog2 (May 14, 2008 10:57 am) |
|
|
|
|
Replying to: kdemello (Jul 05, 2008 9:27 pm) |
|
You are here:
Forums
SUVs GMC Yukon GMC Yukon and Yukon Denali Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2000 GMC Yukon Denali
Browse by Board
Browse by Topic
Today's Chats
