You are here: Forums Sedans Ford Fusion/Mercury Milan Ford Fusion/Mercury Milan

Ford Fusion/Mercury Milan

5511 messages,  Last post on Nov 11, 2009 at 9:26 AM

You are in the Ford Fusion/Mercury Milan Forum. Your Hosts are pat & karens

What is this discussion about? Mercury Milan, Ford Fusion, Sedan

Messages Page 497 of 552 1 ... 494 495 496 497 498 499 500 ... 552 Prev Next Last

Go To Msg # Search This Discussion

#4956 of 5511 Re: Replacing mirror - discount parts site? [rj123456] by akirby Aug 27, 2007 (4:52 am)
Replying to: rj123456 (Aug 26, 2007 10:49 pm) There should be one screw in the bottom of the door pull, one or two around the bottom edge and maybe one near the latch. The rest are clips that just pop out.   I've always used Team Ford in Las Vegas for internet parts purchases. Check with Bill Jenkins - great prices and great service.
#4957 of 5511 Internet Parts by mschmal Aug 27, 2007 (6:34 am)
Only franchised dealers are permited to sell Genuine FLM parts.   All dealers pay the same for parts.   If you get a good quote online, take it to your local dealer and see if they will match it.   Mark.
#4958 of 5511 Re: 'auto-lock' feature [akirby] by green2go Aug 27, 2007 (10:21 am)
Replying to: akirby (Aug 08, 2007 5:28 am) The Fusion was my first domestic car in a while. On balance, I love the auto-lock feature -- it's one of several that make feel like the car is considerate and is looking out for me. Every so often it can be annoying to have to unlock all the doors after a quick trip, but mostly it works smoothly and intuitively and I think it's an important security feature.
#4959 of 5511 Auto Lock by mschmal Aug 27, 2007 (11:30 am)
2006 Fusions allowed you to turn Auto lock and Auto unlock on/off through the info center. These seems to be missing on 2007 Fusions   Auto Unlock pops the rest of the door locks when the driver opens his/her door. Replies to this message: wblake99 (Aug 27, 2007 5:35 pm)
#4960 of 5511 Re: Auto Lock [mschmal] by wblake99 Aug 27, 2007 (5:35 pm)
Replying to: mschmal (Aug 27, 2007 11:30 am) My 2007 Milan built in March of this year has that feature. I don't think it is availble with a manual trans, however.   If I remember right the Message Center has no controls for this function so it must be 'programmed' by one of those turn the key, then off, then stand on your right foot while touching your nose with your left hand type of situations.   I'm sure it is all in the owner's manual, but the dealer asked me if I wanted it on or off so they would know whether to go through the process to turn it off.   On my 2006 Mountaineer it is in the setup menu on the Message Center and is easy to turn on or off.
#4961 of 5511 Re: Replacing mirror - discount parts site? [rj123456] by rj123456 Aug 28, 2007 (8:34 pm)
Replying to: rj123456 (Aug 26, 2007 10:49 pm) Btw, is the mirror easy to replace as a DIY? Does anyone have instructions or gotchas to share?   Thanks in advance! Replies to this message: dtownfb (Aug 30, 2007 11:46 am)
#4962 of 5511 Re: Replacing mirror - discount parts site? [rj123456] by dtownfb Aug 30, 2007 (11:46 am)
Replying to: rj123456 (Aug 28, 2007 8:34 pm) I replaced my mirror on my Olds Intrigue. Very easy to do. Most cars are similar. The key is finding the location of the screws, normally 2 or 3. One is normally "hidden" on the inside latch. Then it is a matter of using a screwdriver or knife to pry the door panel from the frame. Once the panel is off, unplug the electrical connector and unscrew the mirror. Then do it in reverse to install the new mirror. it will tkae you 15 minutes, start to finish. Again the key is finding the screws to undo the door panel.   Good luck.
#4963 of 5511 2009 Ford Fusion by jaxs1 Oct 28, 2007 (3:33 pm)
It's supposed to get a styling update and available stability control. Maybe the 3.5 V6 will be available.   I wonder if it will get this new Ford design element?     Replies to this message: akirby (Oct 28, 2007 4:21 pm) jaxs1 (Oct 28, 2007 5:01 pm) akirby (Oct 28, 2007 5:08 pm)
#4964 of 5511 Re: 2009 Ford Fusion [jaxs1] by akirby Oct 28, 2007 (4:21 pm)
Replying to: jaxs1 (Oct 28, 2007 3:33 pm) The 3.5 will be available but it's not clear whether the refresh will appear next year or the year after. Probably won't know for sure until LA or Detroit Auto Show. Replies to this message: jaxs1 (Oct 28, 2007 5:01 pm) akirby (Oct 28, 2007 5:08 pm)
#4965 of 5511 Re: 2009 Ford Fusion [akirby] by jaxs1 Oct 28, 2007 (5:01 pm)
Replying to: akirby (Oct 28, 2007 4:21 pm) ???   http://www.autosavant.net/2007/09/predicting-2009-fusion.html   Replies to this message: akirby (Oct 28, 2007 5:08 pm)

Messages Page 497 of 552 1 ... 494 495 496 497 498 499 500 ... 552 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Sedans Ford Fusion/Mercury Milan Ford Fusion/Mercury Milan