You are here: Forums SUVs Nissan Murano Nissan Murano Maintenance and Repair

Nissan Murano Maintenance and Repair

2175 messages,  Last post on Nov 19, 2009 at 1:19 PM

You are in the Nissan Murano Forum. Your Hosts are steve_ & tidester

What is this discussion about? Nissan Murano

Messages Page 217 of 219 1 ... 213 214 215 216 217 218 219 Prev Next Last

Go To Msg # Search This Discussion

#2154 of 2175 Re: 2003 Nissan Murano [easym1] by tidester HOST Aug 12, 2009 (9:47 pm)
Replying to: easym1 (Aug 12, 2009 7:47 pm) Yes, pressure varies directly with temperature, provided neither the volume nor density of the gas changes! However, the original problem was that the pressure reading did not change with temperature. That's why a faulty pressure sensor was suspected.   tidester, host SUVs and Smart Shopper
#2155 of 2175 Service Maintenance CD by kathiel Sep 12, 2009 (8:31 pm)
Still suffering along with our 2003 murano, can't afford to unload it. Do any of you have experience with the CD maintenance computer program for troubleshooting the murano. I see that there are several available via ebay and was wondering if anyone has actually used one? if so, what's the best? Appreciate any help. Thanks.
#2156 of 2175 Car slide backward on a slop by goodays Sep 15, 2009 (7:02 am)
I just bought a Murano 2009. I found it will slided backward on a slight slop even the shift is at forward position.   There is a slight slop in front of my garage. Yesterday drove back to home. I first stepped on the break to wait for the garage door to open. When I released the break, the car start to slide backward. I used my another car Lincoln Zephyr to test in the same situation, and it went forward without accelerating.   I'm wondering if this is a big problem or all Murano will do same. Replies to this message: raj29 (Sep 21, 2009 11:59 pm) jenahl (Oct 17, 2009 5:53 am)
#2157 of 2175 Nissan Murano S FWD 2005YM by raj29 Sep 21, 2009 (12:27 pm)
Can any one guide me with the following issues which i experience from my Murano...   1)low pick up (when the car run over a speed breaker and then applying gas/when slow down and den give gas) 2)hissing noise when applying gas similar to leakage on exhaust 3)feel roughness especially when car is driven immediately after starting 4)charcoal smell occassianlly especially when a/c switch on for out flow of air 5) Service Engine signal comes often and goes off. Error code 0442/0455 diagnosed and was reset earlier by the dealer. 6) Rattle noise on the driver side dash   If any one could guide me what is the issue, i would appreciate. Thanks,Raj 6)
#2158 of 2175 Re: Car slide backward on a slop [goodays] by raj29 Sep 21, 2009 (11:59 pm)
Replying to: goodays (Sep 15, 2009 7:02 am) Hi Goodays,   I too had experienced a similar incident but just the reverse of what u had experienced...My office has a basement parking. The slope to the basement is very steep. I parked the car near the parking entrance and used the remote (swap) and moved forward towards the bar.. however it didnt open..when i put the reverse gear (R) and lifted my leg from brake the car rolled towards the entrance instead of moving backwards and i really got scared... I checked with the dealer who had no answer to my question...
#2159 of 2175 Re: Car slide backward on a slop [goodays] by jenahl Oct 17, 2009 (5:53 am)
Replying to: goodays (Sep 15, 2009 7:02 am) My 2007 Murano has been doing the same thing since new, took it to the dealer and they said that it's normal to experience a slight rollback when on a slope. So far no problems at all with the Murano at a solid 90 000 miles of hard driving.
#2160 of 2175 Tie Rod Ends by gooddriver Oct 23, 2009 (4:13 pm)
I see that there is no discussion of tie rod ends failures. Has anyone had any premuture failure of tie rod ends on Muranos? I have a 2004 with 52K mile. I had to replace both outer tie rods last month. Could this failure be due out of balance ties that was insatlled on my car 11 months ago at BJ's? I took it back four times and finally gave up. I just took the car in for tire rotation at another BJ's and sure enough they were all off, apparently the store which installed the tires did not know how to balance the tires. Long story but I won't go there. Anyone else with tire rod ends problems? Replies to this message: ljette (Oct 24, 2009 6:57 am)
#2161 of 2175 Re: Tie Rod Ends [gooddriver] by ljette Oct 24, 2009 (6:57 am)
Replying to: gooddriver (Oct 23, 2009 4:13 pm) I have an '05 Murano. I haven't had to replace tie rods, but I have had to replace wheel bearings on both sides. I have 95,000 miles. This is an expensive car to maintain.
#2162 of 2175 2004 Murano will not start – dealer cannot figure it out by bestforless Oct 25, 2009 (9:49 am)
I bought a used 2004 Murano with 53K miles 6 monthes ago I have now 63K miles Last month I replaced the battery and door actuator. On Monday noon the car did not start. Engine cranks but it doesn’t start. I had the car towed to Goodyear. The mechanics had worked on all my cars and are trsuwordy. They couldn’t figure it out. They tried different spark plugs and remove the catalytic converter. Engine compression is good No computer error codes. They can start the car with 2 spark plus in. If they covet the spark plugs or add another plug in doesn’t start. They suspected a computer module but cannot get one with the option to return it. They had it towed to Nissan. The dealer did the same tests and is at a loss. Their mechanic worked on it for 2 days and call Nissan CA. They told him that they cannot help him. The dealer said that he cannot just replace the main compute since he is not allowed to put it back in stock. They called other Nissan dealers to see if they have a 2004 Murano to “borrow” the computer and try it No one has one in the Atlanta area He doesn’t think it is the computer since there are no error codes. The only error code is CVT related and he thinks that the error has nothing to do with the problem, since the engine has to run in order to test the CVT. They said that they don’t know what to do! They want to try replacing the computer (at a $1000 cost to me) weather it resolves the issue or not. If it doesn’t work, he wants to try to put in a new harness at a $3600 cost and if it doesn’t help a new engine. They said that they had never seen this problem.  They can start the car with 2 spark plugs, but covering the spark plugs or adding another one and the engine dies. It looks like back pressure but he removed the catalytic convertor. Any suggestions ?
#2163 of 2175 Re: hydroplane [kattrent] by judem Oct 28, 2009 (8:21 am)
Replying to: kattrent (Jun 26, 2007 7:45 pm) I realize your message is old, but I still want to comment. I am so sorry for the 3 teachers. I just bought my '05 Murano from my sister and have had serious hydroplaning problems, even driving 23-30 MPH, particularly when the pavement is smooth and there is some standing water. Although my tires still have reasonable tread, I plan to replace them and am looking for the most reliable tires for this SUV. I too am interested to hear if anyone else has this problem. Ny Murano is NOT AWD, which may be the issue. Replies to this message: jayrider (Oct 28, 2009 12:36 pm)

Messages Page 217 of 219 1 ... 213 214 215 216 217 218 219 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Nissan Murano Nissan Murano Maintenance and Repair