Last post on Nov 25, 2002 at 9:14 AM
You are in the Maintenance & Repair - Archived Discussions
This discussion is ARCHIVED. To reactivate the discussion, post a request in the Lost? Ask the M&R Host for directions! discussion.
What is this discussion about?
Ford F-250, Engine, Truck
Nov 24, 2002 (7:52 am)
Are you serious??
sounds like an eight hour job!
#9 of 16 isell........
Nov 24, 2002 (8:32 am)
Pretty close call, Mitchell time is 6.5 hours. That's assuming everything goes like clockwork and every fastener comes out without breaking, seizing or otherwise screwing up your day.
Nov 24, 2002 (11:21 am)
I had no idea it was a 6.5 to 8 hour job to change the pan!!! Maybe I'll try to find someone to braze it, if that doesn't work I'll farm it out to someone with more than the limited backyard mechanic skills that I have. I assume it had rust pinholes and someone did a terrible weld job on it. THANX
#11 of 16 oil pan leaks
Nov 24, 2002 (2:03 pm)
as a preventative measure,when i see rust blistering on the pan i smear a little grease on it.the silicone sealant used as a gasket does a terrific job but oil pans seem to rust out as a result.
Nov 25, 2002 (9:14 am)
All flames have been deleted as well as responses to those flames. Notices going out later.
thank you, enjoy the discussion.
Shifty the Host