You are here: Forums Coupes & Convertibles Chrysler Crossfire Chrysler Crossfire

Chrysler Crossfire

1519 messages,  Last post on Nov 21, 2009 at 7:29 PM

You are in the Chrysler Crossfire Forum. Your Host is claires

What is this discussion about? Chrysler Crossfire, Chrysler Crossfire SRT-6, Coupe, Convertible

Messages Page 153 of 153 1 ... 147 148 149 150 151 152 153 Prev Next Last

Go To Msg # Search This Discussion

#1512 of 1519 PenguinPris by penguinpris Nov 06, 2009 (3:11 pm)
I have my awesome crossfire I LOOOOOOOOOVe it , "Bad Idea" except for the cup holder.  The pluses about the car are so many that it would take too long to list.
#1513 of 1519 oil extractor by vprosser Nov 10, 2009 (10:05 am)
#1514 of 1519 oil extractor by vprosser Nov 10, 2009 (10:08 am)
im trying to do an oil change and I bought an oil extractor but no hose will fit into where the oil filter goes in. Any help or suggestions? Replies to this message: zq8 (Nov 11, 2009 5:42 pm) riddlebox (Nov 13, 2009 12:30 pm) zq8 (Nov 14, 2009 8:26 pm)
#1515 of 1519 Re: oil extractor [vprosser] by zq8 Nov 11, 2009 (5:42 pm)
Replying to: vprosser (Nov 10, 2009 10:08 am) It is to be put in the dipstick tube. I would NOT do it that way if I were you. Just drain it, I do on mine. EASY. Replies to this message: riddlebox (Nov 13, 2009 12:30 pm) zq8 (Nov 14, 2009 8:26 pm)
#1516 of 1519 Re: oil extractor [zq8] by riddlebox Nov 13, 2009 (12:30 pm)
Replying to: zq8 (Nov 11, 2009 5:42 pm) Why not? I know several Crossfire owners (including myself) that use the oil extractors. I know the big debate is that the extractors really don't remove all the gunk on the bottom of the pan, etc. But since I learned that all the Mercedes dealers are using the extractor, I figure that's O.K. with me. Replies to this message: zq8 (Nov 14, 2009 8:26 pm)
#1517 of 1519 Re: oil extractor [riddlebox] by zq8 Nov 14, 2009 (8:26 pm)
Replying to: riddlebox (Nov 13, 2009 12:30 pm) Will not get it all out. Not for me.
#1518 of 1519 2004 Crossfire (positive) battery cable by bob_mcc Nov 21, 2009 (12:28 pm)
My wife's Crossfire would not start and the Spoiler extended when she turned on the ignition. I checked out the battery and found the positive lead at the battery was severely corroded, even to the point that the insulation had split and the stranded wires had greatly expanded. So, to disconnect the opposite end of the cable requires removal of a plastic shield.   The question is...how to disconnect the shield without damage?
#1519 of 1519 Replacing discharged battery. by xrossfire05 Nov 21, 2009 (7:29 pm)
After 4 years my battery (original from dealership) finally gave up.Trying to replace it I removed the two battery cables (positive, negative). That was easy enough, but when I started to remove the battery itself, I found that it was not coming out. I looked all around the battery and battery location and found no fastener or screws that was holding the battery down. Does any one have any idea on how to remove the battery from the car so I can replace it with a new one. The only hold down I saw was the one on top of the battery,but after removing it, the battery was still not budging. Any ideas what could possibly be holding the battery still. It's really stuck, and unmovable.

Messages Page 153 of 153 1 ... 147 148 149 150 151 152 153 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Coupes & Convertibles Chrysler Crossfire Chrysler Crossfire