You are here:
Forums
Coupes & Convertibles
Chrysler Crossfire
Chrysler Crossfire

1514 messages, Last post on Nov 10, 2009 at 10:08 AM
You are in the Chrysler Crossfire Forum. Your Host is claires
|
Replying to: henry125 (Oct 23, 2008 11:08 am) So I went out & drove the hell out of the XFIRE for about an hour today, just for shits & giggles!!!! |
|
| I've recently purchased my crossfire and I'm enjoying driving to work again! Want to go somewhere, anywhere, I'm first to volunteer to drive. My girlfriends are envious and looking to buy as well. Have come across a problem with the electrical though. Left signal light has quit working after I moved the car with the hazards on. The bulb is fine, but doesn't flash.The rear flashes but very fast. We cleaned the contacts within the light unit, but that didn't help. Wondering if anyone has any suggestions before I take the light assembly out to check it??? Love my new ride!!! | |
|
|
|
Hello to all. I'm a proud owner of a 2007 XFire Coupe Limited 6Speed. I've driven PT Cruisers since Sept. '01. My last PT was a Turbo 5Speed Dream Cruiser III. I came across the XFire on an internet hunt in Purcell,OK. Drove down Monday morning and took a test drive. WOW, what a car. I think I scared the salesman when we were on a back road and got on it for a quick trip up the gears, hehehe! Brought her home that afternoon. I can't wait to give a good detail and a wax. Will keep in touch, Later. |
|
|
Replying to: smfrycruzr (Oct 24, 2008 5:08 am) 3 valves/cylinder, 2 spark plugs/cylinder, 8.5 quarts Mobil-1..... Hint, watch your tread wear closely, if it looks uneven....the alignment is only warranted for the first 12 months or 12K miles.....whichever comes first!!
|
|
|
Replying to: smfrycruzr (Oct 24, 2008 5:08 am)
|
|
|
|
|
Replying to: smogdung (Oct 27, 2008 9:20 am)
|
|
|
|
|
Replying to: agebhardt (Oct 27, 2008 9:45 am) |
|
|
|
|
hi, driver side exterior light burned out. took out pin then took out light bulb. put new light bulb in. went to put pin back on and it popped into the housing, can't get it out without removing the front end...expensive. dealerships say i can't purchase the pin. i have to purchase entire light assembly. does anyone know of a sister vehicle that may have this same pin or where i might be able to obtain a new pin? thank you teri |
|
|
Replying to: smfrycruzr (Oct 28, 2008 4:18 am) |
|
Just purchased an 05 limited roaster. Love the car. I was wondering if anyone has a good method of cleaning and preserving the convertable top?
|
|
You are here:
Forums
Coupes & Convertibles
Chrysler Crossfire
Chrysler Crossfire
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2008 Chrysler Crossfire



Browse by Board
Browse by Topic
Today's Chats