- #140 of 171
-
Re: 1986 300zx won't run please help [300pilot]
by madog3
-
Dec 11, 2008 (10:06 pm)
-
|
|
Replying to: 300pilot (Dec 11, 2008 9:17 am)
I tend to agree that if it ran B4, why not now? If the car just quit, as you were told and B4 you spend more money - get out your volt ohm meter and check out the fuse panel (driver's side kick panel) or (easier) - pull the panel loose and check the wire solder connertions on the rear. These joints have been known to break and the engine will start (sometimes) and then the viberation breaks the connection and the engine stops. Cross your fringers - give it a shot - good luck...
|
- #141 of 171
-
thanks guys
by 300pilot
-
Dec 12, 2008 (11:08 pm)
-
|
|
I can't wait to get back to GR Michigan (I'm driving back from LA now) to try your suggestions, where can I get the manual the haynes ones don't have crap in them. I'll keep you posted. thanks 300pilot
|
- #142 of 171
-
Re: thanks guys [300pilot]
by madog3
-
Dec 13, 2008 (5:29 pm)
-
|
|
Replying to: 300pilot (Dec 12, 2008 11:08 pm)
Got mine direct from Nissan (USA). Got the phone number from the local dealer's parts department, called (they do plastic) and presto - two weeks and a brand new 300ZX shop manual. Beware the manual is very good but have errors in it. You're right, the Haynes are only good for the outhouse (down here) or to start you're winter fire up where you are.
|
- #143 of 171
-
1985 300zx needinfo
by tomcat8
-
Jan 14, 2009 (10:09 am)
-
|
|
I havea 1985 300zx. I SUSPECT MY CRANKSHAFT POS. SENSOR IS BAD. i cannot find it on car. I need a picture if you have one. Thanks.
|
- #144 of 171
-
Re: 1985 300zx needinfo [tomcat8]
by Mr_Shiftright HOST
-
Jan 14, 2009 (10:13 am)
-
|
|
Replying to: tomcat8 (Jan 14, 2009 10:09 am)
Didn't we answer this already? It's in your distributor.
|
- #145 of 171
-
Re: 1985 300ZX [jcliffro]
by silkie307
-
Jan 27, 2009 (6:57 pm)
-
|
|
Replying to: jcliffro (Jul 19, 2002 2:14 pm)
i have a 300ZX , 1988 and i do love it , it runs good , it not in as good shape as yours, i bought it used. now it's time for me to sell it , i hate to but its just time . but i need to get a passenger side T-Top for it . lightening must have hit it ,cause i went out one day and the glass was completely crystalize.
if any one could give me advice on how to sell it or where to find a black smoked glass T-Top , that would be great.
what about selling it for parts? cause no one will want to buy a car with only one t-top or 2 t-tops but in different colors and i heard they come in 10 or 12 different shades .
|
- #146 of 171
-
300zx burst of hot air & cruise control proble
by joelcurtis
-
Jan 28, 2009 (11:59 am)
-
|
|
when i get on it i get hot air out of vents also 5 speed 1988 300zx cant set speed green light comes on dash little set buton when i push dont wor i replace relay whole switch now what? thanks
|
- #147 of 171
-
1986 300ZX
by dennis1029
-
Aug 03, 2009 (3:48 pm)
-
|
My cruise control was working then simply quit. Someone suggested I check the vacuum hose which I did and it appears to be working. Any other suggestions? I have some longer trips and would really like to have it in working conditions.
Thanks
Dennis
|
- #148 of 171
-
Re: 1986 300ZX [dennis1029]
by Mr_Shiftright HOST
-
Aug 03, 2009 (4:20 pm)
-
|
|
Replying to: dennis1029 (Aug 03, 2009 3:48 pm)
You can check your fuse box but often with these old cruise controls it is the electronic amplifier (module). But I hope not , as it is expensive. There is also a cruise control relay, (RH side of engine compartment in the relay box, marked I think A.S.C.D) a servo (vacuum operated and also on the RH fenderwell) and the cruise control switch itself in the driver's area. All need to be looked at.
|
- #149 of 171
-
Re: 1986 300ZX [Mr_Shiftright]
by dennis1029
-
Aug 06, 2009 (3:54 am)
-
|
|
Replying to: Mr_Shiftright (Aug 03, 2009 4:20 pm)
Thanks, will check out all the things you mentioned.
|
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Classic Cars 
