You are here: Forums Classic Cars Nissan 300ZX, all models

Nissan 300ZX, all models

171 messages,  Last post on Sep 22, 2009 at 11:44 AM

You are in the Classic Cars Forum. Your Host is mr_shiftright

What is this discussion about? Nissan 300ZX, Hatchback

Messages Page 14 of 18 1 ... 11 12 13 14 15 16 17 18 Prev Next Last

Go To Msg # Search This Discussion

#129 of 171 Re: [Mr_Shiftright] by kdawg67 Aug 16, 2008 (11:41 am)
Replying to: Mr_Shiftright (Feb 07, 2003 10:51 am) I have a 86 turbo 300 everythings fine except my air conditioner won't blow out of the vents i've tried everything, vacuum hoses can some help me please Replies to this message: Mr_Shiftright (Aug 16, 2008 11:49 am) madog3 (Nov 09, 2008 1:31 pm)
#130 of 171 Re: [kdawg67] by Mr_Shiftright HOST Aug 16, 2008 (11:49 am)
Replying to: kdawg67 (Aug 16, 2008 11:41 am) Is your compressor clutch clicking on and off when you hit the AC switch? You can hear this even without the engine running as long as the key is to the ON position.
#131 of 171 Re: [Mr_Shiftright] by smorici Aug 22, 2008 (12:28 pm)
Replying to: Mr_Shiftright (Jan 02, 2003 8:02 am) I agree with Mr. Shiftright. I appraise 50-60 cars a week and experience about a 10-15% accuracy rate. Beyond the underbody inspection a paint meter is a must professionally or as a hobbyist. It has helped me save 10's of 1000's of dollars in losses on vehicles that I have taken in trade with undisclosed damage. I personally recommend the FenderSplendor FS 488. I have had 2 for over a year and they are inexpensive very accurate and easy to use.
#132 of 171 2+2 vs GS by shooot55 Oct 26, 2008 (5:22 pm)
What's the noticeable difference's between the 2+2 and the GS model's
#133 of 171 Re: [kdawg67] by madog3 Nov 09, 2008 (1:31 pm)
Replying to: kdawg67 (Aug 16, 2008 11:41 am) Need more info: Was any work done when it stopped? Will the blower work but no air out of AC? (will it blow heat?). Which AC controls does your car have?
#137 of 171 1986 300zx won't run please help by 300pilot Dec 11, 2008 (9:17 am)
I bought a 86 300zx non-turbo 5sp in GA, dealer said he sold it to a good customer who drove it to FL and it quit,towed back to dealer and I bought it. It starts for about 1sec. and quits. Valdosta nissan said that it had a 84 ecm harness and it wouldn't work but it's obvious that the car ran with this harness. I can hear the fuel pump when I turn the key. I've swapped out dist, crank sens, cyl temp sens. fuel pump, fuel pres sens, w/used units, all with the same result, starts and quits. and ecm's too. i've wrenched on motors for years, what am I missing? It's driving me nuts! It's a beautiful car and i've had these z's for years. Oh please help me z gurus. Replies to this message: Mr_Shiftright (Dec 11, 2008 10:04 am) madog3 (Dec 11, 2008 10:06 pm)
#138 of 171 Re: 1986 300zx won't run please help [300pilot] by Mr_Shiftright HOST Dec 11, 2008 (10:04 am)
Replying to: 300pilot (Dec 11, 2008 9:17 am) Well if indeed it has a cobbled up '84 harness in there, your problem could be anywhere in the harness. It sounds to me like some vital signal from a sensor to the ECM is getting lost or misinterpreted, doesn't it?   You may need a factory manual and a good diagnostic computer to figure this one out. Once modifications have been made, all bets are off. You may need to initiate the tedious process of checking voltages and signals at each ECM port.

Messages Page 14 of 18 1 ... 11 12 13 14 15 16 17 18 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Classic Cars Nissan 300ZX, all models