Ask the Car People.SM


Infiniti G35 Maintenance and Repair

2936 messages,  Last post on Apr 23, 2013 at 5:40 PM

You are in the Infiniti G35 Forum.

What is this discussion about? Infiniti G35, Sedan

Messages Page 293 of 295

#2913 of 2936 Re: Drivers window-coupe [ellaryk] by srs_49

Jul 05, 2012 (5:04 pm)

Replying to: ellaryk (Jul 05, 2012 1:32 pm)
Does the limit switch on the motor just need to be reset?
 
That's what I would try. Here's an short article on how to do that on a Nissan. Your Infiniti should be similar.
 
Artcile Here

#2914 of 2936 Re: Drivers window-coupe [srs_49] by ellaryk

Jul 07, 2012 (10:40 am)

Replying to: srs_49 (Jul 05, 2012 5:04 pm)
I now noticed that the anti-pinch is not working. This is recent, since my last post.
Is it still worth trying to reset the limit switch?

#2915 of 2936 Re: Drivers window-coupe [ellaryk] by srs_49

Jul 09, 2012 (2:10 pm)

Replying to: ellaryk (Jul 07, 2012 10:40 am)
I would try it.
 
I believe the reset does more than just reset the limit points. It actually resets the tiny microcontroller that controls the drive motor for the window. So you have to go through a learning sequence of some sort for it to re-learn where the up and down stop points are, for instance.

#2916 of 2936 Re: Drivers window-coupe [srs_49] by ellaryk

Jul 09, 2012 (3:05 pm)

Replying to: srs_49 (Jul 09, 2012 2:10 pm)
I did. But when I pressed the button I found the motor assembly to be loose. I reset it anyway and afterward the window wouldn't go all the way up. So I figured it had to have something to do with the loose motor. I pulled apart the panel, leaving the motor attached just to peer behind it. I didn't see anything obvious. Put it back together and the motor is still loose. Then I got interrupted.
Next step is to pull it completely apart to find out why the motor would be loose.

#2917 of 2936 Re: 2003 G-35 won't start after sitting [fex] by arram

Jul 15, 2012 (8:47 pm)

Replying to: fex (Aug 12, 2008 7:58 am)
i had a similar issue ..took the car to dealer and i was told to get new TCM to start with (1800$)..please help do you think it just a AT fuse issue? Dealer wants to make money from me ?

#2918 of 2936 2004 G 35 Won't start by arram

Jul 15, 2012 (8:56 pm)

I have a G-35 that will not start after sitting for a week. Well it will start once the service engine soon light and the car preforms poorly. Once it is shut off it will not start again. I had it towed to the dealer and i was told that they want to replace TCM to start with which cost about 1800$ and not sure if that fixes the issue either.Please help me dont want to spend so much money without knowing the real issue ..
 
I would Appriciate the help

#2919 of 2936 Re: Drivers window-coupe [ellaryk] by ellaryk

Jul 16, 2012 (10:31 am)

Replying to: ellaryk (Jul 09, 2012 3:05 pm)
It turns out the motor was broken. I installed a new motor (it has a lifetime warranty so it cost nothing for the motor) and all is well.

#2920 of 2936 Re: 2004 G 35 Won't start [arram] by ellaryk

Jul 16, 2012 (10:33 am)

Replying to: arram (Jul 15, 2012 8:56 pm)
Have you checked the condition of your battery? A bad battery will lose a charge quickly. If the battery is OK look for a drain on the battery.

#2921 of 2936 Re: 2003 G35 engine stop running, check engine light, slip light and VDO lights [nice5] by emtx

Jul 18, 2012 (1:38 pm)

Replying to: nice5 (Jun 16, 2012 9:47 pm)
I am having this same problem with my 2003 g35 coupe now. How did you get this problem resolved?

#2922 of 2936 Re: 2003 G35 engine stop running, check engine light, slip light and VDO lights [emtx] by stef1974

Jul 18, 2012 (1:57 pm)

Replying to: emtx (Jul 18, 2012 1:38 pm)
i had this stalling problem when RPM was low... and a few times at around 50 mph... dealer changed cam position sensor and I have no stalling problems since. This was the code returned, so easy enough to diagnose. Not too expensive to fix

Messages Page 293 of 295

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement