Ask the Car People.SM


Infiniti G35 Maintenance and Repair

2936 messages,  Last post on Apr 23, 2013 at 5:40 PM

You are in the Infiniti G35 Forum.

What is this discussion about? Infiniti G35, Sedan

Messages Page 292 of 295

#2905 of 2936 Re: Leaking Oil Housing [pjt6970] by watash50

Apr 06, 2012 (11:58 am)

Replying to: pjt6970 (Dec 31, 2011 2:03 pm)
Your oil leak is the gasket above the oil filter. Remove the filter and you'll find a hex looking nut under where the filter screws onto the cooler. Loosen the nut and pull housing down. The "O" ring is right there. Replacement ring can be purchased thru your local Nissan dealer for about $8.00. Real inexpensive repair and easy to do.

#2909 of 2936 Trunk leak by allangman18

May 01, 2012 (9:11 pm)

I found that my trunk was leaking at the rubber seal. The seal was damaged by the emergency trunk release which fell on to the seal depressing it enough to allow water to seep into the trunk when the car was washed. So beware of this problem. New seal and snipped off the offending portion of the release.

#2910 of 2936 2003 G35 engine stop running, check engine light, slip light and VDO lights by nice5

Jun 16, 2012 (9:47 pm)

#2911 of 2936 2003 G35 engine stop running, check engine light, slip light and VDO lights by nice5

Jun 16, 2012 (9:47 pm)

2003 Infinity G35 sedan engine will stop running while being driven. Twice when driving 70 mph and once at 30 mph 6 months ago. Now engine is stopping when coming to a stop and hard to start. Engine will only start if gas pedal is pumped a few times. The Service Engine Light, VDC Off & Slip all come on. VDC Off & Slip will turn off after a while. The dealer said my car VIN number is not on the ITB03-072 recall list and recommend I do not change out the crank position or cam position sensors. No codes coming up when using an OBD2 OEM Enhanced code reader. Any suggestions?

#2912 of 2936 Drivers window-coupe by ellaryk

Jul 05, 2012 (1:32 pm)

Last winter I replaced the motor on the driver's window and it worked fine.
Now, when I close it it rolls all the way up then rolls down about 3 inches. Does the same if I hold the switch until it is fully rolled up. To close it I have to hold the switch in the up position until it is closed for 10 seconds or so. The automatic window adjusting function (when the door is opened and closed) and anti-pinch functions works properly.
Does the limit switch on the motor just need to be reset?
Thanks.

#2913 of 2936 Re: Drivers window-coupe [ellaryk] by srs_49

Jul 05, 2012 (5:04 pm)

Replying to: ellaryk (Jul 05, 2012 1:32 pm)
Does the limit switch on the motor just need to be reset?
 
That's what I would try. Here's an short article on how to do that on a Nissan. Your Infiniti should be similar.
 
Artcile Here

#2914 of 2936 Re: Drivers window-coupe [srs_49] by ellaryk

Jul 07, 2012 (10:40 am)

Replying to: srs_49 (Jul 05, 2012 5:04 pm)
I now noticed that the anti-pinch is not working. This is recent, since my last post.
Is it still worth trying to reset the limit switch?

Messages Page 292 of 295

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement