You are here:
Forums
Hybrid Vehicles
Honda Civic Hybrid
Honda Civic Hybrid

1765 messages, Last post on May 28, 2009 at 1:36 PM
You are in the Honda Civic Hybrid Forum. Your Host is pf_flyer
|
Replying to: misterme (Sep 22, 2004 6:59 pm) At any rate its been 10 days with no visits to the gas station yet and heading into 400 miles. we run the air con constantly so I'm sure that's going to affect mileage.As I said before it will still be a lot better than what we're used to! Anyone change their own oil and trans fluid? I've changed the oil on my old cars.Is this one that different? The only 0-20 oil I can find here is synthetic except of course from the dealer.
|
|
|
Replying to: paul12 (Sep 22, 2004 9:08 pm) I am going to change the tranny fluid myself too when the time comes. I might decide on GM SynchroMesh, it seems to be the best manual tranny fluid out there, from what I could find so far. Congrats on your fine choice of a car and good luck !!
|
|
|
|
|
Replying to: larsb (Sep 23, 2004 5:59 am) Mobil 1 is available in 0W-20, which is direct replacement for the 5W-20. 0W-30 may not be such a good idea. I am going to change the tranny fluid myself too when the time comes. I might decide on GM SynchroMesh, it seems to be the best manual tranny fluid out there, from what I could find so far. If the hybrid tranny is similar to non-hybrid, I would strongly suggest that you stick with Honda MTF fluid. Using non-Honda fluids in Honda trans will most definatley void the warranty, and will affect the way the tranny behaves. Same is true with Auto tranny fluid. If Hybrid uses CVT fluid, this is the only fluid that should ever go into the tranny, nothing else. Cost should not be an issue as the Honda MTF or CVT fluids are resonably priced for products that have no competition. |
|
|
0W-30 is good oil: "Mobil 1 0W-30 is the most advanced performance synthetic engine oil designed to provide the cleaning power, wear protection and enhanced fuel economy performance." Another oil site says: "All three oils (0W-30, 5W-30 or 10W-30) are excellent motor oils and ANY one can be used in a vehicle which requires either a 0W-30, 5W-30 or 10W-30 oil as well as in several other engine applications including an engine which recommends a 5W- 20 oil. This leads to the next topic: many people also ask us if the 0W-30 is too thin a viscosity oil for high ambient temperature operation. The answer is absolutely not! Thicker viscosity oils are not always necessarily better since in addition to its' various engine lubrication functions, an oil must also effectively transfer heat. Only about 60% of an engines cooling is performed by the engine coolant, and only on the upper half of the engine. The remaining 40% of an engines cooling is performed mainly by the engine oil." Yet another site: "0W-30 flows up to seven times faster than conventional oils. Therefore, it provides superior protection for engine parts during cold start-ups. And it safeguards your engine when it's extremely hot. Plus, 0W-30 helps maintain low oil consumption and reduces wear on starters and batteries." I can find more examples, but trust me on this: I have used 0W-30 in my last five vehicles since 1997, and it does a fine job. It doesn't evaporate, and it helps fuel economy by reducing friction. |
|
Any comments on the 2005 owner manual stating the mechanic should change the trans fluid then run the car,then drain and repeat process three times. I doubt a dealer would really do this. Thanks for the input on the oil change.
|
|
|
Replying to: paul12 (Sep 24, 2004 12:07 pm) |
|
|
|
|
Mobil 1 Racing 0W-30 SAE Grade 0W-30 Viscosity, ASTM D 445 cSt cSt Viscosity Index, ASTM D 2270 175 Sulfated Ash, wt%, ASTM D 874 1.2 HTHS Viscosity, mPa·s Pour Point, ºC, ASTM D 97 -54 Flash Point, ºC, ASTM D 92 234 Density Mobil 1 0W-20 SAE Grade 0W-20 Viscosity, ASTM D 445 cSt cSt Viscosity Index, ASTM D 2270 165 Sulfated Ash, wt%, ASTM D 874 1.28 HTHS Viscosity, mPa·s Pour Point, ºC, ASTM D 97 -57 Flash Point, ºC, ASTM D 92 232 Density The differences are almost negligible, but I still use 0W-20. Exxon does not list viscosity at 0C, but if you look at difference in viscosity for 0W-30 and 0W-20 from 40C to 100C. I can imagine that 0W-30 is more viscous at sub freezing conditions. You can see that by the lower pouring point of 0W-20 vs. 0W-30. But, all in all, any synth is better than dyno oil. |
|
|
Replying to: budd (May 12, 2004 1:30 pm) The 7th gen Civic's fuel tank is shaped such that it is highly variable as to when you have actually filled the tank. I know this because on occasion I've put more gas in my Civic than the 13.2 Gal capacity and driven for 50 more miles before the guage moves off "F". Sometimes I know the tank isn't quite full despite the pump's auto shut off kicking in. You shouldn't manually fill the tank once the pump shuts off to avoid draining into the emissions system. Why is this importatnt to know? Because when you only drive 100 miles and then refill, your mpg could be way off depending on when the pump shuts off. Solution: Use at least 10 tankfuls of gas returning to the exact same pump every time. Calculate your mpg each time and average all 10 readings to arrive at a reasonably accurate number. It's possible to fill-up, drive 50 miles, fill-up again and the pump shuts off after only half a gallon added (pump shut-off calibrations differ at different pumps) and calculate your mpg to be 100. Of couse 100 mpg is impossible. |
|
|
Replying to: mauto (Sep 28, 2004 4:50 pm) I've owned 12 cars in the last 25 years, and I have only once ever put more fuel than the tank was rated for, and that was only 0.1 more.....
|
|
|
Replying to: larsb (Sep 29, 2004 6:17 am) ___I have owned 12 vehicles in the last 10 years and all have been able to be filled beyond specified capacity. Currently, the Corolla will hold > 15, the Insight > 14, and the MDX > 22. ___Good Luck ___Wayne R. Gerdes
|
|
You are here:
Forums
Hybrid Vehicles
Honda Civic Hybrid
Honda Civic Hybrid
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2011 Honda Civic



Browse by Board
Browse by Topic