You are here: Forums Sedans Buick Park Avenue Buick Park Avenue Maintenance & Repair

Buick Park Avenue Maintenance & Repair

295 messages,  Last post on Nov 18, 2009 at 6:47 AM

You are in the Buick Park Avenue Forum. Your Hosts are pat & karens

What is this discussion about? Buick Park Avenue

Messages Page 29 of 31 1 ... 25 26 27 28 29 30 31 Prev Next Last

Go To Msg # Search This Discussion

#273 of 295 Re: 2004 Park Ave - 75000 Recommended Maintenance [imidazol97] by ginny55 Jul 16, 2009 (4:42 pm)
Replying to: imidazol97 (Jul 15, 2009 4:11 am) Thank you. I bought the car at 25000 miles and I don't think the cabin air filter has ever been changed. I will definitely get that done.   Thanks again for your reply.
#274 of 295 Re: 2003 Park Avenue Ultra "service stability system" diagnostic message [pau03] by jhedrick Aug 08, 2009 (12:03 pm)
Replying to: pau03 (Jul 25, 2007 3:21 pm) Hi,   I have the same problem and was wondering if you found out why it was coming on.   Thanks Replies to this message: imidazol97 (Aug 08, 2009 4:11 pm)
#275 of 295 Re: 2003 Park Avenue Ultra "service stability system" diagnostic message [jhedrick] by imidazol97 Aug 08, 2009 (4:11 pm)
Replying to: jhedrick (Aug 08, 2009 12:03 pm) The post to which you replied was from July 2007; the poster hasn't been on since December 2007. But I'll comment.   There have been a lot of cases of the service stability system message. In some it's the sensor on the steering column not reading well because of gap between it and the column or other things. The four sensors at the wheels can cause problems with gaps, dirt, or corrosion on the contacts.   you might watch to see if it turns on when you turn the steering wheel or when you hit a bump at one of the car wheels while they are turned. I've had my message come on but then it doesn't come on for a long time. I have suspected one of the wheels sensor connections and will reseat each one as I do the brakes over a period of time.   The steering sensor was reset or replaced under warranty when my 03 was within the new car warranty.   If you turn off the car and restart, usually mine will operate just fine. When the message has been on, the stability system is turned off. That's not much of a problem for me.
#277 of 295 Re: cam shaft sensor [imidazol97] by karmaboo Sep 10, 2009 (5:29 am)
Replying to: imidazol97 (Apr 08, 2007 4:49 pm) i have a 91 buick park ave. i changed the coil pack and ignition mod. but after driving for about 20 minutes the car seems to just shut down. it wont start right back up, i have to wait like 20-30 minutes. the last time it did it, it did start back up but i work across the city and need to make sure i can get there and back. someone mentioned cam shaft sensors but it seems everyone on here already tried that!! what should i do? i am getting plenty of gas and power, its just like its getting to hot and shutting down!!
#278 of 295 91 Park Ave Issues????? by karmaboo Sep 10, 2009 (6:48 am)
I bought a 91 park ave about 2 weeks ago. i had to replace the coil pack and ignition mod. because the car would shut down after driving for 30 minutes or so. since then, hte car will still shut down on me. there are no warning signs, it just dies out. i dont know what else to do, when i bought the car they said it had no problems what so ever. where do i go now? it dont overheat all the gages are fine and it runs great before it shuts down. what should i do? Replies to this message: imidazol97 (Sep 10, 2009 12:31 pm)
#279 of 295 Re: 91 Park Ave Issues????? [karmaboo] by imidazol97 Sep 10, 2009 (12:31 pm)
Replying to: karmaboo (Sep 10, 2009 6:48 am) Does it restart immediately? Does it take a while. If it won't start pull off a spark plug wire, put a screwdriver blade in and hold it close to the grounded motor while someone cranks to check for spark. No spark. Then look to crankshaft position sensor.   If spark present then check for proper fuel pressure. Could be fuel pump. You may need to connect a fuel pressure gauge and duct tape it to windshield and drive around watching it.   Could be main computer cutting out.
#280 of 295 97 buick windows problem by solomon123 Sep 22, 2009 (8:40 am)
I have a 97 Buick park avenue. My driver side window does not work. I replaced the window control. I replace the driver door motor. What is causing my problem.
#281 of 295 1998 Park Avenue Suspension by brian1998 Oct 03, 2009 (3:27 pm)
I am replacing the rear shocks and I also will be replacing the sway bar bushings and links. Are there any other items that i need to be concerned with on the rear suspension, also are there any instructions or diagrams available for this procedure. Thanks, Brian
#282 of 295 '02 park avenue rear heat chrisptown02 by chrisptown1 Oct 16, 2009 (2:25 pm)
recently purchased the above i can seem to get any heat out the rear vents above the console. any ideas? thanks.

Messages Page 29 of 31 1 ... 25 26 27 28 29 30 31 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Sedans Buick Park Avenue Buick Park Avenue Maintenance & Repair