45 messages,
Last post on Jan 21, 2009 at 4:40 PM
You are in the
Ford F-Series Forum.
What is this discussion about?
Ford F-150, Ford F-350, Ford F-250, Truck
#2 of 45 The usuals on my V10 F250 ...
by fordtuf
Apr 16, 2002 (10:44 am)
K&N filter, JBA headers, Flowmaster w/dual outlets into 4" tips. They come out at an angle behind the rear tires.
BTW can anyone give a good reason why people want to stick the tailpipes straight out the back and let them extend beyond the bumper.
Great place to bust your shins and knee caps.
#3 of 45 V-10 Mods
by badblue
Apr 23, 2002 (8:22 am)
Super Chip, Air Force 1 airfilter kit, Banks Powerpack setup, can't believe the difference.
#4 of 45 badblue
by tj_610
Apr 24, 2002 (4:49 am)
No 250 yet, getting 1st this fall. Don't want to get too far ahead of myself, but have read about the Banks Powerpack. Can you tell me more? My primary interest would be improvements in daily driving performance. MPG=meaningless, of course ;-
Also, did you upgrade from wimpy-looking 265's?
Thanks.
#5 of 45 Morning ,tj610
by badblue
Apr 24, 2002 (8:15 am)
No, I didn't fool with the tires yet, just turned first 1000 miles. Don't use the truck as an everyday driver, mainly to pull my boat, (23' Wellcraft Excalibur) and fiver (32'Alumascape) which I'm picking up Sat. Before Banks, I was getting 151/2 to 16 MPG on highway at 70 MPH. In city with stop and go 12-13. I'll post next week what my highway numbers are with and without the fiver. Right now power is fantastic, tach winds up like crazy in all gears. Don't know what top end is as speedo returns to 0 when it hits the century mark, but starts working again when you get down below 100. Will post milage results on Monday.
#7 of 45 F350 TURBO INFO
by tedbebe4
Dec 11, 2005 (10:50 am)
CAN SOMEONE TELL ME HOE TO SEND A FAKE SIGNAL TO THE WASTE GATE SO I CAN CREATE MORE BOOST.
#8 of 45 how to convert a 2wd into a 4wd
by best78ford
Dec 20, 2005 (8:31 pm)
how do i convert my 1978 ford f150 2wd into a 4wd?
#9 of 45 Re: how to convert a 2wd into a 4wd [best78ford]
by allday82
Mar 02, 2006 (3:22 am)
you are better off trading for a truck thats alredy 4 wheel. YOU need a transfercase w/mounting plate,new axcels w/locking hub 4 wheel shifter. Transfer case goes between the transmission and the drive shaft. you could also add automatic locking hubs that would be harder.
May 17, 2006 (8:50 pm)
I need to replace my bed-rail liner on the top of the lift gate on my '04 F150.
Anyone know a place other than Ford where I can buy that?
Ford wants $75 for this piece of plastic.