Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Coupes & Convertibles Chevrolet Corvette Corvettes and all things about them
1905 messages, Last post on Nov 21, 2009 at 9:30 AM
You are in the Chevrolet Corvette Forum. Your Host is claires
I have been having an issue with inspection for my 94 with 105000 miles. I have an intermittent check engin light and if it on when the emissions is being done it fails. I have had issues fixed in past years that had showed up on the computer, but now nothing shows up. The mechanics think its a data link issue and to contact a dealer, or to try to get it inspected when the check engin light is off. I am told there are 3 computers involved and it could be a wiring harnass issue I have been trying to check consumer sites to see if there were old recalls. Any input will be helpful. thanks
|
|
|
|
|
Replying to: mjb602 (May 09, 2008 9:12 am) R5108900 TO R5110650 This was a recall campaign # 94C21 Sometimes these mystery lights are connected to a faulty gas cap or loose hoses or loose connecting hoses within the evaporative emissions system. |
|
|
|
|
Replying to: mjb602 (May 09, 2008 9:12 am) |
|
If anyone could help me with how to get to the A/c controller I would be grateful I just need to know how to get to it Thanks
|
|
|
|
|
Replying to: mgriess (May 14, 2008 5:52 pm) 2. Remove the I/P accessory trim plate. 3. Remove the HVAC control head retaining screws. 4. Pull the control head out from the I/P center support bracket to access the electrical connector. 5. Disconnect the electrical connector from the control head. 6. Remove the control head from the vehicle. INSTALLATION PROCEDURE 1. Connect the electrical connector to the HVAC control head. 2. Install the control head to the I/P center support bracket. NOTE: Refer to Fastener Notice in Service Precautions. 3. Install the HVAC control head retaining screws. Tighten Tighten the HVAC control head retaining screws to 1.9 N.m (17 lb in) . 4. Install the I/P accessory trim plate. 5. Connect the negative battery cable. Tighten Tighten the negative battery cable bolt to 15 N.m (11 lb in) . 6. Program the transmitters. Refer to Transmitter Programming/Synchronization in keyless Entry. |
|
|
|
|
Our less than 2 month old 08 base, auto, vette has lost power 3 times driving up the hill to our home in almost the same exact spot. First time we had the car a week. 2nd time 2 weeks! 3rd time the first time we tried to drive it up the hill after it was in the shop for 6 more days! We had the car towed the first 2 times. The 3rd time my husband turned around and limped the car back to the dealer. The dealer says it is the gas. We use Chevron Texaco only. One of the sales people suggested that someone at the dealer where we bought the vette did something to the car! The dealer has now put some kind of monitor in the car for when the next time it happens we are to push the button so they can record what is going on. First time engine light came on. 2nd and 3rd time no engine light. On the hill, it drops from 45 to 10 and goes all the way down to 1st gear. The RPM goes up and down. The incline of the hill is 3000 to 6500 in 11 miles. The hill is smooth and we are on it for 5 miles before it happens. Oh and the roof creaks horribly especially on the drivers side as we drive down the hill from 6800 to 3000. It is very annoying. Does anyone have a clue as to what could be happening? We would appreciate any help. We have not taken it to the Vegas dealer where we bought it as it is a long distance from our home in AZ. We have been taking it to the local Chevy dealer here in Kingman AZ. And yes I am jodenessky who had so much trouble with my 08 Skys brakes. I have no luck with new cars!
|
|
|
Replying to: jodenessky (Jun 30, 2008 12:11 pm) |
|
|
I have never experienced anything like what you are describing – nor have I read about anything similar, and I have monitored the largest “Corvette-focused” forum for over 3 years. Good luck, and please post the resolution? Regarding the noisy roof – there is a TSB: http://forums.corvetteforum.com/showthread.php?t=1554872&highlight=roof+tsb But I would not let a Dealer do what is described. I did the fix described here – and it reduced the noise on my 2007’s top by over 95%: http://forums.corvetteforum.com/showthread.php?t=1956846&highlight=noise+top Good luck. - Ray Happy to have a Chevy dealer nearby with a good ‘Vette Tech. |
|
|
Replying to: jodenessky (Jun 30, 2008 12:11 pm) The Corvette gas tank is a complex arrangement. It is a split, two-tank system, with I think 3 fuel pumps in it, to move gas between the tanks and to the engine. This system has had some reported problems. Usually they seem to be failure in the guage display (caused by components inside the tanks), and also failures that will shut the car down completely. |
|
|
|
|
Replying to: jodenessky (Jun 30, 2008 12:11 pm) |
|
You are here:
Forums
Coupes & Convertibles Chevrolet Corvette Corvettes and all things about them
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chevrolet Corvette
Browse by Board
Browse by Topic
Today's Chats
