Chevy S10 - GMC S15 and Sonoma Care & Maintenance

398 messages,  Last post on Nov 15, 2011 at 3:42 AM

You are in the Chevrolet S-10 & GMC S15 Sonoma Forum.

What is this discussion about? Chevrolet S-10, GMC S-15, Truck

#272 of 398 Re: 2001 S10 Heating Problems "Help" [akm0524] by ozzymandias85

Jan 23, 2006 (9:19 pm)

Replying to: akm0524 (Jan 11, 2006 2:45 pm)
Okay disconnect the heater hoses from the engine. Get a water hose and try to run water through the lines. In other words cram one of the heater hoses into the water hose. See how much water and junk comes out the other disconnected line. Many times Chevy heater cores plug up. If the flushing shows good water flow and or no junk coming out then.
     Check the heater hoses, I have not had any problems with my truck but I had a camaro that did the exact same thing and found that one of the heater hoses would collapse as it got hot.
     Now I dont know if your model is equipped with this or not, but while your following the lines see it there is a heater control valve in line.

#273 of 398 Re: 2 Questions : '93 Blazer Digital Display question and 4WD doesn't work [dhatter] by mbower

Feb 01, 2006 (6:39 pm)

Replying to: dhatter (Jun 29, 2005 5:49 am)
There is an electronis switch on your transfer case that goes bad, and is a fairly common problem with this type (electronic) 4wd.

#274 of 398 Re: 93 blazer s10 brake probs [elkhornkid1] by mbower

Feb 01, 2006 (6:49 pm)

Replying to: elkhornkid1 (Jul 18, 2005 2:00 pm)
I'm sorry, but this was the original type of Antilock Brake systems invented by the General. THEY SUCK! your problem is most likely your wheel speed sensors. In case you dont know what these look like, jack one side of your car up and remove the wheel. look for the brake hose. you should also see a smaller, smooth hose, and that is your wheel speed sensor. i would replace both sides, and i believe theses parts are only available from GM.

#275 of 398 Re: 1987 S-10 with 301,000 miles [koah8] by mbower

Feb 01, 2006 (6:53 pm)

Replying to: koah8 (Jan 14, 2006 3:25 am)
When was the last time your engine got a good tune-up? check your plugs, wires, cap, rotor, air and fuel filter. also, try to adjust your timing. If you cannot see the timing marks on your crank pulley, try setting it 4 degrees before top dead center. if you adjust your timing, and it runs well for a while, but repeats itself like bfore, check your timing chain.

#276 of 398 Re: 1989 V6 Stall Problem [beamermt25] by mbower

Feb 01, 2006 (6:55 pm)

Replying to: beamermt25 (Jan 20, 2006 3:17 pm)
I had the same problem with my '89 and my boss said for me to check the timing chain. But, i got into an accident before i got to replace it, and it was totaled, so have someone check the chain for you.

#277 of 398 Bogged Down Truck by deridder

Feb 02, 2006 (4:21 pm)

I have a 1985 V6 S10 with 75,000 miles on it. Lately its been bogging down really bad in the morning. I go out and start the truck fairly easily, and it will run fine for 2 to 3 miles, but then it starts to bog down. It will only go 5 or 6 mph. The weird thing is that when i go to drive it home 6 hours later, it runs perfectly fine. At first i thought it was the choke sticking, so i put a manual choke on. That did not help. I also changed the plugs, wires, fuel filter, and had an oil change. None of this helped. Could someone please give me some pointers.

#278 of 398 Re: brake light and abs light on [jim91] by heartofgold

Feb 05, 2006 (3:45 pm)

Replying to: jim91 (Jan 09, 2006 2:59 pm)
Does anyone know where I can find the ABS fuse in the fuse box. What's it called? or maybe it's located somewhere else.
Thanks in advance

#279 of 398 Interior lights fuse by juvy

Feb 06, 2006 (9:23 pm)

I cant figure out which fuse is for the interior lights none are labeled as interior lights. Please help me out. >.< 91 S-10 Blazer

#280 of 398 1989 s10 blazier by kkjester

Feb 14, 2006 (7:44 am)

Yeah i have a 1989 blazier, s10 model, 4x4, its got over 220k miles on it, i was driving home after my friend put the fuel filter on wrong and now its leaking, well thats just the start of it, the gas peddle made a loud like pop as my foot was on it, and when i tryed to crack it agian, it wont stay cracked, it shot like fire and threw the air filter from above the fuel injectors to the hood, and.. oil just vanshies, doens't leak, no burns out of the exhaust, just goes some where, so.. i just paid 300 bucks for a new engine but its a 1988 s10 model, my question is.. can it go into that body, and work without to many changes, going to use parts from both trucks to get the newer one working
 
please email me at onlyjesteraol.com
with any help you can provide, thanks

#281 of 398 93 blazer cold start question by 90suprat

Feb 17, 2006 (8:23 pm)

Hi, I have a 93 s10 4x4 blazer with 44k miles, and it doesnt go to high idle when first started on cold days, it just idles like it has been warmed up. It will also smoke a little, but mostly when it's a little warmer outside, it also takes longer to start the warmer it is, any ideas?
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement