Sign In Join 



Acura RSX Maintenance and Repair

1030 messages,  Last post on Oct 09, 2009 at 10:44 AM

You are in the Acura RSX Forum. Your Host is pf_flyer

What is this discussion about? Acura RSX, Electrical, Engine, Hatchback


Messages Page 97 of 104
1
...
94
95
96
97
98
99
100
...
104
Prev
Next
Last
Go To Msg #
Search This Discussion

#952 of 1030
Self Maintenance by 03rsxsowner
Jan 27, 2007 (2:40 pm)
Reply
Hello,
 
I just replaced my passenger side headlight (a tight spot, but not tighter than driver's side), but when I went to start the car it would not start. All of the power works, so I rule out the battery. It tries to turn over, then, when it cannot catch, goes to a series of fast clicks, in which the lights and other battery using things flicker. I may have plugged the cord back into the bulb part upside down, but when I tried to start it with it unplugged, it would still do the same thing. I haven't tried turning it over, maybe I have it upside down, maybe that would work because of some kind of polarity thing. In the process I dropped the bulb and bracket into the bottom of the engine compartment and used a screwdriver to fish it out. I don't think I hit anything that would have shorted something out (the power was off when I was doing this), but I think something electrical is happening. If I go to the car right now, all power operations work, it's just when I try to start it, it seems something electrically related is not working. Any suggestions? I was trying to save whatever money it would have cost to get my mechanic to replace the light.
 
Bummer about all of those SF thefts. I live in Santa Clara and have taken my car up to SF (Pac Heights, Marina areas) a handful of times and haven't had a problem yet. I sounds like it might just be a matter of time.
 
Bill
#953 of 1030
Re: Self Maintenance by 03rsxsowner by 2006rsx
Jan 29, 2007 (4:14 am)
Reply
Your battery may be almost dead. They can have enough juice to run the lights, radio, etc... for a while, but not enough to turn the starter motor. Try charging the battery or jumping it from another car. Or... maybe you accidentally unplugged something or shorted something out while working on the headlight. However, I really think this is unlikely.
 
And don't worry about the headlight being plugged in wrong (or not at all)... that won't cause the car not to start!
#954 of 1030
Re: hesitation when shifting 1st-2nd when hot [dj1rsx] by ljm2043
Jan 31, 2007 (7:10 pm)
Reply

Replying to: dj1rsx (Oct 29, 2006 1:09 pm)

Did you ever have any success with your hesitation problem? Mine still does it but I can't figure out how to duplicate it for the dealer.
#955 of 1030
Re: Self Maintenance [03rsxsowner] by fahrns
Feb 01, 2007 (6:41 pm)
Reply

Replying to: 03rsxsowner (Jan 27, 2007 2:40 pm)

Bill,
 
I have the same problem starting my RSX too. I have an '02 Type S. Drove up to the gas station, filled up, and then wouldn't start. Just clicking noises from the starter. A boost didn't help and I checked the voltage. The battery voltage is fine.
Have you found a solution yet? I'm really hoping it's not the starter. I hear they're not cheap!
Let me know,
Thanks
Pete
#956 of 1030
Re: Self Maintenance [fahrns] by fahrns
Feb 01, 2007 (8:07 pm)
Reply

Replying to: fahrns (Feb 01, 2007 6:41 pm)

Turns out it was the battery. I needed a direct pos-pos neg-neg connection for the boost (had the neg on the dead battery attached to the engine block - didn't get enough juice). I'll be buying a battery tomorrow. Will probably be also keeping an eye on the alternator. Damn cold Canadian winters. My car's been babied in U/G parking for too long!
#957 of 1030
Power locks only work on accessory by johnnyaction31
Feb 08, 2007 (1:43 pm)
Reply
Hi, I recently installed an Apple Mac Mini with a touch screen monitor in my RSX. Around that time, my power door locks suddenly stopped working unless the key was in the ignition. There are no blown fuses or anything and the problem is obviously not with the locks since they work as they should when the key is in the ignition. The only thing I can think of is that when I wired the computer and screen directly to the battery, I also hooked up the new headunit I had bought directly to that wire as opposed to going through the factory harness. Any idea if this is the cause of the problem, and if not, what is? Thanks in advance. --Mark
#958 of 1030
Re: Power locks only work on accessory [johnnyaction31] by drawdef
Feb 08, 2007 (1:55 pm)
Reply

Replying to: johnnyaction31 (Feb 08, 2007 1:43 pm)

Does the key have to be turned to any position or just inside the ignition ?
 
are you documenting your install at all? ive been wanting to install a pc inside my '06 since I got it but i think im going to wait a little while. what are you using the mini for?
#960 of 1030
Re: Power locks only work on accessory [drawdef] by johnnyaction31
Feb 08, 2007 (2:35 pm)
Reply

Replying to: drawdef (Feb 08, 2007 1:55 pm)

The key has to be in accessory mode (to the point just before it would start). Also I have a Compustar alarm which bypasses the clutch for remote start, so you can take the key out and the car stays running until you either shut it off remotely or shut all the doors. When I leave the car running like this the locks do work.
  
As far as the Mac Mini goes, I did not document the install, but the RSX is setup pretty nicely to where you can get an indash screen and put the Mini (or PC) in the glove compartment without modifying anything. You have to have basic wiring knowledge, but basically if you know how to install an aftermarket headunit you can install a computer. The only tricky part was organizing the wires so I could put the dash panel back in once it had both a headunit and the screen mounted to it. (I still dont have a perfect solution to this) The dash snaps apart by hand so I could easily take it apart and take a few pictures to give you an idea of what I had to do. Let me know if youd want that and I can do it tomorrow.
#961 of 1030
Replace headlight by jmwakin1
Feb 20, 2007 (11:01 pm)
Reply
My driver's side headlight is out. I've bought the replacement bulb but when I looked under the hood, I couldn't figure out how to replace it without breaking something.
 
Anyone know how to replace the bulb in the headlight? I'm hoping it's something I can do myself and not take it in to a mechanic and get charge an arm and a leg.
 
Thanks for any help you can offer!

Messages Page 97 of 104
1
...
94
95
96
97
98
99
100
...
104
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement