- #121 of 423
-
Re: hub problem [joeexcursion]
by quickfords
-
Dec 03, 2005 (4:26 pm)
-
|
|
Replying to: joeexcursion (Nov 30, 2005 3:59 am)
Joeexcursion;
Your hubs are shot.  Sorry to break this news to you. Mine were just done under warranty (I thought they damaged them doing a seal, but they say no).I have a 2000 Ex Ltd V10 with 65K miles.
Either way, you need hubs.
|
- #122 of 423
-
Re: 2002 Ford Excursion V10 -2 wheel Drive [1bigtug]
by gm1934
-
Dec 07, 2005 (1:18 pm)
-
|
|
Replying to: 1bigtug (Aug 16, 2005 5:00 pm)
I have a 2001 Ford excursion diesel that rattles in the front when I run over wash board bumps it also rattles from apparently the front when I set at a light in gear.It has been doing this from day one and I cannot find it or any indication that anything is rubbing against something else.
|
- #123 of 423
-
Re: 2002 Ford Excursion V10 -2 wheel Drive [gm1934]
by msmel
-
Dec 09, 2005 (10:16 pm)
-
|
|
Replying to: gm1934 (Dec 07, 2005 1:18 pm)
I don't know if the rattle you hear is related to the squeak I used to hear when going over bumps, but if you think it might be, you should consider whether it could be the windshield. I thought it must have been the dashboard but turns out to have been windshield.
|
- #124 of 423
-
Re: 2002 Ford Excursion V10 -2 wheel Drive [msmel]
by gm1934
-
Dec 10, 2005 (5:38 pm)
-
|
|
Replying to: msmel (Dec 09, 2005 10:16 pm)
This is a diesel not a gasoline unit. I'm sure it is in the front it is a rattle not a squeak.
Thanks anyway.
George
|
- #125 of 423
-
Re: Truck won't start. [1bigtruck]
by nodlew
-
Dec 11, 2005 (10:27 am)
-
|
|
Replying to: 1bigtruck (Dec 01, 2005 12:26 pm)
The fuel filter is under the drivers side running board. You will have to release pressure from the fue line. Remove the gas cap to relieve any pressure from the tank. Then open the fuel filter/water separator drain valve by turning it clockwise.
You should place something underneath to catch the little bit of fuel that drains out.
Disconnect the lines and install the new filter.
Hope this helps.
|
- #126 of 423
-
Re: Truck won't start. [nodlew]
by 1bigtruck
-
Dec 12, 2005 (10:58 am)
-
|
|
Replying to: nodlew (Dec 11, 2005 10:27 am)
Thanks for the info. This is a really great site! I just wish that there was a cure for the paint cancer. Even the areas that the dealership repainted under warranty are pealing.
|
- #127 of 423
-
Power door locks dont work
by 1bigtruck
-
Dec 12, 2005 (11:02 am)
-
|
|
Has anyone had this problem and fixed it? Its only the passenger side front and rear. Is there lubrication maintenance that I dont know about or is there a common problem with motor failure. Any tips????
|
- #128 of 423
-
Re: Power door locks dont work [1bigtruck]
by excurs
-
Dec 14, 2005 (9:43 am)
-
|
|
Replying to: 1bigtruck (Dec 12, 2005 11:02 am)
This is a common problem for '00-'03 Excursions and Super Duty trucks. I replaced them on my previous '00 Excursion and am about to do it for another. Email me back and I will send you the instructions when I get them. (Also, you might as well replace all of the doors as it is just a matter of time.) Good luck.
|
- #129 of 423
-
Re: Power door locks dont work [excurs]
by javaman2
-
Dec 14, 2005 (3:15 pm)
-
|
|
Replying to: excurs (Dec 14, 2005 9:43 am)
I just bought a 00' Excursion and have the exact problem with the locks. If you could send me the instruction as well I would greatlly appreciate it.
|
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
SUVs 
