Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Maintenance & Repair Electronic Gremlins: Electrical Problems That Are Driving You Crazy
1085 messages, Last post on Oct 29, 2009 at 11:41 AM
You are in the Maintenance & Repair Forum. Your Host is mr_shiftright
| I had both front axles replaced in Jan 09--since then I have had various electrical problems. First the anti lock brakes light began coming on intermittently--now on continuously. Then the turn signals/emergency flashers would only work intermittently, now not at all. Then two days ago the battery light and emer brake light came on. After driving it home and parking it in the garage it would not start. I took it too a mechanice who replaced the alternator. The battery and parking brake light went out, but the anti lock brakes light is still on and the turn signals still do not work. Any help would be greatly appreciated. | |
|
Replying to: g_lee (Jun 21, 2007 2:17 pm) |
|
|
|
|
Replying to: cdonovan (May 04, 2006 7:20 am)  How did your issue resolve?
|
|
Car sat for 2 yrs with blown head gasket d/t bad water pump. D/T having oil and h2o in oil pan the cams rusted very bad in engine. have together..all torqued to specs. but wont start. I have replaced: plugs, coil boots, coil, temp. ( engine ) sensor,crank sensor, cam sensor, pcv valve, timing chain, timing guides, cam gears, timing chain tensioner, new heads, new cams, new lifters, new rollers, new intake gasket set, new auto shut down relay, fuel pump relay.. Car wont start... any idea's what i need to do to get the car to start.. does the computer need to be flashed ? Timing Chain, cams are 100% in line. Anything would help at this point...  thanks
|
|
|
Replying to: anita3 (Jun 21, 2009 11:06 am) Check for spark. How did you get rid of all of that bad gas? Any rust on the main crank bearings?
|
|
|
Replying to: kiawah (Jun 21, 2009 11:39 am) compression should be good .. is all new and torqued what about the sentry key imobilizer module in the ignition switch ? its a round ring module.. would that have something to do with it ?
|
|
|
ok will re check everything over again.... thank you for your quick response to my question 
|
|
|
Replying to: anita3 (Jun 21, 2009 12:58 pm)
|
|
You are here:
Forums
Maintenance & Repair Electronic Gremlins: Electrical Problems That Are Driving You Crazy
