8642 messages,
Last post on May 20, 2013 at 10:18 PM
You are in the
Subaru Legacy & Outback Forum.
What is this discussion about?
Subaru Legacy, Subaru Outback, Wagon
#7320 of 8642 Re: Shop Manual or Repair Manual [batman47]
by jfl
Nov 26, 2007 (11:06 pm)
I purchased a few sections of the "Service Manual" for the 2000 Legacy and Outback. Back then, it was an eight(?) volume set with a total price about $200 (or more).
I only bought 4 of the 8 volumes.
See if you can find it online at 1stsubaruparts.com. They also accept Subaru bucks you earn from a Subaru credit card. The bucks can be used for parts, service, or towards a new car.
Jim
Nov 27, 2007 (8:55 am)
On another Subaru topic it was mentioned that some Subaru turbo engines suffer from boost "stutter" that cannot be repaired or adjusted away.
Has anyone seen this in the '08 Outback? I am considering an Outback XT Limited, and would not appreciate like turbo stutter, etc. in a nearly $34 K automobile.
#7322 of 8642 Re: '08 turbo chatter [kurtamaxxxguy]
by ateixeira
Nov 27, 2007 (10:53 am)
Honestly, I've never heard anyone complain about that.
The only stutter complaints I've heard were from the clutches on late 90s models.
The WRXs and Legacy GTs and Forester XTs I've driven were all very smooth, in fact I'd argue the turbos are a bit smoother than the normally aspirated engines.
#7323 of 8642 Re: '08 turbo chatter [ateixeira]
by paisan
Nov 27, 2007 (5:55 pm)
There is a very small drop in the hp/torque curve on the turbo models, but it is in no way noticeable except on paper at the dyno shop. I don't have an issue on my unmodified 05 LGT, and none of my customer's unmodified cars either.
-mike
#7324 of 8642 Re: Replacing a cabin filter in 2007 Outback wagon [ic_designer]
by billb8
Nov 28, 2007 (8:45 pm)
Alland, Thanks for the info. I checked out the site but it leaves a bit to be desired. The instructions that come with the filter don't help much either. They just aren't clear enough to give me the confidence to remove parts without breaking them.
Billb8
#7325 of 8642 97 subaru wagon transmission
by bj69s
Nov 29, 2007 (8:04 am)
I have a 97 wagon that is pulling from side to side and the trans don't want to shift into drive it is a automatic its like it don't want to shift up .
Nov 29, 2007 (10:21 am)
Sounds like two or three *dfifferent* problems..
#7327 of 8642 1998 Subaru legacy outback needs help!
by parrett2
Nov 29, 2007 (11:39 am)
I REALLY need someones help. I have a outback that has a lot of problems that noone seems to know how to fix or whatnot......anyways right now my car will not start. when it tries the lights flash on and off.....I am assuming that its the security system. When i bought this car from another person it did not have a manual in it nor did it comes with the black keyless entry box. Does anyone know how i can disable or reset the security so my car will start?
thanks so much.....
#7328 of 8642 Re: 1998 Subaru legacy outback needs help! [parrett2]
by xwesx
Nov 29, 2007 (11:51 am)
If the car has a factory alarm system, there should be a button located on the left side of the car, up under the dash. Pressing it should reset the system. If the car's battery was changed or the battery died, the alarm system will need to be reset. I thought the need for reset was accompanied by honking, flashing lights, etc., but have not had one with an alarm, so I cannot say for sure.
#7329 of 8642 Re: 1998 Subaru legacy outback needs help! [xwesx]
by parrett2
Nov 29, 2007 (12:21 pm)
.....well i went out and looked to see if i can find some sort of button and i cant seem to see it.........although i dont know what im looking for either .....under the hood it says it has a security system so im guessing that it also has an alarm as when the battery is hooked up the lights flash on an off and the people i have mentioned this to says when the alarm system has been activated it will shut down the engine so it wont start........so i have to figure out where to reset that system......I will have another look under the dash as it could be somplace else......there has to be somwhere to reset it right? Gosh if i can get this started im getting me an manual for sure so i can figure out this dang car........thanks a lot for the reply.....