- #155 of 164
-
Re: AWD ABS Light on [jwebb2]
by ray80
-
Mar 02, 2008 (9:06 am)
-
|
|
Replying to: jwebb2 (Mar 01, 2008 2:33 pm)
For the AWD/ABS warning light, either a sensor in wheel bearing/hub assembly is bad, or in quite a few cases, a connection to one of the sensors is corroded or wire is broken. For the noise, is it a metallic sound/grinding or more like groan or moan sound? Also does it change in intensity or tone and happen more at slow speed or get worse at faster speed? Does it change when turning one way or amother?
|
- #156 of 164
-
Re: AWD ABS Light on [ray80]
by jwebb2
-
Mar 02, 2008 (10:57 am)
-
|
|
Replying to: ray80 (Mar 02, 2008 9:06 am)
The noise is more like a groan sound, I know it is not the break pads i just had new ones put on. From what i can remember the noise gets worse at high speeds and i do remember it changing a little as i make turns. Where would the sensor be located and/or the connection that i should probly check first.
Thanks
|
- #157 of 164
-
Re: AWD ABS Light on [jwebb2]
by ray80
-
Mar 03, 2008 (4:26 am)
-
|
|
Replying to: jwebb2 (Mar 02, 2008 10:57 am)
The groan/moan with the AWD version is usually either an indication the versa-trak fluid needs to be changed, or quite likely it is low on fluid due to a leak. It may be real noticeable on a fairly high speed turn (like an tight turn on exit ramp). I had around 75k miles on ours when I had a leak, so I had them do a fluid change as well as correcting the leaky seal. Each wheel bearing/hub assembly has a wire for the speed sensor that could be checked ( I think a GM dealer can check codes to point to a particular wheel ).
|
- #158 of 164
-
Re: Where is everyone from? [pwb1]
by purplepuppy
-
Mar 03, 2008 (8:34 am)
-
|
|
Replying to: pwb1 (Feb 25, 2008 1:15 pm)
Found the recalls on "Aztekfanclub.com" which is down at the momment I expect the moderator is trying to fix the problem but you might want to try there tomorrow or the next day. I usually check daily to see what is going on but am camping Tue, Wed, Thur. Anyway there is lots and lots of info there and you can just put "recall" in the search slot and it will bring all the infor up.
|
- #159 of 164
-
Re: Where is everyone from? [bruckmann]
by purplepuppy
-
Mar 03, 2008 (8:38 am)
-
|
|
Replying to: bruckmann (Feb 27, 2008 7:19 am)
Had my front Brakes "deglazed" and that worked great, Cost was $48.00. Am going to have my back ones "deglazed" next month
Chere, Crystal, Bear, Heshe & Purplepuppy (The Royal Aztek )
|
- #160 of 164
-
Re: Where is everyone from? [bruckmann]
by beachbum4
-
Apr 09, 2008 (2:18 pm)
-
|
|
Replying to: bruckmann (Feb 27, 2008 7:19 am)
I have seen a few messages relating to how noisy our Azteks are.
Well you might want to get your rear hub bearings checked out.
I had mine replaces when I got the car in 2005, and then we had them replaces last April and they started up again at they end of the year and need to be replaced again. Can anyone say Lemon!!!
|
- #161 of 164
-
Re: 2003 Aztek won't start [rme300]
by beachbum4
-
Apr 09, 2008 (2:26 pm)
-
|
|
Replying to: rme300 (Jan 27, 2008 5:42 am)
There is a part under the drivers door that has to do with the gas. My Aztek failed to start but luckily we were at the shop. My mechanic pushed on something like I mentioned under the drivers door area and it started right up. Check it out.
Good luck
|
- #162 of 164
-
Have they brought them back??
by bruckmann
-
Apr 13, 2008 (11:30 am)
-
|
|
I was searching the internet and found 2 websites giving info on 2008 Aztecs...is this a mistake or is this true?
|
- #163 of 164
-
i dont have instrotion to tent
by juanchoo1
-
Apr 13, 2008 (1:00 pm)
-
|
|
i need the how to.for the tent.please i need it ill like to take my son out to canmp out
|
- #164 of 164
-
Re: Have they brought them back?? [bruckmann]
by steve_ HOST
-
Apr 13, 2008 (4:30 pm)
-
|
|
Replying to: bruckmann (Apr 13, 2008 11:30 am)
Not true according to the source.
Pontiac.com
Some websites stick extraneous info in their meta data or site headers or in seemingly "real" pages to try to get more search engine hits, hoping that you'll click an ad on their site..
|