Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Hatchbacks Volkswagen Beetle Volkswagen Beetle Maintenance and Repair
1064 messages, Last post on Nov 03, 2009 at 5:45 PM
You are in the Volkswagen Beetle Forum. Your Host is pf_flyer
|
Replying to: fphilli1 (Nov 01, 2009 7:23 am) The offhand note that it "drives fine" means nothing... lets hope you have not fried the catalytic converter or something else expensive. Use a Vag-Com to troublesohoot.
|
|
|
Replying to: bpeebles (Nov 01, 2009 4:46 pm)  I did not drive the car but a few feet when it went into the limp home mode. After it warmed up it drove with no notable degridation or performance issues. I have read all the horror stories linked to the check enfine light on. I was thinking that the map window with colder air runs the car too lean and as it warms up it gets back into a workable tabel to run. Does that make sense?
|
|
|
Replying to: fphilli1 (Nov 02, 2009 11:38 am) Most commont reason for P0171 is a cracked/broken or otherwise defective hose allowing air to 'leak' into the intake manifold AFTER the MAF sesor. (Between MAF and engine) Another possibility is the MAF itself not measuring the airflow accurately. If you have every one of those "oiled guaze" air-filters... (like K&N) then your MAF is likely destroyed. 3rd possibility is the foreward O2 sensor measurng the lean condition improperly. I would approach this problem in the order I have suggesed above. 1)Look for air-leak (replace all questionable rubber hoses 2) Pull electrical connector off MAF and drive like that (forces "limp" mode safely) 3)If that helps, consider replacing MAF 4)Consider replacing foreward O2 sensor
|
|
|
Replying to: bpeebles (Nov 02, 2009 6:12 pm)  Thank you so much for the information. I forgot to tell you I put some fuel injector cleaner in the fuel tank when it was at 1/4 tank and have not added any fuel since then. Would that make any difference? I let the car sit for two days and started it this morning with no issues after I let the blue cooling light go off. I did not wait for the cooling light to go off the other day when I had the limp home mode issue. I know it says to let the engine warm up until the blue coolant light goes off, how important is that???? Thanks again for your help....
|
|
|
Replying to: fphilli1 (Nov 03, 2009 5:31 am) VW says to DRIVE GENTLY (accellerate slowly) until the blue coolant light turns off... this is the same as all other vehicles ever made. One should always take it easy on a cold engine. Driving gently is the very quickest way to warm up engine without excessive wear-n-tear. You do understand that the only reason that the NB (New Beetle) has the blue light is because it does not have a formal temparature-guage on the dash to tell you when engine is cold. (VW tried to keep true to the Original Beetle which did not even have antifreeze!!) On the other hand.... letting a cold engine IDLE until it is warmed up is not good for it. An engine takes much longer to warm up when idling. This allows condensation and other nasties to form in the crankcase. |
|
You are here:
Forums
Hatchbacks Volkswagen Beetle Volkswagen Beetle Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Volkswagen New Beetle
Browse by Board
Browse by Topic
Today's Chats
