You are here:
Forums
Pickups
Ford Ranger
Ford Ranger Maintenance and Repair

2825 messages, Last post on Nov 27, 2009 at 6:47 PM
You are in the Ford Ranger Forum. Your Host is kcram
|
|
|---|---|
|
I'm planning on looking at a 1990 Ford Ranger 2wd 5spd std. Regular Cab pickup. I was wondering if this truck would have a 2.0 or a 2.3 4cyl engine. Are there any major points to be checking besides the obvious on these trucks? Thanks in Advance -Ryan |
|
|
Gentlemen, If you would be so kind as tyo check this inquiry in our new Edmunds Answers section: What is the correct rear end for a 1999 Ford Ranger 4WD Supercab? kcram - Pickups Host |
|
| i have a 1992 ford ranger 4x4 2.3L 4 cyl, and i am almost positive that the TPS is bad so i went out and bought a new one but it is located behind the air intake sytstem and i can not seem to figure out how to get at it without removing the intake, does anyone have any insight on how to change the TPS? | |
My 2000 Ford Ranger is stuck in 4 wheel drive low. Is there a fuse a need to be looking at ?
|
|
| I have a 98 3.0 Ranger 2wd auto that needs a y pipe. Can I use one from a 2004 3.0 manual?? It would save me big bucks over a new one. Thanks | |
|
My Ranger XLT 4.0 L washer fluid comes out with low pressure. I put as new pump on today (mounted in the bottom of the fluid reservoir on the firewall side). This made no improvement. It squirts out about 3" up on the window. Any suggestions? No, its not frozen or clogged. Can the switch be dirty? Thks Dave
|
|
| I have 1999 4x4 Ford Ranger with newer (35,000 miles) 3.0 V6 motor. DTC P1309 showing up. Truck runs like a top. I did notice that temp gauge moves up and down slightly during driving since engine light tuned on. Needle has always gone just beyond the "C" on gauge. Does heat sensor need to be replaced? What could it be? | |
|
Replying to: bruce24 (May 21, 2006 12:01 pm) |
|
The Wipers, Speedometer and dome light don't work in my 2001 Ford Ranger. I replaced the wiper switch and checked the fuses to no avail. The problem started when my dome light was staying on and I pulled the bulb so not to run the battery down. Anyone have any fixes? Thanks
|
|
|
Replying to: jburdine (Jan 11, 2008 1:22 pm) Some people say a heavy dose of spray WD40 or elecrical cleaner from outside the door, thru the hole under the handle, can clean the switch enough to get it working again. This should have nothing to do with the wipers or speedometer. Is your ABS light on? Speedometer and ABS sensor can sometimes be related. The ABS sensor in the rear differential may be failed, or just dirty with metal grit. I would think there would be ABS codes set, if it is failed. Pulling the ABS codes is different, I think, from pulling the 'regular' 'check engine codes'. Overall, I don't have a good recommendation on the speedo or wiper problems. |
|
You are here:
Forums
Pickups
Ford Ranger
Ford Ranger Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Ford Ranger



Browse by Board
Browse by Topic
Today's Chats