Ask the Car People.SM


Ford Ranger Maintenance and Repair

2986 messages,  Last post on May 15, 2013 at 6:47 AM

You are in the Ford Ranger Forum.

What is this discussion about? Ford Ranger, Truck

Messages Page 192 of 300

#1904 of 2986 Re: 1998 (Auto, V6) Ranger transmission problem. [freyt] by blogger

Jan 03, 2006 (1:26 pm)

Replying to: freyt (Jan 03, 2006 8:27 am)
My 2000 Ranger went out 3 weeks ago with only 34,000. My non-Ford mechanic said there were at least 5 service bulletins out on it. Poorly designed and it seems to happen fairly regularly at 40,000. We put in a non-factory transmission (automatic) because Ford apparently isn't fixing the design flaws so you will end up with the same problem a few years down the road! $3200 a week before Xmas-merry Christmas. My last Ford.

#1905 of 2986 Custom exhaust by rangermang

Jan 05, 2006 (9:42 pm)

I have a 99 ranger xlt extended cab, 2wd, with the 4cyl 5spd. I was wondering if anyone had any suggestions as to what custom exhaust i should use, in regards to easy installation and quality. I have looked at Gibson's Dual split back exhaust, so far that seems to be the best. suggestions would be great thanks!

#1906 of 2986 Re: All the problems I'm hearing with Rangers, Hmmm [jefferyg] by cniemann

Jan 06, 2006 (9:38 pm)

Replying to: jefferyg (Dec 24, 2005 12:56 pm)
No Dodge means " over priced for what you get " or it's what you do when you see one in the mirror so that they do not hit you.

#1907 of 2986 96 Ranger Transmission Swap by markyasu

Jan 07, 2006 (2:31 pm)

I have a 96 ranger 3.0 auto trans. The trans is broke, I want to install another automatic trans that came out of a 96 ranger 4.0. Will it fit? Help. Mark

#1908 of 2986 2003 Ranger Door Autolock ? by tnhacker

Jan 07, 2006 (3:13 pm)

Can the doors on a 2003 Ranger SC Edge be programmed to autolock? If so, what is the procedure.
Thanks

#1909 of 2986 Horn problem by ngd

Jan 07, 2006 (7:52 pm)

Does anybody know where the horn is on a 94 ranger?

#1910 of 2986 Range Trailer Wire Problem by byrne4

Jan 08, 2006 (4:40 pm)

I have a 1999 Mazda PU 4x4 with the OEM wire harness and a 4 prong flat trailer plug. I hooked up new lights. Everthing works fine, but when I brake, all the lights go off on the trailer. The truck lights are not effected and nothing blows. My ground is good, bulbs ok, fuses ok. I've even tapped into the truck's wires, by-passing the OEM pigtail and still the same problem. Is this a bad brake switch? What is it that I am missing?
Thanks

#1911 of 2986 Re: Noise from my power steering [redsoxfan5] by cdduv

Jan 09, 2006 (3:14 pm)

Replying to: redsoxfan5 (Dec 23, 2005 3:13 am)
I have a noise coming from my pump as well. It began when i dropped a new engine in my truck a few months back. Still have the whine, checked fluid level, replaced belt, etc. I don't know what it is.

#1912 of 2986 Re: 96 Ranger Transmission Swap [markyasu] by jefferyg

Jan 09, 2006 (10:23 pm)

Replying to: markyasu (Jan 07, 2006 2:31 pm)
To my knowledge they are exactly the same, but I would check it out further.

#1913 of 2986 99 ranger cuts out around 50mph whats up by cowgirl3

Jan 10, 2006 (8:40 am)

I have a 99 Ranger off road package 143000 .Started missing around 45-50 miles per hour. Did this mostly under load. replace plugs wires ,fuel filter,belt,And the emissions value. Still is doing it . does anyone know what this could be . Mechanics are charging me to death. Even had the injectors cleaned. Help!!!!

Messages Page 192 of 300

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement