- #674 of 902
-
Re: Changing Dome or Reading Lights [jt8]
by rsht
-
Jan 23, 2007 (5:17 am)
-
|
|
Replying to: jt8 (Jan 12, 2007 9:45 am)
For the front set of lights, use a small flat/thin screw driver to pry the clear lens (from where your press to turn-ON/OFF the light) off (EX & LX are about the same method). Pretty much the same for the rear Map/Reading lights. For the Cargo area, try to pry from the side of the lens. Good luck!
|
- #675 of 902
-
Back-up lights Wiring on 2007 Odyssey
by rarefruit
-
Jan 30, 2007 (10:14 am)
-
|
I have a 2007 LX Honda Odyssey. I want to add a back-up camera and display.
Where and how do I connect the camera wires to the back-up lights system?
|
- #677 of 902
-
RE : Back seat dvd system
by jt8
-
Feb 06, 2007 (2:20 pm)
-
|
|
http://www.allwired.com/vizualogic/a2000-new.htm - check this out
|
- #678 of 902
-
Towing itch on Ody 07
by trmc
-
Mar 07, 2007 (11:28 pm)
-
|
Has anyone installed an aftermarket (what brand) towing itch on a 07? Is it worth getting a Honda one versus aftermarket? What is the max towing weight without ATF & PS cooler without damage to the two systems?
Thanks for any input.
|
- #679 of 902
-
Re: Towing itch on Ody 07 [trmc]
by jmoose
-
Mar 08, 2007 (5:31 pm)
-
|
|
Replying to: trmc (Mar 07, 2007 11:28 pm)
I haven't installed one on an Odyssey, but I installed a Hidden Hitch (purchased on the internet) for my 01 Outback and it was very easy to install, and MUCH cheaper than the dealer would charge. The aftermarket hitch supports the towing capacity of the vehicle (3500 lbs in the case of the Odyssey, according to the marketing literature). I recall that installation on the Odyssey requires some temporary lowering of part of the exhaust system to get the hitch bolted on.
|
- #680 of 902
-
Re: Towing itch on Ody 07 [jmoose]
by trmc
-
Mar 10, 2007 (8:31 pm)
-
|
|
Replying to: jmoose (Mar 08, 2007 5:31 pm)
Thanks for the info.
|
- #681 of 902
-
Re: Towing itch on Ody 07 [trmc]
by duper
-
Mar 15, 2007 (9:01 am)
-
|
|
Replying to: trmc (Mar 10, 2007 8:31 pm)
I installed the Hidden Hitch on the '06 and didn't have to remove/lower the exhaust at all. It went in easy and took about 20-30 min.
|
- #682 of 902
-
Re: Towing itch on Ody 07 [trmc]
by jwb18t
-
Mar 18, 2007 (3:13 pm)
-
|
|
Replying to: trmc (Mar 07, 2007 11:28 pm)
A friend and I installed a Reese Hitch on my 07. Only using my hitch for a bike rack...So no wiring. Had to lower the exhaust although it was easier than it sounds ...basically a hangar with a rubber sound mount had to be unhooked to let exhaust hang as we bolted the hitch into the pre drilled holes...then re hooked the exhaust. Took about 15 mins. Got my Hitch at USA-Trailer-Hitch.com.
|
- #683 of 902
-
Electric brake controller wiring for 2007 Odyssey
by buchansn
-
Mar 28, 2007 (4:08 pm)
-
|
I have a new 07 Odyssey with factory tow package, which only has a four wire connector. I need to tow a camper that has a seven pin round connector for electric brakes. Does anyone have any info or experience on installing a brake controller and how to convert the connector to a 7 pin round connector?
Thank you,
Steve
|