Sign In Join 



Chevy S10/GMC S15-Sonoma: Problems & Solutions - READ ONLY

2018 messages,  Last post on Oct 17, 2006 at 8:12 PM

You are in the Chevrolet S-10 & GMC S15 Sonoma Forum. Your Host is kcram

What is this discussion about? Chevrolet S-10, GMC Sonoma, GMC S-15, Truck


Messages Page 202 of 202
1
...
196
197
198
199
200
201
202
Prev
Next
Last
Go To Msg #
Search This Discussion

#2011 of 2018
Re: Fuel Filter [dkurrle] by the_big_al
Jun 27, 2008 (3:16 pm)

Replying to: dkurrle (Oct 16, 2006 7:22 pm)

Fuel Filters are very simple to change. Changing the filter will probably eliminate a suspect in a rough idle, but may not fix the rough idle. The filter is under the driver's side, next to the frame rail on the inside. You will need some shop rags, a pair of pliers, an adjustable crescent wrench, or a wrench set (I can't remember the exact size) and a plan to bleed off the fuel pressure, unless of course you enjoy spraying your self with fuel.
 
Disconnect the battery and relieve the fuel pressure. Under the hood there is a pressure releif valve (it's a schrader valve, similar to a valve stem on a tire). You can get a kit at parts store that will capture the fluid or you can use the shop rags and hold them over the valve while you depress the pin. Honestly, I would get the kit. After my last experience changing my filter I wouldn't go any other way.
 
Once you have relieved the fuel pressure, crawl under the truck and change the filter by loosening the nut on the tank side and with the pliers pinching the release tabs on the the motor side of the filter and remove the filter. Have a couple of shop rags and or a small pan to catch the residual fluid that will drain out of the lines.
 
Install the new filter and make sure your connections are tight, then make sure all the gas is cleaned up from both under the vehicle and under the hood (if needed spray degreaser and hose off. You don't want gas puddled somewhere in the engine bay.) Make sure your pressure relief kit is removed and the cap covering the relief valve replaced. Reconnect the battery and turn on the key. Let the pump run (the whine you hear when you first turn the key) till it shuts off to build up a little bit pressure then crank the motor to start the truck. The truck will take longer to start than normal as you have emptied the gas lines and so it will take a few cranks to get the truck started. But once the truck is started, make sure there are no leaks in the fuel system. Don't stick your head under the truck in case the you accidently didn't tighten something properly and the minute you stick your head under there it decides to come apart. Just look without sticking your head under the vehicle.
 
That's all there is to changing a fuel filter. Pretty simple and should only take about 10-15 minutes. Unless you are like me and didn't relieve the fuel pressure so that the minute you release the plastic tab fuel sprays backwards into your face, down your neck, up your nose, down your ears, thankfully not in the eyes. Lesson learned Doh. Anyway, I had done it before without relieving the pressure with out such incident but such was not the case the second time... never again !...
#2012 of 2018
dash and doom lights problem by jmedley
Oct 17, 2006 (6:10 am)
Hi, The dash lights, including the radio/CD player, do not come on when I start the truck (2000 GMC Sonoma) in the dark morning. They do seem to work when I start the truck during daylight. The doom light will work, but only for a few seconds then it start going on and off. Have checked all fuses and they seem fine. Tried starting this morning with a flashlight on the light sensor on the dash, but it didn't help. Any thoughts? Thanks much, Jim
#2013 of 2018
turn signal/multifunction switch by carrollsue
Oct 17, 2006 (10:48 am)
This is a general question. I bought a 1993 S-10 just to have a small truck for getting things done around the house. My turn signal/multifunction switch which works for the mist, turning signal and high/low bream, but does not work for the wipers. I called a Chevy dealer, close by, and they could not find a turn signal/multifunction switch in their parts book, all they could find was the turn signal only. Need a part number if anyone has it?
#2014 of 2018
99 S10 2.2 4cyl. man. by bakesale
Oct 17, 2006 (11:58 am)
just picked up this truck a month ago and this thing doesn't accelerate very well at all, even up the smallest of inclines. the motor also 'drops out' at 15mph in 1st, 20-25mph in 2nd, 30-35mph in 3rd, which takes downshifting in an emergency (or uphill, which is a must in this city) out of the question. i've grown pretty tired of impeding traffic and would love to know if this is a known issue, or if there is anything i can do to make this thing work normally. is this an air, fuel, exhaust, trans, or ECU problem? any help would be much appreciated. thanks.
#2015 of 2018
Re: 99 S10 2.2 4cyl. man. [bakesale] by hoodlatch
Oct 17, 2006 (5:20 pm)

Replying to: bakesale (Oct 17, 2006 11:58 am)

If it was cutting out or bucking as you accelerate I would guess plug wires or coil. If it ran ok but was like pulling an anchor I would guess catalytic converter. Has it had a tune up lately like plugs and clean air filter. I had a similar problem one time in the past but not as bad. Finally found a cracked vacuum hose fitting to be the culprit.
#2016 of 2018
Re: transmission trouble [thebigal] by marcb2
Oct 17, 2006 (5:44 pm)

Replying to: the_big_al (Jun 27, 2008 3:16 pm)

Well, as it turns out, the mechanic told me, to the tune of $2300 it was the tranny and I'd be surprised if the truck is worth that much on trade in, considering it had 158,4?? miles on it. Sooooo, needless to say, I suppose its trade in time on this truck for a newer one. For anyone considering an S-10, with the exception of the tranny now, the truck really has not been a bad vehicle for me. In my opinion, it was worth the 13 G's I paid for it slighty used. It has lasted me a good 6 years and 118,000 miles. Definatly a recommendation from me and have started looking for another S-10.
#2017 of 2018
Re: 99 S10 2.2 4cyl. man. [hoodlatch] by bakesale
Oct 17, 2006 (6:46 pm)

Replying to: hoodlatch (Oct 17, 2006 5:20 pm)

just replaced plugs, wires, air filter today. and which coil do you mean? will experiment w/ cat. tomorrow and check vacuum hoses, because now that i think about it, there's also a hissing when i hit the pedal. hmmmm....
#2018 of 2018
Important news! by kcram HOST
Oct 17, 2006 (8:12 pm)

 
As you may have noticed, we are reorganizing the Forums to allow better focus and easier searching when you have a particular problem or comment about any given vehicle. Many of the large generic discussions (like this one) will be closed to new posts, and we ask that you continue in the more focused discussions that you can find at the Group page for the vehicle, linked below. This discussion will not be deleted, so you can still search for information in it.
 
We recognize this is going to take some getting used to (for the hosts too!), so please bear with us. If you have any questions, you can always email the host of any discussion - the link is at the top of each page to the host who oversees that discussion.
 
If you don't see a discussion in the group appropriate to your question or comment, start a new one, or send me an email, and I'll point you in the right direction!
 
Thanks!
kcram - Pickups Host
 
Chevy S10/GMC S15 and Sonoma Group

Messages Page 202 of 202
1
...
196
197
198
199
200
201
202
Prev
Next
Last
Go To Msg #
Search This Discussion

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement